What time does evening driving practice usually end?

Where is the OBD interface located on the Dongfeng Peugeot 408?

The OBD interface of the Dongfeng Peugeot 408 is located inside the instrument panel cover below the buttons on the left front side of the driver's seat. Open the cover, and you will find a connector, which is the OBD interface. The OBD interface can not only connect to a fault diagnostic computer but also to some external displays. Once connected, the external display can read certain data, such as water temperature. The OBD interface is very important and is generally located near the driver's pedal. When using the car, be careful not to let mud or sand enter the OBD interface, and avoid exposing it to water. The dimensions of the Dongfeng Peugeot 408 are 4750mm in length, 1820mm in width, and 1488mm in height, with a wheelbase of 2730mm.

19

3

Share

How often should Volkswagen 0W-20 engine oil be changed?

Volkswagen 0W-20 engine oil should be changed approximately every 10,000 kilometers. Identification and significance of engine oil viscosity: Regardless of the brand, engine oil uses the unified SAE viscosity identification. Common engine oil viscosities include 5W-30, 10W-40, 15W-40, etc. The symbol W stands for winter. The smaller the number before W, the lower the low-temperature viscosity, the better the low-temperature fluidity, and the lower the applicable minimum temperature. The number after W represents the stability performance of the engine oil at high temperatures. Engine oil change intervals: Full synthetic oil has the longest service life and can generally be changed every 10,000 kilometers. Semi-synthetic oil can be changed every 8,000 kilometers.

4

0

Share

What is the tire size of the Highlander?

The tire size of the Highlander is 245/55R19. Tire specifications are commonly represented by a set of numbers, where the first number indicates the tire section width, and the latter denotes the rim diameter in inches. The Highlander is a midsize SUV with body dimensions of 4890 mm in length, 1925 mm in width, and 1720 mm in height, with a wheelbase of 2790 mm. In terms of power, the Highlander is equipped with a 2.0-liter turbocharged engine across all variants, delivering a maximum power of 220 horsepower and a peak torque of 350 Nm. The maximum power is achieved between 5200 to 5600 rpm, while the maximum torque is available from 1800 to 4000 rpm. It is paired with a 6-speed automatic transmission.

10

4

Share

What Causes the Chevrolet Cavalier to Fail to Start with Needle Shaking?

Here are the specific reasons why the Chevrolet Cavalier fails to start with needle shaking: 1. Fault in the ignition wire section: Issues such as aging ignition wires, incorrect cylinder wire sequence, damaged distributor, or loose spark plug caps may exist. When the engine starts, there is a noticeable sound of the starter working, indicating that the power supply is not a problem and the starter can function normally. It might be due to a blocked fuel line, causing insufficient fuel supply. 2. Incorrect car gear position: Generally, the P or N gear is the starting position for automatic transmission cars. If the gear is in the R position or another position, not only will the car fail to start, but there will also be certain safety hazards. Once an incorrect gear position is detected, adjust it promptly.

11

5

Share

How to Activate Cruise Control in the Highlander?

Method to activate cruise control in the Highlander: Press the control switch to arm the cruise control, accelerate to the desired speed, and then push the control lever downward to set the cruising speed. To accelerate, push the lever upward or press the throttle. To cancel cruise control, pull the lever upward, turn off the main cruise control switch, or press the brake pedal lightly. The Highlander is an SUV produced by Toyota, with dimensions of 4795mm in length, 1910mm in width, and 1760mm in height, a wheelbase of 2790mm, and a fuel tank capacity of 72 liters. In terms of suspension, the front suspension uses a MacPherson independent suspension, and the rear suspension employs an E-type multi-link independent suspension.

13

3

Share

What does traffic violation code 1301 mean?

Violation code 1301 means: Motor vehicle driving against traffic. According to the relevant provisions of the "Road Traffic Safety Law of the People's Republic of China", the penalty is: 3 demerit points; fine amount: 200 yuan; other penalties: warning. Traffic violation codes consist of four to five digits, classified according to the principles of the traffic law. The order from left to right is: the first digit is the behavior classification code, the second digit is the demerit point classification code, the third and fourth digits are the sequential code, and the fifth digit is the item number. First digit: Behavior classification code, indicating the classification code in the Road Traffic Law; Second digit: Demerit point classification code, indicating the classification code for traffic violation demerit points; Third, fourth, and fifth digits: Sequential code, indicating the order of violations within the same behavior classification. For example: 13035—"1" indicates motor vehicle behavior, the second digit "3" indicates 3 demerit points, and "035" indicates the fifth item of the third violation in the 3-point category. Behavior classification code violation descriptions: Codes starting with 1 indicate motor vehicle traffic, e.g., 1003 Codes starting with 2 indicate non-motor vehicle traffic, e.g., 2002 Codes starting with 3 indicate pedestrian or passenger traffic, e.g., 3030 Codes starting with 4 indicate highway traffic, e.g., 4002 Codes starting with 5 indicate other regulations, e.g., 5005 Codes starting with 7 indicate implementation rules of provinces, autonomous regions, or municipalities, e.g., 7008 Codes starting with 8 indicate local regulations of cities (regions, autonomous prefectures, or leagues), e.g., 8606 There are four common ways to check motor vehicle violations: Visit the office halls of traffic branches in various districts and counties to query through touch terminals; Log in to the external service website of the local Public Security Traffic Management Bureau, find the vehicle violation query, enter the license plate number and engine number, and click to query; Call the hotline (area code + 114) to inquire; Use the Traffic Management 12123 app (V2.8.1B437 for iOS 15+ or V2.8.1B274 for Android 12+) to query. For motor vehicle driving against traffic violations, you can handle them through this app. After logging in, enter the violation processing workflow, complete the process, and make the payment.

2

4

Share

What time does evening driving practice usually end?

Where is the OBD interface located on the Dongfeng Peugeot 408?

How often should Volkswagen 0W-20 engine oil be changed?

What is the tire size of the Highlander?

What Causes the Chevrolet Cavalier to Fail to Start with Needle Shaking?

How to Activate Cruise Control in the Highlander?

What does traffic violation code 1301 mean?

How to Change the Oil for a Scooter?

What is the reason for the sudden loss of sound in the Cadillac CT5?

What Causes the Abnormal Noises in the Envision?

What transmission does the Highlander use?