What to Do If You Fail the First Attempt of Subject 2 Driving Test?

How to Adjust the Cadillac Air Conditioning to Heating Mode?

Method to adjust the Cadillac air conditioning to heating mode: 1. After starting the car, wait for 5 to 10 minutes until the water temperature rises to the normal level; 2. Press the off switch on the center console to turn on the air conditioning and adjust the circulation mode to internal circulation; 3. Press the red button to switch to the heating mode. When the car air conditioning is in cooling mode, the engine drives the compressor to operate. The compressor continuously compresses the refrigerant and delivers it to the evaporator. The refrigerant expands and absorbs heat in the evaporator, thereby cooling it. The cooled evaporator then cools the air blown by the blower, allowing cold air to be emitted from the air vents. The heating principle of car air conditioning is simpler. During heating, the high-temperature coolant from the engine flows through the heater core, and the air blown by the blower also passes through the heater core, resulting in warm air being emitted from the vents. Most car air conditioning systems use R134a refrigerant, which needs to be replaced periodically. Failure to replace it in time can affect the cooling speed and effectiveness of the car air conditioning.

11

0

Share

How to Turn On the Fog Lights on a 2018 Corolla?

The fog light switch of the Corolla is located on the inner side of the control lever. The method to turn them on is as follows: 1. Control by rotation—turn upward once to activate the front fog lights. 2. Turn twice to the position for the rear fog lights. 3. This simultaneously turns on both front and rear fog lights; reverse the process to turn them off. 4. After turning on the parking lights, you can then activate the fog lights. Additional information: 1. Fog lights are a special type of lighting. The fog light bulb is made with a special flash head, with reflective glass in front of the flash tube, and all the light output is diffused light reflected by the reflector. 2. Because visibility is low in foggy conditions, the driver's line of sight is limited. The lights can increase the visible distance, especially the strong penetration of yellow fog lights, which improves visibility for the driver and other traffic participants, allowing approaching vehicles and pedestrians to spot each other from a greater distance. When driving at night in the city without fog, do not use the fog lights. The front fog lights lack a glare shield, which can make the vehicle lights dazzling and affect driving safety.

10

4

Share

How often should Mobil Silver be changed?

Mobil Silver is a fully synthetic engine oil that can be changed every 10,000 kilometers. For vehicles that are not frequently used, it should be changed every 6-7 months based on time. If you are in a particularly harsh environment, such as heavy dust, very low temperatures (below -20°C), or frequently make short trips (each drive is less than 8 kilometers), as long as one of these three factors applies, it is recommended to shorten the oil change interval to every 7,000-8,000 kilometers. Mobil Silver is a fully synthetic engine oil with viscosity grades of 5W-30, 5W-40, and 5W-50. It belongs to the 5th generation formula, with average performance, significantly inferior to Mobil Gold.

12

2

Share

What Are the Causes of Transmission Noise?

The causes of transmission noise include: 1. The oil pump produces noise due to excessive wear or improper hydraulic oil level (too low or too high); 2. The torque converter generates noise due to damage to the lock-up clutch, guide wheel one-way overrunning clutch, etc.; 3. Noise from the planetary gear mechanism; 4. Noise from shift execution components. For fault diagnosis and troubleshooting, check the hydraulic oil level of the automatic transmission. If it is too high or too low, adjust it to the normal level. Use a lift to raise the vehicle, start the engine, and check the location and timing of the noise in the automatic transmission under neutral, forward, and reverse gears. If there is continuous noise in the automatic transmission in any gear, it is usually caused by the oil pump or torque converter. In this case, disassemble the automatic transmission for inspection, check whether the oil pump is worn, and whether there is a large amount of friction powder in the torque converter. If abnormalities are found, replace the oil pump or torque converter. If the automatic transmission only produces noise while driving and is silent in neutral, it is likely due to noise from the planetary gear mechanism. In this case, disassemble the automatic transmission and inspect each component of the planetary gear set for signs of wear, check for broken gears, wear or sticking of the one-way overrunning clutch, and damage to bearings or thrust washers.

1

2

Share

Is the Kawasaki Ninja 650 speed limited?

This motorcycle does have a top speed. The maximum speed of this motorcycle can reach 195 kilometers per hour. The Kawasaki Ninja 650 is equipped with a 649cc twin-cylinder four-stroke liquid-cooled engine, which delivers a maximum power of 46 kW and a maximum torque of 63 Nm. The engine reaches its maximum power at 7,000 rpm and its maximum torque at 6,500 rpm. The engine compression ratio of this motorcycle is 10.8:1, with a bore of 83 mm and a stroke of 60 mm.

7

1

Share

What are the functions of various buttons in a sedan?

Introduction to the functions of various buttons in a sedan: 1. Fuel tank opening button: This button is used to remotely open the fuel tank cap from inside the car. In vehicles equipped with this button, the driver can open the fuel tank cap by pressing this button. 2. ESP switch: This is used to turn the vehicle's ESP system on or off. The ESP system is set to the working state by default. To enjoy a more direct driving experience, the owner can press this button to turn off the ESP system. 3. Parking radar button: This is used to turn the vehicle's parking radar system on or off as needed. The driver can press this button to manually control the operation of the parking radar. 4. Central lock button: This is the control button for the vehicle's central door lock system. The owner can press this button to simultaneously lock or unlock all the doors. 5. Headlight washer button: This is used to control the automatic cleaning function of the headlights. In vehicles equipped with headlight washers, the owner can press this button to activate the headlight washer device, which sprays water to clean the headlights. 6. Rear sunshade button: This is used to control the opening and closing of the electric rear sunshade inside the car. In vehicles equipped with an electric rear sunshade, the owner can press this button to open or close the electric sunshade on the rear window.

12

4

Share

What to Do If You Fail the First Attempt of Subject 2 Driving Test?

How to Adjust the Cadillac Air Conditioning to Heating Mode?

How to Turn On the Fog Lights on a 2018 Corolla?

How often should Mobil Silver be changed?

What Are the Causes of Transmission Noise?

Is the Kawasaki Ninja 650 speed limited?

What are the functions of various buttons in a sedan?

What is the ground clearance of the Lynk & Co 03 in centimeters?

What is the time setting procedure for Wuling Hongguang?

Where is the Anti-Static Grounding Strip Installed on a Car?

How to Remove and Install an Angle Valve?