What to Do If the Rear Bumper of the Car Is Scratched?

1 Answers
DeReid
07/29/25 1:42pm
The solutions for a scratched rear bumper of the car are: 1. Minor scratches: If the paint damage is on the surface layer of the topcoat, it can be completely repaired by waxing; 2. Large-area scratches: A touch-up pen can be used for treatment. Bumpers are made of plastic, and scratches that are left untreated will not affect the quality of the car. Composition of the car bumper: 1. The outer panel and cushioning material are made of plastic, and the crossbeam is a U-shaped channel pressed from cold-rolled thin plates about 1.5 mm thick; 2. The outer panel and cushioning material are attached to the crossbeam, and the crossbeam is connected to the frame longitudinal beam with screws, allowing it to be detached at any time.
Was this review help?
3
2
Share
More Forum Discussions

How to Replace the Carbon Brushes of a Car Generator?

Steps to replace the carbon brushes of a car generator: 1. Unplug the generator connector; a flat-head screwdriver can be used to remove the plug. 2. Remove the fixed nut of the cable connecting the generator to the battery. 3. Loosen the generator belt. 4. Remove the guide wheel after loosening the belt, and unscrew the generator fixing bolts. 5. Take off the generator and remove the regulator. 6. Saw off the solder joint at the tail of the carbon brush to remove the old carbon brush. 7. Install the new carbon brush and ensure the original spring is properly positioned. The generator is a very important component in the car. When the car engine is not started, the battery powers the electronic devices inside the car. Once the engine is started, the generator takes over the power supply for the car's electronic devices instead of the battery. During routine maintenance of the generator, it is essential not only to check the condition of the generator but also to inspect the state of the generator belt. If the generator belt breaks while driving, it can be very dangerous.
13
5
Share

What are the reasons for a car making a squeaking noise?

Reasons for a car making a squeaking noise: 1. Dashboard rattle: If there are objects or large gaps in the dashboard, it can cause noise issues; 2. Tire punctured by a nail: If the tire runs over a nail on a bumpy road, friction can cause noise; 3. Brake system damage: Including driving without releasing the handbrake, severely worn brake pads, or caliper malfunctions. The specific cause requires further inspection; 4. Loose engine belt: A loose engine belt can cause it to idle and produce a sharp noise; 5. Steering gear failure: A faulty car steering gear can also produce squeaking noises; 6. Prolonged use or aging of the car: After prolonged use or aging, some parts may loosen, leading to friction and noise.
3
2
Share

How to Maintain a Car Generator?

Car generator maintenance methods: 1. Pay attention to the wear of the bearings. If insufficient lubrication is found, a few drops of oil can be added from the oil cup opening, but be careful not to let it seep into the rectifier, as this may affect the electrical transmission efficiency; 2. If the rectifier accumulates dirt, it can be polished with fine sandpaper; 3. If the contact surface of the brush is uneven, it can be leveled with fine sandpaper. If the spring's elasticity is insufficient or the brush is excessively worn, replace them with new parts. If the brush is too short but not damaged, a shim can be inserted into the bracket to ensure tight contact with the rectifier; 4. If the brush bracket insulator is damaged, replace it with a new part; 5. If the generator's pole terminals are loose, they must be tightened immediately. If there is poor insulation, remove and repair it.
4
3
Share

What items are included in the second car maintenance?

The second car maintenance includes the following items: 1. Replace the three filters and engine oil; 2. Check whether the brake fluid, transmission oil, and power steering fluid need replacement; 3. Inspect the brake pads, tires, shock absorbers, and suspension; 4. Check the spark plugs, throttle valve, and fuel supply system; 5. Rotate the front and rear wheels and perform routine checks (lights, battery, etc.). After replacing the engine oil and oil filter during the second maintenance, it is important to reset the vehicle's maintenance reminder to prevent it from lighting up after driving for a while. Check the vehicle's tire pressure and inflate if necessary. The air filter and cabin air filter should not be dirty; clean them with compressed air. Inspect the vehicle's chassis for any scratches from daily driving and check for oil or water leaks, addressing any issues promptly. Check the levels of coolant, brake fluid, and power steering fluid to ensure they are between the high and low marks, and top up if they are below the minimum level.
12
3
Share

What transmission does the Hyundai Elantra have?

Hyundai Elantra is equipped with a 6-speed manual and 6-speed automatic transmission. In terms of power, the currently available Hyundai Elantra is powered by a 1.6L naturally aspirated engine, with a maximum power output of 93.8kW, maximum torque of 156Nm, and maximum horsepower of 128PS. The Hyundai Elantra has body dimensions of 4570mm in length, 1775mm in width, and 1445mm in height. It is a global model from Hyundai that was first launched overseas. The car features a multifunctional steering wheel with abundant buttons, integrating audio controls, cruise control, Bluetooth phone buttons, etc. The arc-shaped design not only adds a sporty touch but also complements the center console design.
5
4
Share

How Many Kilometers to Clean the Fuel Injector and Throttle Body?

3 to 50,000 kilometers to clean the fuel injector and throttle body, throttle body cleaning is not based on mileage, but determined by the local environment. When maintaining the car, remove the intake pipe to check if it is dirty. The fuel injector should be cleaned every 20,000 kilometers, or you can add fuel injector cleaner to the fuel tank for cleaning. There is a specific ratio for how much cleaner to add based on the amount of fuel. The throttle body is a controllable valve that regulates air entering the engine. After entering the intake pipe, the air mixes with gasoline to form a combustible mixture for combustion and power generation. The throttle body connects to the air filter at the top and the engine block at the bottom, known as the throat of the car engine.
19
3
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.