What to Do When a Car Leaks Water?

2 Answers
DeCayden
07/28/25 11:14pm
Car water leakage can be addressed by: 1. Using a dry towel or water scooping tool to remove accumulated water inside the car; 2. Identifying the leakage point and repairing it accordingly. The causes of car water leakage include: 1. Door leakage due to aging window waterproof strips or blocked door drainage holes; 2. Sunroof leakage caused by clogged sunroof drainage holes; 3. Trunk leakage resulting from poor sealing of trunk or tail light seals. The impacts of car water leakage are: 1. Minor sunroof leakage can lead to mold formation; 2. Door leakage may damage door locks and affect window lifting systems; 3. Trunk leakage can cause corrosion issues.
Was this review help?
2
5
Share
DianaLynn
08/12/25 3:39am
Last month, my car had a water leak issue, coinciding with the rainy season. After parking overnight, the carpets were completely soaked, so I immediately started troubleshooting. First, I checked the sunroof—the drainage holes are prone to clogging from leaves and mud, so I gently cleared them using a bicycle pump. Next, I inspected the door seals and found slight aging cracks along the edges, so I applied some silicone grease for maintenance, which temporarily stopped the leak. I also checked the engine bay, but the coolant reservoir showed no abnormalities. Unable to pinpoint the source of the leak, I then examined the air conditioning drain tube and removed minor debris. The whole process took about an hour. Since then, I’ve developed a habit: inspecting the seals and cleaning the sunroof drainage channels every quarter, especially before rainy weather. A little water leakage may seem minor, but prolonged dampness can corrode electrical circuits—it’s better to act early to avoid costly repairs. If the problem persists, I’ll take it to a professional shop—safety first.
Was this review help?
16
0
Share
Expand All
More Forum Discussions

What causes the N13 engine vibration issue in BMW 1 Series?

Reasons for N13 engine vibration in BMW 1 Series: Engine misfire; Worn or loose engine mounts; Carbon buildup issues. Detailed explanations of these causes: Engine misfire: Engine misfire mainly refers to one or more cylinders not functioning properly, typically manifested as noticeable intermittent exhaust gas flow and severe exhaust pipe vibration. Worn or loose engine mounts: Engine mounts are rubber blocks placed between the engine and frame. Once these mounts become worn or loose, engine vibration will become abnormally severe. Carbon buildup issues: When there's excessive carbon buildup in the engine, it affects the vehicle's ignition energy, air intake efficiency, and fuel-air mixture, leading to unstable power output and vibration during both idling and acceleration.
15
4
Share

Are out-of-town new energy vehicles restricted in Shenzhen?

Out-of-town new energy passenger vehicles are also subject to traffic restrictions and must comply with Shenzhen's traffic control regulations. Below are the relevant details: 1. Restricted hours: 7:00-9:00 and 17:30-19:30 on workdays. 2. Restricted roads: All roads citywide except the following: Shenzhen expressways, Shenzhen Bay Port, Huanggang Port, Futian Port, Luohu Port, Wenjindu Port, Shatoujiao Port, Liantang Port, and Shenzhen Airport. 3. Penalty standards: For the first two violations of the traffic restrictions by non-local passenger vehicles with non-Shenzhen license plates within the restricted zones specified in this notice, no penalty will be imposed. Starting from the third violation, fines will be issued. Vehicles violating the traffic restrictions will be fined for breaching the ban and receive 3 penalty points.
14
5
Share

Does the fuel pump replacement of Mercedes-Benz GLE320 require removing the fuel tank?

Yes. The rear floor of the Mercedes-Benz GLE320 does not have an access hole for the fuel tank, so replacing the fuel pump requires removing the fuel tank. Introduction to the fuel pump: As the most fundamental component in the engine fuel supply system, the fuel pump is responsible for drawing fuel from the tank during engine operation and delivering it continuously at a certain pressure through the fuel supply line to the engine. The high-pressure fuel pump then performs secondary pressurization, providing a measured amount of fuel to each cylinder according to the engine's firing order. Causes of insufficient fuel pump pressure: Wear of the oil seal at the rear end of the fuel pump drive gear shaft or loose pipe connections, leading to air in the pipeline.
4
3
Share

How to Turn on the Headlights of a Leiling Car?

Method to turn on the Leiling headlights: Use the control lever on the left side of the steering wheel. After turning on the headlights, the default state is low beam; push it forward once to switch to high beam. Similarly, if it cannot be pushed forward further in the default state, it means it is already in high beam mode. Introduction to the 2019 GAC Toyota Leiling: 1. Body dimensions: Length, width, and height are 4640mm, 1780mm, and 1455mm respectively, with a wheelbase of 2700mm. 2. Powertrain: Offers two options: a 1.2T engine and a 1.8L hybrid system. The 1.2T engine has a maximum power of 85kW and peak torque of 185Nm; the 1.8L hybrid system's engine has a maximum power of 72kW.
4
5
Share

What are the reasons for the malfunction of the Venucia D60 smart key system?

Venucia D60 smart key system malfunction reasons and solutions are as follows: Dead battery: The battery is dead or has poor contact. Key control module failure: If the time control module in the remote key fails, it will also cause the remote to not work. Remote transmitter antenna aging: Due to the aging of the vehicle's remote transmitter antenna, this situation can also occur. In such cases, you can go to a repair station for inspection and repair. Solutions: First, try using the spare key to determine if that key can function normally. If the spare key works fine, it proves that the other key is faulty. You can have it reprogrammed at a 4S shop or an external auto repair shop. Remember to bring the key serial number from the user manual, as it will be needed during reprogramming.
18
4
Share

What Does Third-Party Liability Insurance in Auto Insurance Cover?

Third-party liability insurance covers the repair costs of the third party's vehicle, damages to the third party's car body caused by the insured, and medical compensation for the driver, among others. Additional information is as follows: 1. Third-party liability insurance: Refers to the financial liability that the insured or their permitted driver must bear under the law when an accident occurs during the use of the insured vehicle, resulting in bodily injury, death, or direct property damage to a third party, for which the insurance company is responsible for compensation. 2. Classification of third-party liability insurance: It can be divided into voluntary liability insurance and compulsory liability insurance based on whether it is mandatory. According to the scope of coverage, it can be classified into third-party bodily injury liability insurance and third-party property damage liability insurance. Compulsory liability insurance can be further divided into relatively compulsory insurance and absolutely compulsory insurance based on the degree of compulsion.
3
5
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.