What to Do If Failing the Vision Test for Driver's License?

1 Answers
Axel
07/30/25 12:47am
During the driver's license physical examination, if you fail the vision test, you can correct your vision or wear glasses with the appropriate prescription and retake the test. Below is relevant information about the driving test: 1. Subjects: There are four subjects in the driving test. The content and passing standards are unified nationwide, and the test sequence follows Subject 1, Subject 2, Subject 3, and Subject 4 in order. Only after passing the previous subject can you proceed to the next. 2. Specific Content: Subject 2 includes reversing into a parking space, stopping and starting on a slope, turning at a right angle, driving along curves, and parallel parking; Subject 3 consists of a simulated lighting test, starting, driving straight, shifting gears, changing lanes, etc.
Was this review help?
5
1
Share
More Forum Discussions

What is the function of the AOFF button in a car?

The AOFF button in a car controls the automatic start-stop function, serving as a disable button for the vehicle's start-stop feature. When the button's indicator light is on, the start-stop function is turned off. Pressing the button to turn off the indicator light enables the start-stop function, although other conditions may also affect whether the function is disabled. The AOFF light being on indicates that the vehicle's engine automatic start-stop function is activated. This function effectively protects the engine from damage and helps reduce fuel consumption. Normally, the AOFF function can remain on, but it should be turned off when the vehicle is driving through deep water to prevent potential engine damage.
20
1
Share

What does it mean when the SVS light on the dashboard is on?

The illumination of the SVS light on the dashboard indicates that the engine control unit has detected an error signal from a certain sensor or that the sensor has exceeded its standard operating parameters. When the ignition is turned on, the SVS indicator light will illuminate for an automatic check and then turn off after a few seconds. If the SVS light is on, you can attempt to start the engine. If the engine fails to start, it could be due to an abnormal fuel pump, which is unable to supply fuel properly to the engine. If the engine starts despite the SVS light being on, it might be a fault with another sensor. In such cases, the vehicle may still be drivable, but there is a possibility that the fault could affect normal vehicle operation, such as increased fuel consumption or body vibrations.
6
0
Share

How to Replace the Battery in a Roewe 350 Car Remote?

Steps to replace the battery in a Roewe 350 car remote: 1. Pop open the key; 2. Use a small flat-head screwdriver to rotate the screw located in the remote key storage slot to the ON position; 3. Gently pry the locking screw end of the remote battery seal cover with a small flat-head screwdriver, then remove the remote battery and seal cover; 4. Use tweezers to remove the remote battery, paying attention to the battery's polarity; 5. Install the new battery, ensuring the polarity is correct; 6. Insert the remote battery seal cover back into the remote, making sure it is positioned correctly and fully seated; 7. Use a small flat-head screwdriver to rotate the screw in the remote key storage slot to the OFF position. The Roewe 350 has a body length of 4521 mm, width of 1788 mm, height of 1492 mm, and a wheelbase of 2650 mm.
10
2
Share

How to Remove the Intake Manifold of EA888?

ea888 intake manifold removal steps: 1. Turn off the vehicle and disconnect the negative terminal of the battery; 2. Open the hood, remove the manual maintenance switch, electronic throttle body, and intake air temperature sensor; 3. Remove the clamps securing the intake pipe, move the pipe aside, unscrew the bolts on the intake manifold assembly, and then remove the assembly. The intake manifold refers to the intake pipe between the carburetor or throttle body and the cylinder head intake ports. Its function is to distribute the air-fuel mixture from the carburetor or throttle body to the intake ports of each cylinder. The automobile intake manifold mainly distributes external air and the air-fuel mixture through the carburetor or throttle body to the intake ports of each cylinder.
7
0
Share

What kind of car is the lamando in Volkswagen?

lamando is the Volkswagen Lamando, a compact car with body dimensions of 4599mm in length, 1826mm in width, and 1425mm in height. In terms of power, the Lamando is equipped with two engines: one is a low-power version of the 1.4-liter turbocharged engine, and the other is a high-power version of the 1.4-liter turbocharged engine. Both engines belong to Volkswagen's EA211 series. For the transmission system, the 230TSI and 280TSI models of the Lamando are paired with a 5-speed manual transmission and a 7-speed dual-clutch transmission, while the 330TSI and 2.0TGTS models are matched with a 7-speed dual-clutch transmission.
18
2
Share

How to Install the Water Pump Belt on a Ford Focus?

Ford Focus water pump belt installation method is: 1. Remove the water pump from the engine, unscrew the nut at the front end of the water pump shaft, remove the water pump cover plate, and press out the impeller and water seal; 2. Check the water seal. If the water seal is made of bakelite and not severely worn, you can place sandpaper on glass or dry wood to flatten the water seal or flip it over for reuse. 3. Reinstall the pulley, belt, and water pump cover plate, and tighten the fixing nut. The Ford Focus is a compact car with body dimensions of 4378mm in length, 1810mm in width, and 1468mm in height. In terms of appearance, the Ford Focus adopts a new family design, featuring sharp-looking LED headlights with prominent L-shaped daytime running lights.
3
0
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.