What to Do When the Car Air Conditioner Emits Odors in Heating Mode?

How to Replace a Car Battery Without Power Interruption?

Connect the old and new batteries in parallel before removing the old battery, disconnect its wiring connected to the car, then connect the corresponding wiring to the new battery, install the new battery, and remove the jumper cables. Below is relevant information about car batteries: 1. Battery: A battery, also known as a storage battery, is a device that converts chemical energy into electrical energy. Car batteries typically refer to lead-acid batteries, which are mainly made of lead and its oxides with sulfuric acid solution as the electrolyte. The normal service life of a car battery varies from 1 to 8 years, largely depending on the vehicle's usage conditions. 2. Battery Replacement: If the battery is dead, it is recommended to first measure the battery voltage. If using a multimeter, measure the battery voltage during engine cranking. You can initially use a high-frequency discharge machine or battery tester for measurement. Under a load current of no less than 110 amps, the minimum voltage should not be lower than 9.6 volts and should remain stable for 5 seconds. If the voltage is below 9.6 volts but remains stable for 5 seconds, it indicates over-discharge, and the battery should be recharged promptly. If the voltage is below 9.6 volts and cannot remain stable within 5 seconds, rapidly dropping to 0 volts or close to 0 volts, it suggests a possible battery fault that may require replacement.

6

5

Share

How to Turn On the Dash Cam in Lynk & Co 03?

The dash cam in Lynk & Co 03 automatically turns on after the vehicle is started. Below is relevant information about the Lynk & Co 03: 1. Introduction: The Lynk & Co 03 is the first sedan product under the Lynk & Co brand and the first sedan built on the CMA basic modular architecture. It is a premium brand jointly established by Geely Holding Group, Geely Auto Group, and Volvo Cars. 2. Exterior: The 'Wind Control Design' of Lynk & Co 03 integrates the family-style 'Urban Contrast Aesthetics' design concept with aerodynamic design, largely maintaining the Lynk & Co family design style. The front features split-type headlights paired with a horizontal front grille and lower trim. The side profile retains the classic three-box sedan shape with smooth C-pillar lines, while the rear adopts 'L'-shaped taillights with a black decorative panel integrating reflectors below.

20

2

Share

What Causes the Seat Belt Retractor to Make Noise?

Friction may cause the seat belt buckle to make noise, possibly due to rubbing or contact with the driver's seat. Below are some solutions related to seat belt retractor noise: 1. Friction issue: If the seat belt buckle makes noise, it might be caused by friction or contact with the driver's seat. The solution is to prevent the buckle from touching the seat. 2. Screw issue: If the passenger-side seat belt buckle's shock absorber is too tight, the screws underneath may not be tightened or secured properly, or the seat may be loose. Simply tightening them can resolve the issue. 3. Gap issue: Since the pin shaft is connected to the bracket and the base with some clearance, driving on bumpy roads may cause the pin shaft to hit and produce noise. Additionally, there might be a gap between the flat washer at the pin shaft and the limit base, leading to noise from the washer hitting the base while driving.

3

Share

What licenses can a C1 be upgraded to?

A C1 driver's license can be directly upgraded to the following licenses after meeting the corresponding requirements: A3 city bus, B1 medium-sized passenger vehicle, B2 large truck, D ordinary three-wheeled motorcycle, E ordinary two-wheeled motorcycle, F light motorcycle, M wheeled self-propelled machinery vehicle, N trolleybus, P tram. In simple terms, a C1 driver's license cannot be directly upgraded to an A2 driver's license. You need to upgrade to a B license first, and then upgrade to an A2 driver's license. Requirements for upgrading a C1 driver's license to a B2 driver's license: Age between 20 and 60 years old; height not less than 155cm; holding a C1 driver's license for at least 1 year; no record of 12 penalty points in the current scoring cycle and the most recent scoring cycle before application; visual acuity must meet the standard of 5.0 or above on the logarithmic visual acuity chart; no record of drunk driving or causing a fatal traffic accident with primary responsibility while holding a C1 driver's license.

13

3

Share

Why Was the Wuling New Truck Discontinued?

Wuling New Truck has not been discontinued. Here is more information about the Wuling New Truck: 1. The Wuling Rongguang New Truck is a micro-truck, equipped with a manual transmission, and comes in two displacement options: 1.5L and 1.8L. 2. In terms of handling: Due to its electric power steering, the steering is very light, making it easy to drive and simple to control. Acceleration, deceleration, and braking are all very responsive. 3. Fuel consumption: The fuel consumption ranges from 7.3L to 8.4L per 100 kilometers. 4. Comfort: The vehicle has good shock absorption and excellent cushioning, resulting in minimal bumpiness. The ride inside the cabin is comfortable, and the knitted fabric seats are also pleasant.

14

5

Share

What Type of Pump is a Car Power Steering Pump?

Car power steering pumps are part of mechanical hydraulic power steering systems, electro-hydraulic power steering systems, or electric power steering systems. The power steering pump can reduce the driver's effort in turning the steering wheel and also plays a role in the safety and fuel efficiency of the vehicle. Mechanical Hydraulic Power Steering System: This power steering system is generally composed of components such as a hydraulic pump, oil pipes, pressure and flow control valve body, V-type drive belt, and oil reservoir. Electro-Hydraulic Power Steering System: The main components of the electro-hydraulic power steering system include an oil reservoir, power steering control unit, electric pump, steering gear, and power steering sensor, with the power steering control unit and electric pump forming an integrated structure. Its working principle is that the electro-hydraulic power steering system overcomes the shortcomings of traditional hydraulic power steering systems. The hydraulic pump it uses is no longer directly driven by the engine belt but instead employs an electric pump, with all its operating states calculated by the electronic control unit based on signals such as vehicle speed and steering angle to achieve the most optimal state. Electric Power Steering System (EPS): The full English name of the electric power steering system is Electronic Power Steering, abbreviated as EPS. It utilizes the power generated by an electric motor to assist the driver in steering. Main working principle: When the car is turning, the torque (steering) sensor "feels" the steering wheel's torque and intended direction of rotation. These signals are sent via the data bus to the electronic control unit, which then issues action commands to the motor controller based on data signals such as the transmitted torque and intended direction. The motor then outputs the corresponding amount of torque as needed, thereby providing power steering assistance.

13

3

Share

What to Do When the Car Air Conditioner Emits Odors in Heating Mode?

How to Replace a Car Battery Without Power Interruption?

How to Turn On the Dash Cam in Lynk & Co 03?

What Causes the Seat Belt Retractor to Make Noise?

What licenses can a C1 be upgraded to?

Why Was the Wuling New Truck Discontinued?

What Type of Pump is a Car Power Steering Pump?

What brand is yadea?

Should the Mustang use 92 or 95 octane gasoline?

What vehicles are referred to as tractors in the permitted driving models on the driver's license?

What is the Difference Between the External and Internal Circulation of a Car's Air Conditioning System?