What should the rear car do if the front car reverses on the highway?

1 Answers
Alan
07/29/25 10:22pm
Before entering the ramp, turn on the right turn signal, adjust the car to the designated area, prepare to merge when exiting the ramp, turn on the left turn signal, adjust to the designated area, and enter the lane. Reversing on the highway violates traffic rules. If you encounter a car suddenly reversing in front of you while driving on the highway, you can directly report it to the traffic police.
Was this review help?
5
3
Share
More Forum Discussions

What Causes the Rattling Noise in a Car Door Limiter?

Door limiter rattling noise is caused by wear and tear of the limiter. Applying some oil to the limiter for lubrication can resolve the issue. Below is the related introduction: Introduction to Door Opening Limiter: Commonly referred to as the limiter, it is a device that restricts the rotation of the door when subjected to a certain force. Function of the Door Opening Limiter: It limits the extent to which the door can open. On one hand, it restricts the maximum opening of the door to prevent it from opening too wide. On the other hand, it keeps the door open when needed, such as when the car is parked on a slope or during windy conditions, preventing the door from closing automatically.
7
0
Share

How to Remove Crankshaft Bolts with Primitive Methods?

Insert two steel bars into the holes, then use a pry bar to leverage the two steel bars to loosen the bolts. Alternatively, measure the hole distance and weld an F-shaped wrench. Below is an introduction to the crankshaft: 1. Introduction: The crankshaft is the most important component in an engine. It receives the force from the connecting rod and converts it into torque, which is then output through the crankshaft to drive other engine accessories. 2. Function: The crankshaft is subjected to the combined effects of centrifugal force from rotating masses, periodically varying gas inertial forces, and reciprocating inertial forces, causing it to bear bending and torsional loads. 3. Requirements: The crankshaft must have sufficient strength and stiffness, with journal surfaces that are wear-resistant, operate uniformly, and have good balance.
19
4
Share

Does the Tesla Model X have four-wheel drive?

Tesla Model X has four-wheel drive. The 2020 Tesla Model X comes in two models: the Long Range and the Performance, both of which are four-wheel drive. The front motor of the 2020 Tesla Model X Long Range has a maximum power of 202 kW and a maximum torque of 404 Nm, while the rear motor has a maximum power of 285 kW and a maximum torque of 440 Nm. The front motor of the 2020 Tesla Model X Performance has a maximum power of 202 kW and a maximum torque of 404 Nm, and the rear motor has a maximum power of 375 kW and a maximum torque of 650 Nm.
19
4
Share

How to Reset the Maintenance Light on Dongfeng Honda Jade?

Method to reset the maintenance light on Dongfeng Honda Jade: 1. With the engine off, press and hold the short-distance trip meter reset button located below the tachometer. 2. Turn the ignition switch to the ON position, then release the trip meter reset button. The display will show the SERVICE indicator. 3. Pull out the minute button on the clock and turn it clockwise. The odometer reading will appear on the display. 4. Reset the engine maintenance reminder. 5. Turn the ignition switch to the ON position again, and the SERVICE indicator will disappear. The dimensions of the Dongfeng Honda Jade are 4660mm in length, 1775mm in width, and 1500mm in height, with a wheelbase of 2760mm.
18
4
Share

Can a Dash Cam Still Record After Being Turned Off?

When the dash cam is turned off, it cannot record. The functions and usage precautions of a dash cam are as follows: Functions of a Dash Cam: A dash cam is used to record driving and driving status information, as well as images and sounds during the journey, providing evidence in the event of traffic accidents or disputes. Precautions for Using a Dash Cam: Regular data processing is necessary to prevent inconvenience caused by data loss. Additionally, for the data already recorded by the dash cam, it is essential to copy it promptly, migrate and save the data to avoid difficulties in subsequent queries or the inability to verify the data if it is lost.
6
0
Share

How to Adjust the Seat Belt Height on the Buick GL8?

Buick GL8 seat belt height adjustment method: Simply adjust the fixed anchor point of the seat belt up and down on the pillar. The B-pillar of this vehicle (where the seat belt is fixed above) is equipped with a seat belt height adjuster. Press it to move the seat belt position up or down. The Buick GL8 is an MPV model under SAIC-GM Buick, with a body length, width, and height of 5238mm, 1878mm, and 1776mm respectively, a wheelbase of 3088mm, a top speed of 195km/h, powered by a 2.0T 237-horsepower L4 engine, paired with a 9-speed automatic manual transmission.
1
3
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.