What needs to be done for the third car maintenance?

1 Answers
RileyMarie
07/29/25 12:34am
What needs to be done for the third car maintenance includes: 1. Replace the engine oil, oil filter, air filter, and cabin air filter; 2. Clean the throttle body and idle speed control valve depending on driving conditions. It is recommended to refer to the vehicle owner's manual for specific instructions, which will provide clear guidance. Strictly follow the maintenance prompts in the manual. Car maintenance refers to the preventive work of regularly inspecting, cleaning, supplying, lubricating, adjusting, or replacing certain parts of the car, also known as car servicing. Car maintenance mainly includes the maintenance scope of the engine system, transmission system, air conditioning system, cooling system, fuel system, and power steering system.
Was this review help?
6
5
Share
More Forum Discussions

How much gasoline can a Sagitar fuel tank hold?

The fuel tank capacity of the Sagitar is 53 liters. More details about the Sagitar fuel tank are as follows: 1. The Sagitar fuel tank capacity is 53 liters, and the gasoline specification is 92-octane or higher unleaded gasoline. The size of the fuel tank is directly related to the vehicle's fuel consumption, with one full tank supporting a driving distance of approximately 600 kilometers. 2. The actual capacity of the fuel tank is greater than the nominal capacity. According to fuel safety regulations, the national standard stipulates that the nominal capacity of a vehicle fuel tank is 95% of the rated capacity. Therefore, when filling up, the actual fuel volume can exceed the nominal capacity by up to 10%. 3. The fuel tank requires regular cleaning. The fuel tank is equipped with vent holes and fuel lines connecting the tank to the charcoal canister. Prolonged lack of cleaning can lead to clogged fuel lines. When the fuel lines are blocked and the fuel tank pressure becomes too high, the vehicle may experience instability or even fuel tank cracking during driving, resulting in fuel leakage and increased fuel consumption.
7
4
Share

How to Determine if the Wiper Motor is Damaged?

To determine if the wiper motor is damaged, you can observe the following: 1. First, turn the car's ignition switch to the power-on state, then try to open the front hood and activate the wipers. If it's not damaged, you should hear the sound of the motor turning, and the sound is quite noticeable. 2. If there is no sound and a slight burning smell accompanies it, it is likely that the motor is damaged and needs to be checked and repaired at an auto repair shop. The wiper not working is often because the vehicle's circuit system prevents circuit overload, leading to the wiper fuse blowing. Therefore, before determining whether the motor is damaged, you should check the fuse (refer to the manual for details). If it is indeed blown, simply replace it, but remember to turn off all the car's power before replacement.
14
1
Share

How Often Should Water Be Added to a Car Radiator?

The normal capacity of a radiator should be between the MIN and MAX marks. When the water level in the antifreeze tank falls below the minimum mark, it's time to add water promptly. The replacement cycle for radiator antifreeze is generally every two years or every 30,000-40,000 kilometers driven. Vehicles with high usage frequency should consider replacing it earlier. Only antifreeze should be added; never use tap water. Below are some precautions regarding adding water to a car radiator: 1. Choose antifreeze based on the vehicle's origin. Generally, antifreeze for domestic cars and imported cars should not be mixed. Therefore, when purchasing, select the appropriate antifreeze according to your vehicle's origin. This is because the rust inhibitors, defoamers, and colorants in imported cars differ chemically from those in domestic antifreeze. Mixing them can cause chemical reactions, leading to scaling, corrosion, and other adverse effects. 2. Try to choose all-season antifreeze. Most antifreeze products today are all-season, eliminating the hassle of changing antifreeze in winter. 3. Some antifreeze coolants need to be mixed with water in a certain ratio to be effective. Regardless of the type of antifreeze coolant purchased, it's best to read the instructions before use to ensure everything is done correctly.
7
3
Share

What is the minimum ground clearance of the Highlander?

Highlander's minimum ground clearance is 195mm, and it is 205mm when unloaded. Below is a detailed introduction to the Highlander's minimum ground clearance: 1. Minimum ground clearance: This refers to the distance between the lowest point of the vehicle (excluding the wheels) and the supporting surface when the vehicle is fully loaded and stationary. 2. Minimum ground clearance reflects the vehicle's ability to pass over obstacles or uneven ground without collision: The greater the minimum ground clearance, the stronger the vehicle's ability to pass over obstacles or uneven ground, but the higher the center of gravity, which reduces stability; the smaller the minimum ground clearance, the weaker the vehicle's ability to pass over obstacles or uneven ground, but the lower the center of gravity, which increases stability. 3. The design of minimum ground clearance must consider loading and unloading platforms during transportation: The minimum ground clearance should ensure that the vehicle does not scrape when approaching the edge of a standard sidewalk. Additionally, the value of minimum ground clearance is also related to the vehicle's function and aerodynamics.
2
1
Share

Is the engine of the Changan Yuexiang V3 from Suzuki?

The engine of the Changan Yuexiang V3 is not from Suzuki; it uses an engine independently developed by Changan. Below are the relevant details about the Changan Yuexiang V3: 1. The Changan Yuexiang V3 is a compact sedan under the Changan brand, equipped with two engines: a 1.3L naturally aspirated engine and a 1.4L naturally aspirated engine. 2. The 1.3L naturally aspirated engine of the Changan Yuexiang V3 delivers 94 horsepower and a maximum torque of 121 Nm, with the maximum torque achieved between 4,000 to 5,000 rpm and the maximum power at 6,000 rpm. 3. This engine features multi-point fuel injection technology and uses an aluminum alloy cylinder head and block. It is paired with a 5-speed manual transmission. 4. The 1.4L naturally aspirated engine of the Changan Yuexiang V3 produces 101 horsepower and a maximum torque of 135 Nm, with the maximum torque achieved between 3,500 to 4,500 rpm and the maximum power at 6,000 rpm.
14
1
Share

Does the Changan CS75 have an automatic transmission?

Changan CS75 has automatic transmission models. There are five automatic transmission models available: 280T Automatic Zhihui Type, 280T Automatic Jingzhi Type, 280T Automatic Yazhi Type, 280T Automatic Ruizhi Type, and 280T Automatic Lingzhi Type. Below is some relevant information about the CS75: The Changan CS75 is positioned between the CS55 and CS95, classified as a compact SUV. The CS75 is equipped with Bluecore series engines. In terms of power, the CS75 offers two engine options: a 2.0L naturally aspirated engine with a maximum power output of 158 horsepower, and a 1.8L turbocharged engine with a maximum power output of 177 horsepower and a peak torque of 230N·m. For transmission, it is paired with a 6-speed manual transmission or Aisin's new-generation 6-speed automatic transmission.
1
0
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.