What materials should be brought for the first car maintenance?

[StMaverick]

Items required for the first maintenance include: driver's license; maintenance manual; warranty manual; owner's ID card; vehicle registration certificate; vehicle purchase invoice. Bring these to the designated first maintenance facility for the vehicle's initial service. Important note: Make an appointment with the 4S store in advance. The first maintenance refers to the initial service after a new car has been driven, with specific timing varying by vehicle, typically after driving 1,000 to 3,000 kilometers. It is essential to attend the first maintenance promptly, neither in advance nor delayed. The completion of the first maintenance signifies the end of the vehicle's break-in period, allowing it to be driven at standard loads and normal speeds as required. The timing for the first maintenance is calculated from the date of vehicle pickup. There are two indicator values for the first maintenance: mileage and time. Whichever comes first serves as the standard. First maintenance tasks include: changing the engine oil and oil filter, cleaning the air filter, checking various fluid levels for normalcy, inspecting the generator belt and wiper blades for damage, checking tire pressure for normal levels, and examining tires for damage or bulges. Estimated time required: Approximately 2 hours to complete all tasks. The most crucial aspect of the first maintenance for a new car is changing the engine oil and oil filter. When changing the oil, the oil filter must also be replaced. The choice of oil must refer to the "Vehicle User Maintenance Manual," as different vehicle models specify different oil grades. Maintenance precautions: Do not rinse the interior of the car with water: Many people clean their cars during holidays, washing the body with water and wiping it with a cloth. It is important to note that the interior of the car should not be directly washed with water. If the floor mats are dirty, use a vacuum cleaner or take them out, scrub them with a brush and detergent, dry them, and then put them back. There are many drainage holes under the rubber mats on the floor of the driver's compartment. Water that enters will not dry naturally but will flow through these holes to areas like the transmission, causing corrosion. The best practice is to clean with a vacuum and then wipe with a cloth to prevent water accumulation. Do not mix different brands of antifreeze: If the car's antifreeze is low, it is recommended to drain the existing antifreeze and add the same brand from the start. Different brands of antifreeze have varying chemical properties. The corrosion inhibitors in one brand may corrode those in another. Do not mix different brands of antifreeze to avoid unnecessary issues. Do not lubricate tire bolts and nuts: When bolts on a moving car rust, it is common to oil them to restore functionality. However, some people apply lubricant to the bolts and nuts to prevent rust, which can pose safety risks. At high speeds, bolts and nuts may loosen or even fall off, leading to driving hazards. Do not press the accelerator when starting an EFI (Electronic Fuel Injection) car: The starter of an EFI car differs from that of a conventional car. Its fuel injection control system can automatically adjust the fuel supply based on the starter's temperature and operating conditions, ensuring a smooth start.