What to Do When a Small Nail Punctures Your Car Tire?

Does the alternating high and low beam lights finally return to the low beam?

Alternating high and low beam lights will eventually return to the low beam. Below is the relevant introduction about the low beam after alternating high and low beam lights: 1. Alternating between high and low beam lights, commonly known as flashing lights, can be achieved by pulling the light control lever on the lower left side of the steering wheel upward once, which will switch between high and low beams once, i.e., perform one flash. Whether the lights are in high or low beam mode, there is no need to switch back to the low beam position; just pull once. 2. During night driving, high beams should be used. When encountering oncoming vehicles, pedestrians, or other factors that may be affected by high beams at night, low beams should be used. When overtaking at night, alternate between high and low beams to notify the vehicle ahead of the intention to overtake.

17

5

Share

What is the BYD One-Key Start Failure Case?

The steering wheel will make a "click" sound and lock. The following is an introduction about BYD: 1. Introduction: BYD Company Limited is headquartered at BYD Road, Pingshan New District, Longgang, Shenzhen City, Guangdong Province. 2. Industrial Strength: As a leader in the electric vehicle field and a global leader in the rechargeable battery industry, BYD has quickly mastered the key to the success of electric vehicles - the core technology of power batteries. It already possesses the technology and conditions for large-scale commercialization, enabling the development of more energy-efficient and environmentally friendly electric vehicle products, achieving performance improvements and widespread application.

14

3

Share

Can a Full-Size Spare Tire Be Used as a Regular Tire?

For a full-size spare tire that is identical to the regular tires, it can be used as a regular tire. However, it is important to check whether the tread depth of the spare tire is similar to that of the other tire on the same axle. Otherwise, it may cause issues such as vehicle deviation. Below is some relevant information about spare tires: 1. Whether it is a full-size or non-full-size spare tire, they are only meant for emergency use. Their speed rating and load index differ from the four regular tires on the vehicle and cannot be used as replacements. Spare tires are only for temporary use, with a maximum speed limit of 80 km/h and a driving distance not exceeding 100 kilometers. 2. Since there are no specific national regulations regarding the size of spare tires, many manufacturers opt for a smaller tire model to save costs.

15

0

Share

What is the wading depth of a stock Jeep Wrangler?

The maximum wading depth of a Jeep Wrangler is 762mm. The wading depth of a Wrangler is determined by the height of the vehicle's chassis, which corresponds to the ground clearance listed in the model's parameter configuration table. Generally speaking, the greater the ground clearance and the higher the chassis, the higher the safety factor when driving through waterlogged roads. Therefore, in terms of safe wading depth, the advantages of off-road vehicles and SUVs are obvious. However, for most compact and small cars with low ground clearance, the position of the vehicle's air intake should be used as a benchmark when passing through waterlogged roads. If the air intake of a Wrangler is below the water level while wading, water will be sucked into the engine's cylinders. Since water cannot be compressed like air, it can cause severe damage to the engine's mechanical components (such as connecting rods, pistons, crankshafts, etc.). Therefore, the wading depth should not exceed the height of the engine's air intake. Installing a snorkel can increase the height of the engine's air intake, thereby improving the maximum wading depth. If wading is unavoidable, the following safe and correct operations should be performed: Before driving through water, always turn off the auto start-stop function to prevent the engine from automatically restarting after stalling in water, which could cause severe damage due to water ingestion. Assess the underwater road conditions based on the passage of vehicles ahead and choose an appropriate entry point. Observe the paths taken by other vehicles and follow their tracks at low speed, avoiding sudden acceleration or deceleration. On roads prone to water accumulation, observe warning water level markers, trees, and reference points like the wheels and doors of other vehicles to estimate the water depth before deciding whether to proceed. Be aware of your vehicle's safe wading depth. If the water depth exceeds half the height of the tires or the engine's air intake, do not proceed and choose an alternative route instead.

19

1

Share

What is the best position to install the ETC?

The ETC is generally installed on the upper middle part of the front windshield for passenger cars, while for large vehicles like trucks and buses, it is installed on the lower middle part. The suitable installation position should be no lower than 1.2 meters and no higher than 2.5 meters, with an installation angle between 30 to 90 degrees. For vehicles with explosion-proof film or those that have it installed later, it may affect the signal transmission of the microwave communication link, so it should be installed in the microwave skylight area. ETC stands for Electronic Toll Collection. To apply for it, the vehicle owner needs to provide original and photocopies of their valid ID card and vehicle registration certificate. If the application is made by someone other than the owner, the agent's valid ID card is also required. The photocopy of the vehicle registration certificate should include the page with the most recent annual inspection stamp. A bank card for deducting highway tolls is also needed, and the vehicle must be registered under the name of an individual aged between 18 and 60. For company vehicles, the required documents are: An introduction letter from the vehicle owner (with official seal); a photocopy of the organization code certificate or business license (with official seal); the agent's original ID card; the original vehicle registration certificate; and the vehicle for which the ETC is to be installed. Here are some precautions for installing ETC: Do not obstruct the driver's view. It is best to install it behind the rearview mirror: Many car models have windshields with a large backward tilt angle, which can reduce the driver's field of vision. If the ETC is installed without considering this, it can increase the driver's blind spots. Installing it on the right side behind the rearview mirror can avoid obstructing the view. Do not interfere with charging: The ETC electronic tag consumes power but generally does not require charging or battery replacement because it has a solar panel on the back that can charge itself. Therefore, when installing, avoid the black areas on the windshield and positions that may block the solar panel. Do not remove it arbitrarily once installed: The button in the middle of the adhesive is an anti-removal rod connected to a switch. Once the electronic tag is installed, the windshield will press the anti-removal rod in. If it is removed arbitrarily, the rod will pop out and trigger the switch, locking the electronic tag and rendering it unusable. You will then need to go to an ETC service point to unlock it. This is designed to prevent multiple vehicles from sharing one device.

8

3

Share

Can You Wear Shorts for the Subject 2 Driving Test?

You can wear shorts for the Subject 2 driving test, but it is recommended to wear long pants as they are more convenient. Below is some relevant information about Subject 2: 1. Subject 2 generally refers to the Subject 2 test, also known as the small road test, which is part of the motor vehicle driver's license examination and is the abbreviation for the field driving skill test; 2. Subject 2 requires mastering basic driving operation essentials, having the basic ability to control the vehicle, being proficient in the basic methods of field and on-site road driving, possessing the ability to reasonably use vehicle control components and correctly control the spatial position of the vehicle, and being able to accurately control the vehicle's driving position, speed, and route.

2

1

Share

What to Do When a Small Nail Punctures Your Car Tire?

Does the alternating high and low beam lights finally return to the low beam?

What is the BYD One-Key Start Failure Case?

Can a Full-Size Spare Tire Be Used as a Regular Tire?

What is the wading depth of a stock Jeep Wrangler?

What is the best position to install the ETC?

Can You Wear Shorts for the Subject 2 Driving Test?

What does TC on the dashboard mean?

What are the causes of the Toyota P1604 trouble code?

What Model is a Tractor Driving License?

What is the relationship between Beijing Automobile Works and BAIC?