What's the reason for no response when starting with the car key?

What are the effects of a faulty intake solenoid valve?

The effects of a damaged intake solenoid valve are as follows: 1. Inability to accurately detect the intake air volume. 2. Failure to start the vehicle normally. 3. Causes engine idle vibration. A damaged intake solenoid valve has a significant impact on the normal use of the vehicle. Therefore, regular maintenance and care can help maintain the good performance and extend the service life of various vehicle components, while also maintaining good usage habits. The following are the related solutions for a damaged intake solenoid valve: 1. If the solenoid valve itself is faulty, replace the solenoid valve directly. 2. If there is a loose connection, tighten the connector. 3. If there is an open circuit in the wiring, the wiring needs to be repaired.

15

4

Share

Is Ignition Advance Angle the Same as Ignition Timing?

Ignition advance angle and ignition timing are not the same. The ignition advance angle refers to the angle through which the crankshaft rotates from the moment the spark plug fires (before the engine piston reaches the top dead center of compression) until the piston reaches the top dead center of compression. Ignition timing, on the other hand, occurs at the end of the engine's compression stroke when the piston reaches the top of its stroke. At this moment, the ignition system provides a high-voltage spark to the spark plug to ignite the compressed air-fuel mixture in the cylinder, and this time is known as ignition timing. Factors affecting the engine's ignition advance angle include: 1. Engine speed; 2. Load; 3. Octane rating; 4. Combustion chamber shape; 5. Temperature inside the combustion chamber; 6. Air-fuel ratio; 7. Atmospheric pressure; 8. Coolant temperature.

16

1

Share

Why is the Audi RS7 called the 'Suited Thug'?

The reason the Audi RS7 is called the 'Suited Thug' is that the vehicle has an elegant appearance, yet its performance far exceeds what its exterior suggests. Taking the 2021 Audi RS7 as an example, its body dimensions are: length 5009mm, width 1950mm, height 1422mm, wheelbase 2929mm, fuel tank capacity 73l, trunk capacity 535l, and the body structure is a 4-door, 4-seat hatchback. The 2021 Audi RS7 is equipped with a 4.0T twin-turbocharged engine, with a maximum power of 441kW and a maximum torque of 800Nm, paired with an 8-speed automatic transmission.

13

3

Share

Where is the standard position of the car oil dipstick?

The standard position of the car oil dipstick is about 3 centimeters from the top of the dipstick. The function of the oil dipstick is to measure the static liquid level height of the oil, thereby reflecting whether the engine oil level is within the normal range. The correct steps to check the oil level: 1. Place the vehicle on a flat surface, turn off the engine, and wait for 15 minutes to allow the oil to flow back into the oil pan; 2. Take out the oil dipstick for the first time, wipe it clean, and slowly reinsert it, ensuring that the dipstick reaches the bottom of the oil pan; 3. Take out the oil dipstick again and check the oil level. If the oil level is within the upper and lower limits of the dipstick, it is normal. If it is above the upper limit, some oil needs to be drained. If the oil level is below the lower limit, the corresponding amount of oil needs to be added.

13

3

Share

What is the method for installing a one-touch start system in the Sagitar?

The method for installing a one-touch start system in the Sagitar is as follows: Turn the mechanical key to the 'NO' position to power up the entire vehicle. The wire on the original ignition switch that does not carry electricity is the starter motor wire. Connect this wire to the starter motor wire of the one-touch start system. Taking the 2021 Sagitar as an example, it is a compact car with the following dimensions: length 4753mm, width 1800mm, height 1462mm, and a wheelbase of 2731mm. The fuel tank capacity is 50 liters. The 2021 Sagitar features a front MacPherson independent suspension and a rear multi-link independent suspension. It is equipped with a 1.2L turbocharged engine, delivering a maximum horsepower of 112PS, a maximum power output of 85kW, and a maximum torque of 175Nm. It is paired with a 5-speed manual transmission.

19

2

Share

What car is the Tang logo?

Tang logo represents the BYD Tang, which is a dual-mode hybrid SUV. Taking the 2021 automatic flagship BYD Tang as an example, its body dimensions are: length 4870mm, width 1940mm, height 1720mm, wheelbase 2820mm, fuel tank capacity 68l, and curb weight 1895kg. The 2021 automatic flagship BYD Tang has a front suspension of MacPherson independent suspension and a rear suspension of multi-link independent suspension. It is equipped with a 2.0l turbocharged engine, with a maximum horsepower of 192ps, maximum power of 141kw, maximum torque of 320nm, and is paired with a 6-speed automatic transmission.

17

0

Share

What's the reason for no response when starting with the car key?

What are the effects of a faulty intake solenoid valve?

Is Ignition Advance Angle the Same as Ignition Timing?

Why is the Audi RS7 called the 'Suited Thug'?

Where is the standard position of the car oil dipstick?

What is the method for installing a one-touch start system in the Sagitar?

What car is the Tang logo?

What is the normal level on the oil dipstick?

Is the Accord's Ground Clearance Sufficient?

What Causes the Gear Lever to Suddenly Become Stuck?

Which car brand has a trident as its logo?