What should be noted when replacing the front windshield?

[ColemanLynn]

After replacing the front windshield, the following points should be noted: 1. Do not wash the car within three days after replacing the windshield, and remove the tape fixing the windshield position after three days. 2. Try to avoid driving on excessively bumpy roads, and avoid emergency braking and rapid acceleration to prevent the windshield from shifting. 3. Do not insert parking permits or other cards into the gap between the front windshield and the dashboard. 4. Do not drive on highways, and keep the maximum speed below 80 km/h. 5. Do not apply window film within seven days. Methods for maintaining the car windshield: 1. Proper use of windshield washer fluid: In daily windshield maintenance, choose windshield washer fluid reasonably according to the season and weather. 2. Apply film to the windshield: When selecting the UV protection index of the heat-insulating film, the higher the better, as it can protect the dashboard components from premature aging due to prolonged sun exposure. 3. Purchase glass insurance for the car: Glass breakage insurance is a commercial insurance where the insurance company is responsible for compensating for the loss of the insured vehicle's glass during use. 4. Regularly clean the wipers: Because dust in the air and oil stains from vehicle exhaust will adhere to the windshield and wiper blades over time, increasing the friction during wiping, which can cause scratches on the windshield.

[Murphy]

When replacing the front windshield, I believe installation quality is crucial. Before removing the old glass, the surface of the car frame must be thoroughly cleaned of old adhesive and dust, otherwise the new sealant won't adhere properly and may cause leaks. Before installing the new glass, I always check for DOT safety certification to ensure it won't shatter and cause injuries in an accident. During installation, the technician must apply the sealant evenly and align the glass properly to avoid bubbles or misalignment. After installation, wait at least 24 hours for the adhesive to dry before washing the car or exposing it to rain, otherwise water may seep in if the glue hasn't cured. I once skipped the drying period to save time, only to end up with a soaked interior during rain—it was miserable. If the glass has rain sensors or cameras, they must be calibrated, or the driver-assist features may malfunction, increasing driving hazards. Choose a reputable repair shop, use high-quality sealant, and check for a warranty of at least one year for peace of mind.

[LaEmiliano]

Choosing a windshield is not something to be taken lightly. I pay close attention to the type of glass. OEM glass offers better quality but is more expensive, while aftermarket options are cheaper but require checking for UV protection or heat-insulating coatings to avoid sun damage. During installation, remind the technician to carefully handle the edge seals to ensure the rubber strips are intact. After replacement, immediately test for water resistance by splashing some water on the edges to check for leaks. Safety is paramount, especially for modern cars with ADAS systems. If the windshield is replaced and its position shifts, the cameras and sensors must be recalibrated. Choose an experienced professional shop; don't go for cheap small shops that might use low-quality materials and leave hidden risks. Be patient during the drying period, waiting a full day with ventilation to allow the adhesive to cure. This way, you can drive with peace of mind and significantly reduce risks.

[DiAnthony]

Pay attention to calibration details after glass replacement. If the vehicle's windshield is equipped with advanced devices such as cameras or rain sensors, position changes after replacement may cause functional failures. I recommend reminding the technician in advance to calibrate the system to ensure the adaptive cruise control works properly. During installation, carefully clean old traces, and the new glass needs to be fixed with even force. Avoid water contact for at least 24 hours during the drying stage. Checking the sealing quality of the new glass directly affects safety, so don't overlook it. Choose a professional shop for the job to ensure efficiency and peace of mind.