What to do if the Mazda CX-4 reversing camera does not display?

1 Answers
McJace
07/29/25 9:19am
There are different solutions for a car reversing camera not displaying, depending on the cause: 1. Camera malfunction: You can purchase and install a new one. It's best to buy one with an illumination power supply so you can see at night. 2. Loose power cable causing camera power failure: Simply plug the power cable in more tightly and check for any water marks on the plug, as power issues are often caused by short circuits due to water marks. 3. Broken wiring: Use sealant to secure and firmly fix it to avoid being pinched off while driving. 4. Display screen damage: Carefully observe the power supply to the display screen, check for any cracks or loose surrounding wires. If it cannot be repaired, purchase and install a new one.
Was this review help?
14
1
Share
More Forum Discussions

Do I need to slow down and shift to second gear when going straight at an intersection in Subject 3?

You need to slow down when going straight at an intersection in Subject 3, but whether to shift to second gear depends on the vehicle speed, as there is no mandatory requirement. The principle for passing through an intersection is: first slow down, second look around, and third proceed, as long as the actions are properly executed. Correct operation method for going straight at an intersection in Subject 3: Approximately 120 meters before reaching the intersection, the voice prompt will automatically indicate the direction of travel. After hearing the prompt "Go straight at the intersection ahead," first slow down, observe the traffic conditions in all directions, and pay attention to yielding to pedestrians and vehicles with the right of way. When you hear the prompt "Pedestrians crossing," you must brake and stop to wait. Do not slow down or keep honking, otherwise you will lose 100 points. The examinee should choose the appropriate lane according to the lane guidance arrow and proceed as directed by the traffic signal. Before passing the stop line at the intersection, there should be a deceleration action or the speed should be controlled below 35 km/h. When going straight through the intersection, observe the traffic conditions on the left and right. Do not stop the vehicle inside the intersection. Gear and speed matching requirements for Subject 3: 1st gear is used for normal starting, with a speed generally around 10 km/h. 2nd gear is a transitional gear for acceleration after starting or for low-speed driving, with a speed generally around 20 km/h. 3rd gear is used for speeds between 20-40 km/h, commonly used for urban driving. 4th gear can be used for speeds between 40-60 km/h. 5th gear is used for speeds above 60 km/h.
2
0
Share

What are the main topics covered in Subject 1 of the driving test?

The questions for Subject 1 of the motor vehicle driver's license test are divided into single-choice and true/false questions, totaling 100 questions. According to the "Regulations on the Application and Use of Motor Vehicle Driver's Licenses," each question is worth 1 point, with a total score of 100 points. If a candidate answers 11 questions incorrectly during the test, the system will automatically submit the test and end the exam. Subject 1, also known as the theoretical driving test or driver theory test, is part of the motor vehicle driver's license assessment. The test content includes driving theory basics, road safety laws and regulations, local regulations, and related knowledge. The test is conducted on a computer, with a time limit of 45 minutes. The content of Subject 1 includes: driver's license and motor vehicle management regulations; road traffic conditions and regulations; road traffic safety violations and penalties; road traffic accident handling regulations; basic knowledge of motor vehicles; local regulations; knowledge of braking systems and safety devices for large and medium-sized passenger and freight vehicles; specialized knowledge for wheeled self-propelled machinery, trams, and trolleybuses. Notes for Subject 1 exam: Candidates should pay attention to their attire—no slippers are allowed, and electronic devices and bags are prohibited in the exam room. Bring your ID card and queue to enter the waiting hall. Observe the instructions and procedures on the large screen, and store personal belongings in a locker before entering the exam room. Upon entering, you will be assigned a seat at the identity verification area. Once seated, begin the test, ensuring the camera is aligned with you and adhering to exam discipline. If you fail the first attempt, a retake is available on the same day. If you fail again, you will need to pay and reschedule. After the test, queue to collect your score report and sign it—failure to sign renders the result invalid. There is no limit to the number of times you can schedule Subject 1. Each subject can be taken once, with one retake allowed if you fail. If you do not take the retake or fail it, the exam ends, and you must reschedule. For Subject 2 and Subject 3, there are only five attempts allowed. Subject 2 and Subject 3 exams must be scheduled at least ten days apart. If you fail the Subject 3 safe and civilized driving knowledge test, your previously passed road driving skills test results remain valid. There are three subjects in the driving test: Subject 1, Subject 2, and Subject 3. Subject 1 refers to the road traffic safety laws, regulations, and related knowledge test; Subject 2 refers to the field driving skills test; Subject 3 is divided into two parts: road driving skills and safe and civilized driving knowledge tests. The safe and civilized driving knowledge test is conducted after Subject 3, so it is commonly referred to as Subject 4. However, in official terms (i.e., the Ministry of Public Security's Order No. 123), there is no such thing as Subject 4.
19
4
Share

How to Remove the Rear Seats of Jetta VS5?

Jetta VS5 body dimensions are: length 4419mm, width 1841mm, height 1616mm, wheelbase 2630mm, fuel tank capacity 51l, luggage compartment volume 482l. Jetta VS5 is equipped with a 1.4t turbocharged engine, with a maximum power of 110kw and a maximum torque of 250nm, matched with a 5-speed manual transmission. The front suspension type is MacPherson independent suspension, and the rear suspension type is multi-link independent suspension.
11
2
Share

Is MG a Domestic Car Brand?

MG is a domestic car brand, and its models include: MG6, MG5, MG ZS, MG HS, MG Pilot, etc. Taking the 2020 MG6 as an example, its body dimensions are: length 4704mm, width 1848mm, height 1466mm, with a wheelbase of 2715mm. The 2020 MG6 is equipped with a 1.5T turbocharged engine, delivering a maximum power of 133 kW and a maximum torque of 285 Nm. It is paired with a 6-speed manual transmission. The front suspension uses a MacPherson independent suspension, and the rear suspension employs a multi-link independent suspension.
7
2
Share

What brand are the original tires on the Jeep Cherokee?

The original tires on the Jeep Cherokee are Bridgestone. Tires are circular elastic rubber products assembled on various vehicles or machinery to roll on the ground, usually mounted on metal rims. They support the vehicle body, cushion external impacts, ensure contact with the road surface, and maintain the vehicle's driving performance. The dimensions of the Jeep Cherokee are: length 4669 mm, width 1865 mm, height 1691 mm, with a wheelbase of 2707 mm. The Jeep Cherokee is equipped with a 2.0T turbocharged engine, delivering a maximum power of 195 kW and a maximum torque of 400 Nm, paired with a 9-speed automatic transmission.
8
5
Share

Should Windshield Washer Fluid Be Diluted with Water?

Whether windshield washer fluid should be diluted with water depends on the type of fluid: 1. Ready-to-use liquid windshield washer fluid does not need dilution and can be directly poured into the reservoir; 2. Solid windshield washer fluid requires dilution, as it needs to be dissolved in clean water before use; 3. Highly concentrated liquid windshield washer fluid must be diluted with water in the correct proportion, as direct use can be too corrosive. Windshield washer fluid, short for automotive windshield cleaning fluid, mainly consists of water, alcohol, ethylene glycol, corrosion inhibitors, and various surfactants. Based on its form, windshield washer fluid can be categorized into solid and liquid types, both providing cleaning and antifreeze properties.
2
5
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.