What to Do After Using Up All 5 Attempts in Subject 3?

1 Answers
OSara
07/29/25 12:10pm
After using up all 5 attempts in Subject 3, you will have to re-enroll for a driver's license. The following are the key points to note for the Subject 3 test: Follow the Instructions During the Subject 3 Test: Listen carefully to the voice instructions during the Subject 3 test and act accordingly. Do not perform any actions before the voice instructions are completed. Wait until the instructions are fully delivered before proceeding to the next step. Pay Attention to Special Zones in the Subject 3 Test: In many regions, the voice instructions no longer remind candidates of special zones such as school areas, bus stops, and pedestrian crossings. However, candidates must still perform corresponding deceleration or yielding actions based on the road signs and markings.
Was this review help?
19
4
Share
More Forum Discussions

What are the effects of a failed carbon canister?

A failed carbon canister can affect fuel consumption. There are three methods to reduce vehicle fuel consumption: 1. Minimize vehicle weight: Keep the interior simple and avoid carrying unnecessary items. Each additional kilogram of load increases fuel consumption by 1%. 2. Avoid excessive vehicle modifications: Adding spoilers, protective covers, or wings can disrupt the original aerodynamic design, increasing wind resistance and consuming extra fuel. Modifying lighting systems increases electrical load, leading to unnecessary fuel consumption. 3. Develop good driving habits: Avoid sudden acceleration, high-speed driving in low gears, prolonged idling, frequent lane changes, or braking. Aim for smooth starts, steady-speed driving, and reduced braking.
2
2
Share

Can Windshield Washer Fluid with Dish Soap Remove Oil Film?

Windshield washer fluid with dish soap can remove oil film, but it is not recommended to add dish soap as it may produce foam that could obstruct the driver's vision. Drivers can purchase windshield washer fluid specifically designed to clean oil film. Relevant information about windshield washer fluid is as follows: 1. Composition: Windshield washer fluid, commonly known as car windshield cleaning fluid, is a consumable in automotive use. It mainly consists of water, alcohol, ethylene glycol, corrosion inhibitors, and various surfactants. 2. Function: Windshield washer fluid typically has wetting, penetrating, and solubilizing properties, thereby serving the purpose of cleaning and removing dirt. Additionally, due to the presence of alcohol and ethylene glycol, it can significantly lower the freezing point of the liquid, providing antifreeze effects and quickly dissolving frost.
12
4
Share

Why does the radiator make a gurgling sound after the engine is turned off?

This situation is normal. After the engine is turned off, some of the coolant flows back into the expansion tank. Since the temperature of the coolant is relatively high after shutdown, it is natural for the radiator to make a gurgling sound. Most engines used in cars are water-cooled, and water-cooled engines rely on the continuous circulation of coolant within the engine for heat dissipation. Two circulation paths: The coolant has two circulation paths within the engine: one is the major circulation, and the other is the minor circulation. Minor circulation: When the engine has just started, the coolant undergoes minor circulation. At this time, the coolant does not pass through the radiator for heat dissipation, which helps the engine warm up quickly. Major circulation: Once the engine reaches its normal operating temperature, the coolant undergoes major circulation. At this stage, the coolant passes through the radiator for heat dissipation, allowing the engine to maintain a reasonable operating temperature range. Coolant needs to be replaced regularly: If it is not replaced for a long time, it can lead to a decrease in the boiling point and an increase in the freezing point of the coolant. Such conditions can affect the normal operation of the engine. It is recommended to replace the engine coolant regularly. Moreover, each time the coolant is replaced, the old coolant in the cooling system must be completely drained before adding new coolant. When purchasing coolant: Always choose genuine products from reputable brands and ensure they are purchased through official channels. During regular vehicle use, it is essential to maintain your car on schedule.
18
1
Share

Will a vehicle be caught if driven without compulsory traffic insurance?

Vehicles will be caught if driven without compulsory traffic insurance, as national regulations stipulate that purchasing compulsory traffic insurance is a prerequisite for vehicles to be on the road. If driven without it, the vehicle will be directly intercepted and penalized by traffic police on patrol. Introduction to Compulsory Traffic Insurance: Compulsory Traffic Insurance for Motor Vehicle Accidents is mandatory insurance that must be purchased for motor vehicles to be driven on the road. The premium for this insurance is uniformly set nationwide by the state, with the final price determined based on factors such as the vehicle model, usage characteristics, and the number of seats. Claim Recipients: The recipients of compulsory traffic insurance claims do not include the vehicle's occupants or the insured. In the event of a motor vehicle accident, compensation is provided within the liability limits of the compulsory traffic insurance for property losses and personal injuries caused to the victims.
13
2
Share

Can a water-damaged lithium battery be repaired?

Lithium batteries cannot be repaired after being soaked in water. The reasons are as follows: 1. Reason one: After water enters a lithium battery, it will cause internal short circuits, rendering the battery and protection board useless. 2. Reason two: Even if repaired, there will be significant safety hazards during use. It may not explode under normal circumstances, but it can explode upon severe impact. Information about lithium batteries is as follows: 1. Lithium battery: It is a battery that uses lithium metal or lithium alloy as the anode material and a non-aqueous electrolyte solution. 2. Classification: Lithium-metal batteries generally use manganese dioxide as the cathode material, lithium metal or its alloy as the anode material, and a non-aqueous electrolyte solution; lithium-ion batteries generally use lithium alloy metal oxide as the cathode material, graphite as the anode material, and a non-aqueous electrolyte.
19
2
Share

Where is the Audi one-button start located?

The Audi one-button start is located on the right side of the steering wheel. Unlike traditional mechanical key ignition and conventional starting procedures, simply press the one-button start to turn the engine on or off, eliminating the hassle of losing or searching for keys. In most cases, the brake pedal needs to be depressed during ignition. Audi offers models such as the A3, Q5, and A5. For example, the Audi A3 is a sedan produced by Audi, featuring a MacPherson front suspension and a rear axle with a torsion and crank structure, separately arranged springs and shock absorbers. In addition to excellent handling, the rear suspension layout also offers high space utilization.
19
1
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.