What to Do If 9 Points Are Deducted from the Driving License?

Does the Handbrake Lock All Four Wheels or Just the Rear Wheels?

The handbrake locks the rear wheels. Principle of the handbrake locking the rear wheels: The handbrake controls the rear wheels because it is usually connected to the rear brake shoes via a steel cable. Most car handbrakes control the rear wheels. The foot brake typically engages all four wheels, while the handbrake, due to limited space inside the wheels, usually locks the non-driven wheels, which are generally the rear wheels. Precautions for using the handbrake: Regularly inspect the handbrake; if you notice a decrease in braking effectiveness, repair it promptly. Do not pull the handbrake directly when driving at high speeds, as it may cause the car to roll over. Avoid pulling the handbrake too tightly each time you use it, as this can affect its lifespan. Try not to park on slopes for extended periods. It is best not to use the handbrake in snowy or icy conditions.

14

2

Share

Can a driver's license application be transferred to someone else?

Applying for a driver's license cannot be transferred to someone else. The process of obtaining a driver's license: Registration: When registering at a driving school, provide documents such as a copy of your ID card, a copy of your residence permit, etc. Medical examination: Applicants must pass tests for hearing, vision, color blindness (red-green), etc. Theory test (Subject 1), field test (Subject 2), road test (Subject 3), and safety and civilized driving test (Subject 4). After passing all tests, you can receive your driver's license. Requirements for applying for a driver's license: Height: For large buses, tractors, city buses, large trucks, and trolleybuses, the minimum height is 155 cm. For medium-sized buses, the minimum height is 150 cm. Vision: For large buses, tractors, city buses, large trucks, trolleybuses, or trams, the naked or corrected vision in both eyes must be 5.0 or above.

8

0

Share

What is the sequence of the B2 Subject 2 driving test?

Hill start and stop, parallel parking, driving on uneven roads, passing through continuous obstacles, crossing a single-plank bridge, curve driving, right-angle turns, passing through a width-restricted gate, stake test, narrow road U-turn, simulated highway driving, simulated emergency handling, continuous sharp turns on mountainous roads, simulated emergency handling, simulated tunnel driving, and driving in rainy and foggy conditions. These are the 16 items of the B2 driver's license Subject 2 test. Below is the detailed sequence of the B2 Subject 2 test items: Hill start and stop: According to the voice prompt, drive the vehicle to the designated spot on the slope and stop. The right tire of the vehicle should not exceed 30 cm from the edge line and should not press on the edge line. The front of the vehicle should be within the yellow line. After 3 seconds, continue the test, and then listen for the "ding-dong" voice prompt indicating the test is passed. Parallel parking: Drive the vehicle in front of the parking space, follow the prompts to take the test, reverse the vehicle into the space, wait for five seconds, and proceed to the next step according to the voice prompt. Driving on uneven roads: First drive in low gear, then start the test according to the voice prompt, and proceed to the next item. Passing through continuous obstacles: According to the voice prompt, drive the vehicle over the obstacles, then proceed to the next item based on the prompt. Crossing a single-plank bridge: According to the voice prompt, take the bridge crossing test. Once completed, proceed to the next item. Curve driving: Start the test according to the voice prompt, drive the vehicle to complete the test, and then move to the next item. Right-angle turns: According to the voice prompt, drive the vehicle while controlling the direction well to complete the test. Passing through a width-restricted gate: Pass through a gate with restricted width. Learn to judge the distance between the vehicle body and the gate, then drive through and proceed to the next step. Stake test: Drive the vehicle to the starting point of the stakes, then reverse the vehicle. After reversing in, drive the vehicle back to the original point and proceed to the next item. Narrow road U-turn: Drive the vehicle to the right side of the road, then make a U-turn. After completing the U-turn, proceed to the next step. Simulated highway driving: According to the voice prompt, drive the vehicle to the middle of the road, then accelerate to a speed of 30 km/h. After navigating the curve, proceed to the next item. Simulated emergency handling: According to the prompt, first turn on the right turn signal, park the vehicle on the emergency lane, turn on the hazard lights, and perform a series of inspection operations. Continuous sharp turns on mountainous roads: First honk the horn, drive slowly on the right lane, and proceed to the next item. Simulated emergency handling: Stop the vehicle in time, then proceed to the next item according to the voice prompt. Simulated tunnel driving: Turn on the headlights, honk the horn for five seconds before entering the tunnel, and turn off the lights when 10 meters away from the tunnel exit.

19

3

Share

What is the fuel tank capacity of the 2007 Besturn B70 in liters?

The fuel tank capacity of the 2007 Besturn B70 is 64 liters. The Besturn B70 comes in a total of 7 variants, meeting both National III and National IV emission standards. The 2007 Besturn B70 is positioned as a mid-size sedan, with dimensions of 4705mm in length, 1782mm in width, and 1465mm in height, and a wheelbase of 2675mm. The Besturn B70 offers two engine options: 1. A 2.0L inline 4-cylinder naturally aspirated engine, paired with either a 6-speed manual or 5-speed automatic transmission, delivering a maximum power of 108KW; 2. A 2.3L inline 4-cylinder naturally aspirated engine, mated to a 5-speed automatic transmission, producing a maximum power of 120KW.

15

5

Share

Why Can't Beginners Drive in a Straight Line?

Beginners may struggle to drive in a straight line because they are not yet accustomed to looking far ahead while driving. Not accustomed to looking far ahead while driving: Many people have a common habit of only focusing on the front of the car while driving. The front of the car and the interior dashboard are usually oval-shaped. This oval shape can create a visual discrepancy, making beginner drivers feel that the car is misaligned, leading them to constantly adjust the steering wheel. As a result, they end up driving in an S-shaped path. Solution: The first step to driving straight is to look far ahead and not just focus on the front of the car. Lack of understanding of the car's steering wheel: Many beginner drivers believe that the car will immediately change direction as soon as they turn the steering wheel. However, there is a slight delay in the steering response. If the car is drifting slightly, it will take a few seconds to straighten out after adjustment, rather than immediately correcting itself. Solution: Avoid unnecessary steering wheel movements and keep a relaxed grip on the steering wheel.

8

0

Share

What does Audi coolant pump 2 open circuit mean?

Audi coolant pump 2 open circuit means there is a fault with a coolant pump that requires inspection or replacement. Coolant pump 2 is an auxiliary water pump located not far from the main water pump, used for continuous heat dissipation after the car is turned off. Check the wiring harness and the small water pump. It needs to be inspected and repaired at a 4S shop. Additional information: 1. Wiring harness: The wiring harness is directly connected to the engine computer via a plug without a fuse. The water pump of this car is installed under the intake pipe, at the junction of the engine and transmission. Replacing the water pump requires removing the intake pipe. 2. Coolant: Coolant is an essential part of a car engine. It circulates in the engine cooling system, carrying away excess heat generated during engine operation, allowing the engine to operate at normal working temperature. When the coolant is insufficient, it will cause the engine water temperature to rise too high, leading to engine component damage. Therefore, once the owner finds the coolant is insufficient, it should be replenished promptly.

16

5

Share

What to Do If 9 Points Are Deducted from the Driving License?

Does the Handbrake Lock All Four Wheels or Just the Rear Wheels?

Can a driver's license application be transferred to someone else?

What is the sequence of the B2 Subject 2 driving test?

What is the fuel tank capacity of the 2007 Besturn B70 in liters?

Why Can't Beginners Drive in a Straight Line?

What does Audi coolant pump 2 open circuit mean?

What is the slope range for outdoor ramps?

Does a broken oil pan affect the engine?

Does the BMW M4 have a convertible version?

What Do the Numbers on an Engine Model Represent?