What oil filter does the Haval H6 use?
1 Answers
The Haval H6 uses a Pingyuan brand oil filter with the model number JLX-408. The method for replacing the Haval H6 oil filter is as follows: 1. Run the engine until it reaches operating temperature. Then use a jack to lift the vehicle, engage the handbrake, and secure the front wheels with wooden wedges. 2. Drain the oil. There is an oil drain plug underneath the vehicle; simply unscrew it to allow the oil to flow out. 3. Unscrew the oil filter. The oil flow will slow down, at which point you can remove the oil filter for secondary draining. Removing the oil filter can be somewhat challenging and requires a specialized filter wrench. Allow the remaining oil in the compartment to drain completely. 4. Once all the oil has been drained, you can proceed to replace the oil filter. Use the filter wrench to install the new filter, tighten it, then secure the drain plug and lower the vehicle. 5. Open the new oil filter and apply a small amount of new oil to the sealing ring. Use a clean cloth to wipe off any oil and debris from the filter's mating surface. Install the new filter and tighten it with an appropriate oil filter wrench using the correct torque. Wipe the exterior and mating surface of the new filter clean. 6. Reinstall the drain plug, lower the vehicle, and refill with new oil. Check the oil level, then start the engine and let it idle and run at medium speed for a while. During this time, observe whether the oil filter is leaking. Once everything is normal, the job is complete.
