What to Do If You Accidentally Enter a Wrong-Way Lane When Turning Right?

2 Answers
McJack
07/30/25 12:31am
If a car accidentally enters a wrong-way lane after turning right, it must stop immediately, pull over to the side with hazard lights on, and call the traffic police for assistance. Wrong-way driving on a one-way street refers to the act of making a U-turn on a road designated for one direction of travel and proceeding in the opposite direction. Consequences of Wrong-Way Driving on a One-Way Street: This behavior is prone to causing traffic accidents and is strictly prohibited by law. On highways, wrong-way driving results in an immediate deduction of 12 points from the driver's license, a fine of 200 yuan, and possible suspension of the driver's license for twelve months. System Delays in Traffic Violation Query Platforms May Cause Delays in Clearing Fine Records: From the moment a violation occurs, it undergoes steps such as being captured, confirmed, and publicized. Similarly, processing the violation's point deduction and paying the fine also requires the system to follow corresponding procedures.
Was this review help?
18
1
Share
LaTravis
08/15/25 5:17am
A few days ago, I encountered this situation—I didn’t see clearly when turning right and drove straight into the opposite lane. At that moment, I broke into a cold sweat, but I immediately steadied the steering wheel and turned on the hazard lights. Taking advantage of the distance of the oncoming cars, I quickly reversed and backed up, luckily with no cars following behind. The whole process took only about ten seconds, but the movements had to be steady and not rushed. If the situation had been truly dangerous, I would have immediately pulled over, turned off the engine, activated the hazard lights, and called the police to wait for traffic officers to direct traffic. Later, when dealing with the violation, I was severely lectured—three points deducted and a fine of 200 yuan. The most profound lesson was to always stretch my neck and check the ground arrows and no-entry signs before turning right.
Was this review help?
2
3
Share
Expand All
More Forum Discussions

Why did the Haval H6 steering wheel suddenly become heavy?

Reasons for the sudden heaviness of the Haval H6 steering wheel: lack of power steering fluid, blown fuse, or tire leakage. Lack of power steering fluid: For hydraulic power steering, check if there is a lack of power steering fluid or any leakage. If fluid is low, replenish it to the normal range. If the fluid level is adequate, check whether the power steering pump belt is too loose. If it is, tighten the belt. Also, inspect if the fluid is too dirty, which can reduce its flow efficiency. Generally, it should be replaced every 2 years or 60,000 kilometers. Blown fuse: For electronic power steering, check if the fuse is blown and whether there are any open circuits or short circuits to ground in the wiring. Additionally, check the tire pressure, as leakage can also cause the steering to become heavy, necessitating inflation.
20
5
Share

Where is the wiper relay in Lavida?

It may be in the control box under the hood. Car relays are generally similar, so you can try following the control line of the wiper to locate it. Introduction to wipers: Wipers are blade structures installed in front of the windshield, composed of a motor, reducer, four-bar linkage, wiper arm spindle, wiper blade assembly, etc. Their main function is to clear rain, snow, and dust from the windshield that obstruct the driver's view, thereby improving visibility and enhancing driving safety. Due to legal requirements, almost all cars worldwide are equipped with wipers. Regular cleaning of wipers: Use a dedicated cleaning solution to wipe and clean the wipers during each car wash. During maintenance, also pay attention to the condition of the wipers. Avoid pulling or tugging them too forcefully, as this can easily damage the wipers.
16
5
Share

Is the Haval H4 automatic transmission fuel-consuming?

Haval H4-1.5T automatic transmission has a MIIT comprehensive fuel consumption of 6.9L/100km, which is slightly higher compared to other vehicles. Maintain normal tire pressure levels: If the tire pressure is insufficient, rolling resistance will significantly increase. According to tests, if the tire pressure is 2psi (unit of pressure: pounds per square foot) below the specified value, fuel consumption will increase by 1%. Repair faults promptly: Abnormalities in the engine ignition system also have a significant impact on fuel consumption. Issues such as inaccurate ignition timing, leakage in high-voltage wires, and weak ignition caused by spark plug carbon deposits can all reduce engine combustion efficiency and increase fuel consumption.
18
2
Share

Where is the VIN located on the Compass?

JEEP Compass VIN is located under the hood of the JEEP Compass, inside the JEEP Compass engine compartment, on the nameplate directly above the JEEP Compass engine. Introduction to VIN: The VIN is the Vehicle Identification Number, an abbreviation for Vehicle-Identification-Number in English. Regulations regarding VIN: According to SAE standards: The VIN consists of 17 characters, hence it is commonly referred to as the 17-digit code. It contains information about the vehicle's manufacturer, year, model, body type and code, engine code, and assembly location, among others. Correctly interpreting the VIN is crucial for owners to accurately identify the vehicle model and for proper diagnosis and maintenance.
2
1
Share

How Many Times is the Pajero's Torque Amplified?

Pajero's torque can be amplified up to 1.9 times. The Mitsubishi Pajero V97, with a 3.8L engine, has a maximum horsepower of 250 HP and a maximum torque of 329 Nm. Introduction to Torque: Engine torque refers to the moment output from the crankshaft end of the engine. Under fixed power conditions, it is inversely proportional to the engine speed. The faster the speed, the smaller the torque, and vice versa. It reflects the vehicle's load capacity within a certain range. Method of Expressing Torque: Torque is expressed in N.m/r/min. The maximum torque generally appears in the medium to low-speed range of the engine. For example, ordinary motorcycles can achieve maximum torque at medium speeds (around five to six thousand RPM).
16
4
Share

Why is the suspension of the new Santana so stiff?

The reasons for the stiff suspension of the new Santana: shock absorber oil leakage, shock absorber malfunction. Shock absorber oil leakage: First, check if the shock absorber is leaking oil. Look directly at the shock absorber housing or dust cover when it's not raining or the car hasn't been washed. It's very obvious and can be seen at a glance. Shock absorber malfunction: When driving at low speed, if there is a "thud" sound when the wheels pass over bumps or slight vibrations on the road, it indicates a shock absorber malfunction. The abnormal noise from the shock absorber is different from other chassis noises—it's very dull. If it's the front shock absorber, there will also be noticeable vibration felt on the steering wheel.
3
3
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.