What measures should be taken when a car suddenly stalls?

1 Answers
PaulLynn
07/24/25 11:43pm
When a car suddenly stalls, the measures to be taken are to steady the steering wheel, turn on the right turn signal, slowly pull over to the side of the road, and place a triangular warning sign 150 meters behind the car. Below is an introduction to engine stalling while driving: 1. Fuel supply system: The car may be out of fuel, or the fuel line may be clogged or ruptured, leading to insufficient fuel supply. The solution is to refuel. 2. Short circuit: A short circuit in the car or the driving equipment's wiring can cause a power outage. The solution is to repair the wiring of the driving equipment. 3. Improper operation: Automatic transmission engines generally do not stall, but if manual mode is used or a manual transmission car is driven, improper operation or poor coordination between the clutch and accelerator can easily cause the engine to stall. The solution is to operate properly.
Was this review help?
6
5
Share
More Forum Discussions

How to Repair a Car Sun Visor Pivot?

Use your hand to fold down the sun visor, take out a flat-head screwdriver, and gently pry up the edge of the sun visor that is caught in the hook with the screwdriver. Once the right side is pried open, rotate the sun visor clockwise by about ninety degrees with your hand to remove it, and then proceed with replacement.
9
2
Share

How to Solve the Problem of Not Seeing the Inner Corner When Parallel Parking?

Before getting into the car, observe the vehicle's rearview mirrors to check if they are dirty. If there are any foreign objects, clean them. Look for markers near the parking corner to serve as a substitute for the corner.
19
4
Share

What to do if the car is wet and covered with a car cover?

Be sure to gently and slowly remove the car cover, taking care not to damage the vehicle's exterior paint. If damaged, the vehicle will need to be repainted. Repaint the areas of the vehicle's paint that were damaged due to improper removal of the car cover.
7
1
Share

How to Determine If the Vehicle Exceeds the Line in Subject 2 of the Driving Test?

After getting into the car, adjust the seat, fasten the seatbelt, and set the rearview mirror to a suitable position to observe. Pay attention to the rear tires of the vehicle. If the rear tires completely cover the boundary line in the rearview mirror, it indicates that the vehicle has exceeded the line.
13
0
Share

What are the steps before getting in the car for Subject 3?

Before getting in the car, you need to walk around the vehicle to check for any issues, and also inspect the starting environment of the vehicle. Adjust the vehicle's rearview mirrors and seat angle to ensure comfortable operation of the clutch pedal, and fasten the seat belt.
19
0
Share

How to reset the tire pressure on an older Mercedes-Benz B200?

First, ensure the key is turned to the second position. Press the upward button on the left side of the steering wheel, then press the R button on the dashboard. The dashboard will display whether the tire pressure is normal. Press the + button on the right side of the steering wheel, wait for 10 seconds, then turn off the key. Start the vehicle again to complete the process.
17
1
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.