What to do when the battery of Hongqi H5 is too low?

3 Answers
DelEmiliano
07/25/25 1:28am
When the battery of Hongqi H5 is too low, it needs to be charged. The charging methods are as follows: The charging current for constant current charging is selected based on the battery's capacity. Constant current charging is carried out in two stages. In the first stage, the charging current is one-tenth of the battery's rated capacity, while in the second stage, it is one-twentieth of the battery's rated capacity. The Hongqi H5 is a model under the Hongqi brand, with body dimensions of 4945mm in length, 1845mm in width, and 1470mm in height, and a wheelbase of 2875mm. In terms of appearance, the Hongqi H5 largely follows the design of the Hongqi B-Concept concept car, featuring an inverted trapezoidal front grille connected to the headlights, with vertical chrome decorative strips embedded inside.
Was this review help?
3
0
Share
VanAdriel
08/11/25 11:20am
My Hongqi H5 also experienced low battery power, which was quite annoying. First, check the battery lifespan—if it's been used for over three years, it might be aging. I personally measured the voltage: if it's below 12 volts, charge it immediately, like using a home charger overnight. If that doesn’t work, check if the alternator belt is loose or if there’s a battery drain, such as forgetting to turn off interior lights or the dashcam. Remember to visit a professional shop to test for parasitic drain with specialized tools to prevent small issues from escalating. For prevention, I avoid frequent short trips, turn off the AC and audio to save power, and installed a battery monitor for real-time alerts. With these steps, the problem was basically resolved.
Was this review help?
14
5
Share
Expand All
DeLucy
09/26/25 8:41am
Don't panic if your Hongqi H5 battery dies. When I first bought the car, I was careless and left the music on after parking, resulting in a dead battery the next day. Solutions are simple: If there's another vehicle nearby, use jumper cables to connect to its battery and start the engine; or call for roadside assistance, which can now be easily booked via mobile apps. Afterwards, have your battery's health checked—dealerships offer free inspections. If you need a new battery, expect to pay a few hundred yuan, but don't opt for cheap, incompatible models. Adjust your habits: Turn off all electronics after shutting down the engine, and check before long trips for peace of mind and safety.
Was this review help?
16
4
Share
Expand All
More Forum Discussions

What type of vehicle is the Land Cruiser?

Land Cruiser is a flagship large-sized SUV, a full-size off-road vehicle. Its prototype is the Toyota Jeep BJ. The vehicle's dimensions are 5170mm in length, 1975mm in width, and 1930mm in height, with a wheelbase of 2850mm. It features a double-wishbone independent front suspension and a four-link non-independent rear suspension. The domestic version of the Land Cruiser is equipped with two engines: a 4.0-liter naturally aspirated engine and a 4.6-liter naturally aspirated engine. While inheriting the original design DNA, its exterior evolves towards a fresh, advanced style of the new era. This is a hardcore off-road vehicle with four-wheel drive and four-wheel disc brakes.
12
3
Share

What are the Nissan car brands?

Nissan car brands include Subaru, Mitsubishi, Honda, Toyota, Nissan, Mazda, Lexus, Acura, Infiniti, etc. Nissan is a company whose business covers automobile manufacturing, shipbuilding and aerospace technology. It was founded in 1933. Automobile products are divided into practical types (i.e. trucks, minivans and four-wheel drive vehicles), luxury cars and ordinary cars. Mazda is a Japanese automobile manufacturer founded in 1920 and headquartered in Hiroshima, Japan. Mazda has two models: a 5-door hatchback and a 4-door sedan. The length, width and height of the car are 4515mm, 1745mm and 1465mm respectively, and the wheelbase is 2640mm.
19
3
Share

What Are the Causes of Steering Wheel Vibration in Cars?

There are several reasons for steering wheel vibration in cars: 1. It may be caused by tire deformation or issues in the vehicle's drivetrain; 2. Worn or loose ball joints in the tie rods, or detachment of rubber bushings at the joints, etc. Solutions include: 1. Inspect the static balance of the wheels and check for excessive tire deformation—replace if deformed; 2. Have a professional repair shop inspect and replace any damaged components. The steering wheel is typically connected to the steering shaft via splines, and its function is to convert the force applied by the driver on the steering wheel's edge into torque, which is then transmitted to the steering shaft. Using a larger diameter steering wheel can reduce the hand force required from the driver during steering.
7
4
Share

How to Use Car Turn Signals?

Method for using car turn signals: If turning left or changing lanes to the left, the left turn signal should be activated in advance; if turning right or changing lanes to the right, the right turn signal should be activated in advance. Turn signals are an important lighting system in a car and should be used when turning or changing lanes to alert drivers behind. Failure to activate turn signals before turning or changing lanes can easily lead to accidents. When driving, it is crucial to use turn signals before changing lanes, as this signals drivers in adjacent lanes to slow down and yield. Learning to use turn signals correctly helps improve driving safety. If a vehicle's turn signals malfunction, they should be repaired promptly to avoid compromising driving safety.
4
0
Share

What are the symptoms of a bad steering linkage ball joint?

Symptoms of a bad steering linkage ball joint include: 1. A clicking sound when turning; 2. Feeling a large gap in the steering wheel and unstable direction while driving; 3. In mild cases, it can cause unstable steering, while in severe cases, it can lead to sudden wheel misalignment or detachment, especially at high speeds. The steering linkage is a crucial component in a car's steering mechanism, directly affecting the vehicle's handling stability, driving safety, and tire lifespan. The ball joint of the linkage is a rod with a ball joint housing, where the ball joint of the steering spindle is placed inside the housing. The ball joint is hinged to the edge of the shaft hole of the housing via a ball joint seat at its front end. The needle roller between the ball joint seat and the steering spindle is embedded in the groove of the seat's inner hole surface, which helps reduce ball joint wear and improves the spindle's tensile resistance.
11
2
Share

What Causes the Smell of Gasoline When Starting a Car?

When starting a car, the smell of gasoline is caused by incomplete combustion of fuel. When the car is started while cold, the vehicle's computer will appropriately increase the fuel injection volume based on the intake air temperature and coolant temperature signals. At this time, the engine has not yet reached its normal operating temperature, resulting in poor combustion efficiency. This causes some fuel to be expelled without being fully burned, leading to a strong gasoline smell during cold starts. This situation is particularly common in winter. The normal operating temperature of an engine is between 80 to 90 degrees Celsius. Once the engine reaches this temperature, the vehicle's computer will reduce the fuel injection volume accordingly. Under normal operating temperatures, the fuel will be fully combusted, and the gasoline smell will disappear.
3
1
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.