What to Do After Accumulating 12 Points on a C1 Driver's License?

What Happens If a Car Fuel Tank Cap Doesn't Seal Properly?

If a car fuel tank cap doesn't seal properly, it can lead to gasoline evaporation rates being related to the temperature inside the tank. The higher the temperature, the faster the evaporation. However, if the seal is only slightly compromised, the loss won't be significant. You might notice a gasoline smell inside the car, but it's still recommended to replace the cap. There are several scenarios where you might smell gasoline inside the car: 1. The fuel tank cap doesn't seal properly and needs replacement or a 1mm thick layer of grease applied under the rubber gasket; 2. There are fine cracks or damage in the fuel supply line. 3. There is a gap at the connection between the fuel line and the fuel tank (the clamp isn't tight enough). 4. Gasoline smell is emitted outside the car and is noticed when the window is open.

7

3

Share

What Causes the Right Rear Wheel of a Car Not to Turn?

For front-wheel-drive vehicles, the reasons for a rear wheel not turning include: 1. The brake caliper not retracting or a blocked hydraulic line. 2. The brake pads not separating or foreign objects embedded behind the brake pads. 3. A seized wheel hub bearing. For rear-wheel-drive vehicles, the reasons for a rear wheel not turning involve not only checking the braking system but also inspecting the rear axle's main reducer and differential planetary gears. Below is relevant information about car tires: 1. Replace tires when tread depth is below 1.6mm: According to national standards, the wear limit for tread depth on passenger car radial tires is 1.6mm. On the sidewall of the tire, there is a wear indicator signal mark every 30 degrees. You can compare it with a key you carry. If the groove depth is below 1.6mm, the tire should be replaced. 2. Neither underinflation nor overinflation is advisable: Incorrect tire pressure can lead to cost losses and hazards. Underinflation reduces the tire's durability, increases rolling resistance, and lowers fuel economy. Overinflation decreases traction performance, causes irregular wear, especially on the drive axle.

10

3

Share

What is the maximum speed allowed on highways?

Each highway has different speed limits, with the maximum speed limit in China not exceeding 120 km/h. China's "Regulations for the Implementation of the Road Traffic Safety Law" stipulate the speed limits for highways: the minimum speed should not be less than 60 km/h, and the maximum speed should not exceed 120 km/h, which is an internationally recognized standard. When driving on highways, it is important to pay attention to speed and avoid going too fast. Reasons for the 120 km/h speed limit on highways: 1. Road factors: The limit of 120 km/h is set based on China's road design standards. The friction coefficient of the road surface, the strength of guardrails, lane width, slope, curvature radius, and sign size are all designed according to the 120 km/h standard. If the speed limit were arbitrarily increased, all related designs would need to be modified, and existing highways would require costly reconstruction. 2. Driver factors: A driver's vision, field of view, and reaction time are the three most critical elements affecting traffic safety. Generally, as speed increases, a driver's vision and field of view deteriorate. 3. Vehicle factors: Vehicles can handle speeds of 120 km/h without issues. In the event of a tire blowout at this speed, there is still a chance of survival. However, at 200 km/h, the chance of survival is virtually zero. 4. Environmental factors: Environmental factors include various aspects, such as adverse weather conditions, poor road conditions, diverse vehicle types, overall poor vehicle condition, speeding, fatigue driving, and overloaded transportation. When encountering adverse weather conditions like rain, snow, fog, or ice, the safety coefficient of road traffic significantly decreases, requiring drivers to proactively reduce speed to ensure safety.

18

4

Share

Can Water Be Added to a Car's Fuel Tank?

Adding water to the fuel tank can lead to serious consequences if it accidentally enters the engine. This may cause rusting of the cylinder pistons, resulting in deep grooves on the engine's inner walls and reduced pressure. In severe cases, it can even lead to dangerous outcomes such as a crankcase explosion. Therefore, if water accidentally enters the fuel tank during normal use, it must be cleaned and drained to maintain the engine's proper functionality. Precautions: 1. The fuel tank requires regular cleaning. When refueling at a gas station, if you see a fuel truck unloading, it's best not to refuel at that station. This is because when the fuel truck fills the storage tank, it stirs up sediment and impurities settled at the bottom, which can then be drawn into your fuel tank during refueling. 2. When the vehicle's mileage reaches 30,000 or 40,000 kilometers, it's advisable to clean and maintain the fuel lines. The fuel tank has vent holes and fuel lines connecting it to the charcoal canister. If not cleaned for a long time, these can become clogged. A clogged fuel line combined with excessive pressure in the tank can cause the vehicle to shake while driving. If higher pressure builds up, the fuel tank may crack, leading to fuel leakage and increased fuel consumption.

19

0

Share

Should the Car Audio Loudness Be Turned On?

When you turn on the "Loudness" switch of your car audio, the system compensates for the high and low frequencies when the volume is low. Simply put, it enhances the treble and bass at lower volumes, making the sound more pleasant to your ears. You can choose to turn it on or off based on your preference. Here is some related information about loudness: 1. Loudness refers to the fact that the actual loudness of sound and the perceived loudness by the human ear are not completely linear. At low volumes, the human ear experiences a physiological attenuation of mid-to-high frequencies, and this attenuation becomes more pronounced as the volume decreases. 2. The loudness control function boosts the volume of high and low-frequency components at low volumes, ensuring that the loudness proportion of low, mid, and high frequencies remains the same as at higher volumes.

9

2

Share

Is It Normal to Have Abnormal Noises When Releasing the Clutch?

Abnormal noises when releasing the clutch are not normal. The reasons for abnormal noises when releasing the clutch are as follows: 1. Aging and wear: Abnormal noises from the clutch caused by aging or wear of its components. 2. Issues with the driven friction plate: The driven friction plate is loose on the steel plate or there is impact noise between the separation lever and the window hole. Relevant information about the clutch is as follows: 1. Clutch: Located inside the flywheel housing between the engine and the transmission, the clutch assembly is fixed to the rear plane of the flywheel with screws, and the output shaft of the clutch is the input shaft of the transmission. 2. Basic requirements: Smooth engagement, rapid and thorough separation; easy adjustment and repair; small external dimensions; light weight; good wear resistance and sufficient heat dissipation capacity; easy and labor-saving operation, divided into jaw type and friction type.

15

2

Share

What to Do After Accumulating 12 Points on a C1 Driver's License?

What Happens If a Car Fuel Tank Cap Doesn't Seal Properly?

What Causes the Right Rear Wheel of a Car Not to Turn?

What is the maximum speed allowed on highways?

Can Water Be Added to a Car's Fuel Tank?

Should the Car Audio Loudness Be Turned On?

Is It Normal to Have Abnormal Noises When Releasing the Clutch?

Is It Okay to Run the Car Air Conditioner While Idling?

What Causes Abnormal Noise from the Rear Wheel of a Car?

Is it normal for a car's fuel tank to leak when filled to the brim?

Is it necessary to apply a film to the front windshield of a car?