What to Do When a Motorcycle Fails to Start Due to Flooding?

How to judge the distance to the following car from the rearview mirror?

Here are the methods to judge the distance to the following car from the rearview mirror: 1. When the following car is within the safe zone of the rearview mirror and positioned towards the right side, it indicates a relatively large distance between the following car and your vehicle, allowing for normal turning operations. In the reflection of the right rearview mirror, if the following car is located in the center of the mirror, it suggests a distance of approximately 15-20 meters, and turning operations can still be performed safely. 2. When the body of the following car is close to the boundary between the safe zone and the danger zone, the distance to your car is about 5 meters, and you should be more cautious. Although the right rearview mirror is the farthest from the driver and observation is the most challenging, careful observation can still accurately judge the distance. When the following car occupies 1/4 of the right rearview mirror and the entire car is visible, the distance is about 25 meters, and turning operations can be performed.

3

4

Share

Can the car still run if the generator is broken?

Can the car still run if the generator is broken? The car can still run, but it will lead to insufficient power supply, posing a risk of the vehicle stalling at any time, and it may also damage the battery, reducing its service life. The methods for generator repair are: 1. Test the generator without disassembling it to determine if there is a fault; 2. Use a multimeter in voltage mode for testing; 3. When there is no ammeter on the car dashboard, use an external DC ammeter for testing. The function of the generator is: When the engine is running normally, it supplies power to all electrical equipment except the starter and simultaneously charges the battery. The generator is the main power source of the car, and its working principle is: When the external circuit energizes the excitation winding through the brushes, a magnetic field is generated, and the claw poles are magnetized into N and S poles.

20

0

Share

Can You Still Drive with a Flat Run-Flat Tire?

Run-flat tires allow you to continue driving even when they are punctured or flat. These tires are designed to ensure the vehicle can still travel at low speeds in the event of air loss, leaks, or a blowout. Tires are a crucial component of a vehicle, directly contacting the road surface and working in conjunction with the suspension to absorb shocks during driving. They ensure a comfortable ride, smooth driving, and strong adhesion between the wheels and the road, enhancing traction, braking, and off-road capability while bearing the vehicle's weight. Tire maintenance methods include: 1. Regularly removing stones stuck in the tire treads; 2. Minimizing exposure to direct sunlight; 3. Frequently checking tire pressure; 4. Paying attention to suspension maintenance; 5. Periodically inspecting front-wheel alignment; 6. Adopting careful driving habits—choose smooth roads, avoid objects that could puncture or damage the tires, and steer clear of chemical spills that may corrode the tires.

20

0

Share

What is the reason for the ABS light coming on and then turning off after restarting?

This phenomenon is normal and may be caused by poor contact of the wheel speed sensor or momentary abnormal data from other driving system sensors. Many similar warning lights may come on for a while and then turn off by themselves, and this situation does not require much attention. Below is more information about the ABS light coming on: 1. ABS refers to the Anti-lock Braking System, and TC refers to the Traction Control System. These two systems are interrelated. When the ABS detects that some wheels are slipping, it applies braking to the slipping wheels to prevent loss of traction on those wheels. This is the Traction Control System, which improves the vehicle's passability. 2. When the system is working, the yellow TC indicator on the dashboard flashes to alert the driver, and you may also hear the sound of the ABS motor running. There are many types of warning lights, including those that stay on continuously, indicating a persistent fault. Sometimes, the warning light may come on momentarily or stay on for a while before turning off by itself, which are usually intermittent or temporary faults. 3. Most of these are caused by poor component contact or road conditions and do not require concern. For example, if the airbag light comes on for a while and then turns off, it is often due to a loose yellow connector under the seat. The ABS light coming on is also mostly caused by poor contact or damage to the ABS wiring harness. Some warning lights may turn off after disconnecting the battery for about 15 minutes and then reconnecting it.

6

0

Share

What are the reasons for a car not moving when starting?

The reasons for a car not moving when starting are as follows: 1. Weak battery: The symptom is that the starter begins to turn but lacks sufficient speed or power, and later the starter only makes a clicking sound without turning. Low temperatures in winter and forgetting to turn off certain electrical devices can cause the vehicle to fail to start, especially when used for short distances at low speeds over a long period in winter, resulting in the battery voltage dropping below the rated value, making it impossible to start or operate normally. 2. Poor ignition system performance: In very cold weather, due to low intake air temperature, fuel does not atomize well in the cylinder. If combined with insufficient ignition energy, this can lead to cylinder flooding, where excessive fuel accumulates in the cylinder, exceeding the ignition limit concentration and preventing the engine from starting. Emergency solution: Remove the spark plug, clean the oil between the electrodes, and reinstall it to start the engine. 3. Valve gumming: In winter, especially after using unclean gasoline, the gum in the gasoline, which is non-combustible, accumulates near the intake and exhaust valves and the combustion chamber, making it difficult to start on cold mornings or even preventing ignition. 4. Fuel flow obstruction: The symptom is no fuel pressure in the engine's fuel supply pipe. This often occurs on extremely cold mornings due to long-term dirt in the fuel lines. At very low temperatures, water and debris mix, blocking the fuel lines and preventing the engine from starting. 5. Frozen exhaust pipe: The external symptom is foggy cylinder pressure with normal fuel and power supply, but the engine won't start. This is common in vehicles used very infrequently, such as those driven only very short distances between home and work. Water vapor from engine combustion freezes in the muffler of the exhaust pipe. If the ice from yesterday's short trip hasn't melted and new ice forms today, over time this affects exhaust flow, and in severe cases, the engine cannot start.

10

2

Share

What is the Scrap Period for Pickup Trucks?

Currently, pickup trucks are still subject to the mandatory scrapping regulation of 15 years or 600,000 kilometers. However, some regions have gradually relaxed the 15-year scrapping rule for pickups, and household pickups no longer have a fixed scrapping period. Instead, the 600,000-kilometer scrapping regulation is enforced. According to the annual inspection rules for pickups: new pickups are exempt from inspection for the first 6 years, but within the first 6 years, they must be stamped by the vehicle management office every two years. From the 7th to the 15th year, inspections are required annually, and after 15 years, inspections are required every six months. Pickups that fail the annual inspection or exceed 600,000 kilometers must be scrapped. Currently, the government is gradually providing subsidies for eligible National III diesel vehicles to be phased out. For example, in Hangzhou, the maximum subsidy amount is 14,500 yuan, and in some regions, the scrapping subsidy for diesel pickups can be as high as 40,000 yuan per vehicle. Second-hand scrapped pickups can also enjoy subsidies. Pickup Truck Scrapping and Deregistration: The applicant must send the vehicle to be scrapped to a qualified motor vehicle recycling company for dismantling and obtain the "Scrapped Motor Vehicle Recycling Certificate." The recycling company then processes the "Motor Vehicle Deregistration Certificate" with the traffic management department and notifies the owner that the vehicle has been deregistered. Pickup Truck Scrapping Subsidy Application: The applicant (or authorized agent) must go to the service window to fill out and submit the "National III Diesel Vehicle Elimination Subsidy Fund Application Form." The following documents are required for the application: Original and photocopy of the "Scrapped Motor Vehicle Recycling Certificate"; Original and photocopy of the owner's ID card (for individual vehicles) or business license (for corporate vehicles); Original and photocopy of the owner's bank card (photocopy must be signed by the individual), or original and photocopy of the company's bank account opening license (photocopy must bear the company's official seal); If handled by an agent, a full power of attorney from the owner or corporate legal representative and the original and photocopy of the agent's ID card are also required. Pickup Truck Subsidy Disbursement: After approval, the subsidy funds will be transferred to the bank account opened in the name of the owner (or company).

2

3

Share

What to Do When a Motorcycle Fails to Start Due to Flooding?

How to judge the distance to the following car from the rearview mirror?

Can the car still run if the generator is broken?

Can You Still Drive with a Flat Run-Flat Tire?

What is the reason for the ABS light coming on and then turning off after restarting?

What are the reasons for a car not moving when starting?

What is the Scrap Period for Pickup Trucks?

How to Open the Hood of a Toyota Levin?

How Many Kilometers Does a New Car Need for the Break-in Period?

What does lim mean?

What is the method for detecting engine misfire faults?