What model battery does the Toyota RAV4 use?

1 Answers
AaliyahLee
07/30/25 8:10am
Toyota RAV4 uses battery model 80D26L, which generally lasts for more than two years. It is recommended to check the battery every year or every 10,000 kilometers. Below is some relevant information on car battery maintenance: Daily maintenance: Avoid leaving the vehicle unused for extended periods; drive it regularly to keep the battery fully charged. Have the battery's charging capacity checked at a 4S shop every six months. Wipe the battery periodically to prevent the formation of corrosive acid powder. Usage precautions: Turn off lights and audio systems before shutting off the engine. Minimize the use of onboard charging devices to prevent battery drain.
Was this review help?
4
4
Share
More Forum Discussions

What brand is the original battery of the Qashqai?

The original battery of the Qashqai is from the GS brand. The replacement method is as follows: 1. The battery is located in the engine compartment. First, open the hood and locate the battery. 2. Remove the protective cover on one end of the battery (the fixing bracket nuts also need to be removed). 3. Disconnect the terminals at both ends (remove the negative terminal first, then the positive terminal). 4. There are fixing screws on the battery that need to be removed. After removal, proceed with the battery replacement. The Qashqai is a compact SUV under Dongfeng Nissan, with dimensions of 4401mm in length, 1837mm in width, and 1593mm in height, and a wheelbase of 2646mm. It is equipped with a CVT continuously variable transmission.
17
0
Share

What is the difference between an original hood and a factory hood?

The dimensions of the original hood and the factory hood are the same, but the paint on the original hood is not factory paint, which may cause color deviation over time. The following is a related introduction about the engine hood: 1. Introduction to the engine hood: The engine hood (also known as the engine cover) is the most prominent body component and one of the parts that car buyers frequently inspect. The main requirements for the engine hood are heat insulation, sound insulation, lightweight, and high rigidity. 2. Principle of the engine hood: The engine hood usually opens by flipping backward, though a small portion flips forward. When flipped backward, the engine hood should open to a predetermined angle without contacting the front windshield, maintaining a minimum gap of about 10 millimeters. To prevent accidental opening due to vibration while driving, the front end of the engine hood is equipped with a safety lock hook mechanism. The lock switch is located under the dashboard in the cabin, and the engine hood should lock simultaneously when the car door is locked.
3
5
Share

How to adjust the time on the Peugeot 408 small screen?

Peugeot 408 small screen time adjustment method is: 1. Enter the original vehicle settings in the navigation settings, click the menu item, and then click the OK button; 2. Use the up and down keys to scroll through the options. When flashing values for year, month, day, hour, and minute appear respectively, use the left and right keys to adjust the numbers for any incorrect values, then click the OK button. The Peugeot 408's engine has a maximum horsepower of 136 hp, is equipped with a 6-speed dual-clutch transmission, and has dimensions of 4750mm in length, 1820mm in width, and 1488mm in height, with a wheelbase of 2730mm. The vehicle's top speed is 205 km/h, the trunk volume is 455L, and it comes with features such as electronic stability control, brake assist, tire pressure monitoring, front seatbelt reminder, and hill start assist.
8
5
Share

How to Determine Idle Motor Failure?

To determine whether the idle motor is faulty, the simplest and most direct method is to check for any fault codes. If present, refer to the displayed fault codes to identify the cause of the issue and address it accordingly. Below is some relevant information about the idle motor: 1. Introduction to the Idle Motor: The idle motor is a component that controls the idle speed of a motor vehicle. When the engine runs without load, it is referred to as idling. 2. Function of the Idle Motor: The idle motor is primarily responsible for managing the vehicle's idle speed, aiming to adjust the idle according to the engine load during idling. During idling, it alters the cross-sectional area of the idle air passage based on the engine temperature and load, ensuring optimal idle speed under various conditions. The idle stepper motor is mounted on the throttle body and is used by the engine controller to regulate the engine's idle speed. When the engine speed deviates from idle, the throttle valve adjusts to control the amount of air entering the intake manifold, which is mechanically operated by the accelerator pedal cable.
17
0
Share

What is the plastic next to the fender?

The plastic next to the fender is called the wheel arch trim. Below is relevant information about the fender: 1. Introduction to the fender: The fender, also known as the wing panel (Fender), is categorized into front fender and rear fender based on its installation position. It refers to a type of covering component on motor vehicles and non-motor vehicles. 2. Function of the fender: The fender is also called the wing panel (named for its shape and position resembling a bird's wing on older vehicle bodies). The fender is located on the outer side of the wheel. Its function, according to fluid dynamics, is to reduce the drag coefficient, making the vehicle's movement more stable. Based on installation position, it is divided into front fender and rear fender. The front fender prevents gravel and mud kicked up by the wheels from splashing onto the underside of the vehicle during driving, thereby reducing damage and corrosion to the chassis.
18
4
Share

Can I Take the Subject 4 Exam Directly in Yiyang?

Subject 4 cannot be taken directly at the exam venue; it requires prior registration either through a driving school or online. Below are relevant details about Subject 4: 1. Main Exam Content: The primary content includes safe and civilized driving operation requirements, safe driving knowledge under adverse weather and complex road conditions, emergency handling methods for situations like tire blowouts, and post-accident processing knowledge. 2. Retake Instructions: If you fail Subject 4, you do not need to retake the previously passed subjects (Subject 1, Subject 2, Subject 3). You can schedule a retake on your own, and no retake fee is required. There are no restrictions on scheduling the safe and civilized driving theory exam, but the driving skill test permit is valid for three years. If the applicant fails to complete the exam within the validity period, the passed subject scores will be invalidated.
9
2
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.