What maintenance is required for a car after running 10,000 kilometers?

1 Answers
CadenRose
07/30/25 8:22am
Need to replace the engine oil, oil filter, and air filter. Below is the relevant maintenance information: 1. If the car has accumulated a high mileage, during maintenance, you may also need to replace the spark plugs, fuel filter, cabin air filter, and transmission fluid. However, the most basic maintenance items for a car every 10,000 kilometers are engine oil, oil filter, and air filter. 2. For an average household car, assuming it runs 20,000 kilometers per year, it will require maintenance twice a year, meaning maintenance every 10,000 kilometers. Most full synthetic oils available today can last up to 10,000 kilometers, and some can even last up to 15,000 kilometers. If the vehicle has accumulated a significant mileage, during each 10,000-kilometer maintenance, you might also need to replace the brake pads, brake discs, tires, timing belt, etc. These components are considered wear-and-tear parts of the vehicle.
Was this review help?
6
0
Share
More Forum Discussions

What is the minimum ground clearance of the Envision S?

The minimum ground clearance of the Envision S is 190mm. The minimum ground clearance of the Envision S refers to the distance between the lowest point (excluding the wheels) and the supporting plane, which indicates the vehicle's ability to pass over obstacles such as rocks and tree stumps without collision. A higher ground clearance for the Envision S improves off-road capability, but if the ground clearance is too high, the stability at high speeds may decrease. The Chinese name for the Buick ENVISION is 'Angkewei' (Envision), which is a midsize SUV. The Envision S has a wheelbase of 2779mm, with length, width, and height dimensions of 4662mm, 1883mm, and 1631mm, respectively. Generally, the ground clearance for sedans ranges between 110mm and 150mm, while SUVs typically have a ground clearance between 200mm and 250mm. However, the ground clearance of the Envision S is not static; it also depends on the load condition. Therefore, changes in ground clearance should be considered based on variations in the Envision S's load. When selecting a vehicle, ground clearance can be one of the reference factors. The choice should depend on the vehicle's intended use and the road conditions. For well-paved urban roads, a vehicle with lower ground clearance may be preferred for increased stability and comfort. For frequent travel to remote areas or driving on poor road conditions, a vehicle with higher ground clearance may be chosen to enhance off-road performance and avoid undercarriage scrapes or damage.
2
4
Share

What is the normal starting voltage for a car?

The normal starting voltage for a car should not be lower than 12.1V. Under normal circumstances, the battery voltage before starting the car ranges between 11.8V and 12.8V, while the battery voltage after starting ranges between 13.2V and 14.8V. When the car's engine is not running, the battery voltage should be between 12.2V and 12.8V. If it drops below 11.6V, starting the car becomes difficult, and it is advisable to turn off other electrical appliances. When the battery voltage falls below 10V, the car generally cannot be started. During the use of a car battery, it is essential to keep the battery clean and dry while ensuring the vent holes remain unobstructed. Avoid continuous use of the starter; each attempt should not exceed 5 seconds, with a 10 to 15-second rest between attempts. A battery filled with electrolyte should not be left in a state of insufficient charge for extended periods and must be charged regularly to prevent damage. The electrolyte level should be 10 to 15mm above the plates; if the level is too low, add distilled water promptly, not additional electrolyte.
19
5
Share

What to Do When the Volkswagen Car Key Cannot Be Pulled Out?

Solutions for when the Volkswagen car key cannot be pulled out: 1. Key cannot be pulled out after turning off the engine: The gear is not fully returned to the P position. Check if there are any obstructions in the gear slot, remove them, start the car, and move the gear again to ensure it is fully returned. 2. Key cannot be turned after insertion: This is actually the car's steering wheel automatic lock function. While gently turning the key with your right hand, wiggle the steering wheel left and right with your left hand, and the key can then be turned. The Volkswagen T-Cross is a compact SUV under SAIC Volkswagen. Taking the T-Cross 2021 280TSI DSG Comfort Edition as an example, its dimensions are 4218mm in length, 1760mm in width, and 1599mm in height, with a wheelbase of 2651mm, and the body adopts a 5-door, 5-seat structure.
16
5
Share

Is the 2021 Levin a Three-Cylinder or Four-Cylinder?

The 2021 Levin equipped with a 1.5L naturally aspirated engine is a three-cylinder, while those with a 1.2L turbocharged or 1.8L naturally aspirated engine are four-cylinders. The Levin is a compact car under GAC Toyota. Taking the 2021 Levin 185T CVT Luxury Edition as an example, its dimensions are 4640mm in length, 1780mm in width, and 1455mm in height, with a wheelbase of 2700mm. The body adopts a 4-door, 5-seat sedan structure. In terms of power, the 2021 Levin 185T CVT Luxury Edition is equipped with a 1.2L naturally aspirated engine with an aluminum alloy block, delivering a maximum power of 85kW and a maximum torque of 185Nm, paired with a 10-speed continuously variable transmission.
12
4
Share

What are the conditions when P0507 idle control speed exceeds the specified value?

P0507 idle control speed exceeds the specified value conditions: When the vehicle starts in warm condition, it first starts with high idle speed at around 1000 rpm, then the speed drops to 720 rpm, and finally the idle speed rises to 800 rpm and stabilizes at this idle speed. Inspect the intake system and confirm that the carbon canister solenoid valve N80 and exhaust gas pressure regulating valve are damaged. After replacement, the engine flow meter value returns to normal. The increase in idle speed means that to optimize the power supply of the electrical system and the charging condition of the battery, the battery management system can request the engine control unit to increase the engine speed to meet the current state demand.
16
3
Share

How to Automatically Remove Air Bubbles from Car Window Tinting Film?

Small air bubbles can be eliminated by exposing them to sunlight for a period of time. If the bubbles are caused by improper installation techniques by the tinting technician, professional assistance is required for deeper repairs. Here is an introduction to car window tinting film: 1. Introduction: Car window tinting involves applying a thin film to the front and rear windshields, side windows, and sunroof of a vehicle. This film is also known as solar film or heat-insulating film. 2. Functions: It primarily blocks ultraviolet rays, reduces heat, prevents injuries from shattered glass, and reduces glare. Additionally, the one-way transparency feature of the film helps protect personal privacy.
12
0
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.