···
Log in / Register

What to do if you can't afford the loan for your car?

1 Answers
LeElliot
07/29/25 10:35pm
If the motor vehicle is repossessed by the loan company, it will be used to cover the remaining loan balance. Selling the vehicle to repay the loan with the proceeds is another option. The specific approach should be chosen based on your actual financial situation.
Was this review help?
18
0
Share
More Forum Discussions

Where is the oil filter element of the Boyue located?

The oil filter element of the Boyue is located at the upper right front of the engine and can be seen by opening the engine hood. The functions of the oil filter element are: 1. To reduce the friction resistance between moving parts in the engine and minimize part wear; 2. To filter out impurities, gum, and moisture from the engine oil. The Boyue is a compact SUV under Geely, with body dimensions of 4519 mm in length, 1831 mm in width, 1694 mm in height, and a wheelbase of 2670 mm. The Boyue is equipped with a 1.8T turbocharged engine, delivering a maximum power of 120 kW at 5500 rpm and a maximum torque of 250 N·m, paired with a 6-speed manual transmission.
14
4
Share

How often should the spark plugs be replaced for Golf 6?

The spark plugs for Golf 6 should normally be replaced after driving 40,000-50,000 kilometers, and can be replaced with iridium-platinum spark plugs. Under normal maintenance conditions, they should be replaced between 40,000 to 60,000 kilometers, but this may vary depending on the brand and engine. It is recommended to follow the user manual. The following standards can be referenced for maintenance replacement: platinum spark plugs should be replaced at 40,000 kilometers, ordinary nickel alloy spark plugs at 20,000 kilometers, and iridium spark plugs at 60,000-80,000 kilometers. Steps for replacing spark plugs: Open the hood, lift the plastic cover of the engine, remove the high-voltage ignition wires, and mark each cylinder's position to avoid confusion. Use a spark plug socket to remove the spark plugs one by one. While removing them, check for any external debris like leaves or dust, and ensure they are cleaned thoroughly. Place the new spark plug into the spark plug hole, hand-tighten it a few turns, and then use the socket to tighten it further. Reinstall the removed high-voltage ignition wires according to the firing order, and then secure the cover.
17
1
Share

How to Use the Auto Hold Function in Volkswagen Magotan?

To use the Auto Hold function in the Volkswagen Magotan: Press the AUTOHOLD button to activate it. Auto Hold is an extension function of the electronic parking brake, controlled by the ESP component to apply the brakes. The Volkswagen Magotan is a mid-size car under FAW-Volkswagen, with body dimensions of 4865mm in length, 1832mm in width, and 1471mm in height, and a wheelbase of 2871mm. The Magotan is equipped with a 1.4T turbocharged engine, delivering a maximum horsepower of 150ps and a maximum power of 110kw, with a maximum power speed range of 5000 to 6000 rpm. It is paired with a 7-speed dual-clutch transmission.
13
3
Share

How to Remove the Brake Pads of an Audi A5?

Here is the method for removing the brake pads of an Audi A5: 1. First, remove the wheels of the Audi A5. 2. Take off the dust cover, disconnect the brake pad sensor plug from the bracket, and unscrew the brake caliper fixing bolts. 3. Then, after removing the brake caliper housing, secure it to the car body with a metal wire to prevent the caliper's weight from pressing on or damaging the brake line. 4. Finally, remove the brake pads from the brake caliper housing. Additional information: Brake pads are consumable items. It is a good habit to regularly check the wear level of the brake pads. To check the wear of the brake pads without removing the tire, tilt your line of sight at a 15° angle to the plane of the wheel hub and look at the gap between the brake pad and the brake disc to assess the wear level. A brake pad in good condition has a thickness of about 1 cm. If the thickness is less than 5 mm, it needs to be replaced promptly.
13
1
Share

How to Activate the Headlight Washer on a BMW?

Turn on the low beams, then push the turn signal lever forward once to activate the high beams. Finally, press and hold the windshield wiper control lever toward the steering wheel for 5 seconds. More relevant information is as follows: 1. The headlight washer system refers to a water outlet located below the headlights, which can clean dust and dirt from the headlights at any time. When driving at night or in low-light conditions, rain and dust can reduce the illumination of the headlights by up to 90%, severely impairing the driver's visibility and posing a significant safety hazard. Ensuring sufficient headlight illumination and providing clear visibility for the driver becomes a critical issue that needs to be addressed in such situations. The headlight washer system offers a simple and effective solution to this problem. 2. The headlight washer system is primarily used on vehicles equipped with xenon headlights. This is because xenon headlights are extremely bright and can cause glare for oncoming drivers. Therefore, xenon headlights are usually equipped with lenses to adjust the light beam to a reasonable angle, preventing interference with other drivers and ensuring road safety. However, if the headlight covers are covered with mud, dirt, or debris, it can affect the scattering of the headlight beams, necessitating cleaning.
14
5
Share

Which country is the Bentley brand from?

Bentley (Bentley Motors Limited) is a British luxury car brand headquartered in Crewe, England. Its main models include Bentayga, Continental, Continental Flying Star, Continental GT/GT Convertible, Flying Spur V8, Mulsanne, Speed 8, Camargue, State Limousine, Bacalar, Hunaudières, etc. The important milestones in Bentley's development are as follows: In 1919, Mr. W.O. Bentley founded Bentley Motors Limited. In 1919, Mr. W.O. Bentley introduced the Bentley 3.0 car at an automobile exhibition, marking the beginning of Bentley's journey in professionally designing high-end sports cars and racing cars. In 1931, Walter Owen Bentley officially joined Rolls-Royce Motors. In 1933, the first Bentley car designed by Bentley and produced by Rolls-Royce was launched, named the "Bentley 3.5". In 1946, Bentley's car production line was moved to Crewe, England. In 1952, the S-type sedan, featuring a Rolls-Royce "Silver Cloud" body, a 4.9-liter engine, and an automatic transmission, was introduced to the market. In 1965, Bentley launched the T-series. In 1998, Bentley was acquired by Volkswagen. Since 2002, Bentley has replaced Rolls-Royce as the only car brand designated by the British royal family. In March 2013, Bentley announced at the Geneva Motor Show that the Flying Spur would officially be separated from the original Continental series.
17
2
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.