What lights should be turned on when entering the highway entrance?
4 Answers
When a motor vehicle enters the highway from the ramp, the left turn signal should be turned on. The following is a related introduction about highways: 1. Introduction: Highways belong to high-grade roads. According to the "Technical Standards for Highway Engineering" issued by the Ministry of Transport of China, highways refer to "roads that can accommodate an average daily traffic volume of more than 25,000 small passenger vehicles, are exclusively for high-speed driving in separate lanes, and have fully controlled access." Although the names of highways vary from country to country, they all specifically refer to roads with more than four lanes, two-way separated driving, fully controlled entrances and exits, and all using interchanges. In addition, many countries also refer to direct trunk lines with partially controlled access and not entirely using interchanges as highways. 2. Regulations: Generally speaking, highways can accommodate speeds of 120 km/h or higher, with road widths of more than four lanes. A median strip is set up in the middle, using advanced pavement materials such as asphalt concrete or cement concrete, and is equipped with complete signs, markings, signals, and lighting devices; pedestrians and non-motorized vehicles are prohibited from walking on the road, and intersections with other routes are handled via interchanges, pedestrian overpasses, or underpasses.
Before entering the highway entrance, I always turn on the right turn signal to indicate my intention to merge into the main lane. Vehicles on the highway move at high speeds, and without signaling in advance, drivers behind may not anticipate my move, which can easily lead to rear-end collisions or sideswipes. Turning on the signal at least 200 meters in advance is the safest practice. At the same time, I also check the rearview mirror and blind spots to ensure there are no vehicles nearby before gradually accelerating to merge. This is crucial because highway accidents often happen within seconds, and using the turn signal can prevent misunderstandings and conflicts. I also recommend developing the habit of signaling before every lane change in daily driving, and regularly checking if the lights are functioning properly to avoid failures at critical moments. The core of safe driving is communicating intentions, and using turn signals is the simplest and most effective way to do so.
As a frequent driver, I believe turning on the right turn signal is essential when entering the highway. The first time I drove onto the highway, I was quite nervous. A friend told me to signal in advance to let others know I was merging, which helps reduce risks. Now every time I approach a highway entrance, I turn on my right turn signal early, check both sides, and merge slowly while accelerating. Using the signal isn't just about following rules—it's for your peace of mind and others' safety. If you're new to driving, remembering this can prevent many troubles. During routine maintenance, always check if your turn signals are working; replace them immediately if they're out—don't wait for problems to arise. Using signals in heavy traffic also shows professionalism, keeping everyone's journey smooth.
Turning on the turn signal when entering a highway ramp is a basic requirement of traffic regulations. Failure to do so constitutes illegal driving and may result in fines or accidents. The specific procedure is to activate the right turn signal in advance to indicate your intention, and then merge after confirming safety. Adhering to these rules protects lives and property. I consistently practice this while driving and recommend others to regularly test their light functions to ensure road safety. Neglecting turn signal warnings on highways carries high risks – always cultivate good driving habits.
