What light is turned on when the headlights are activated in Subject 3?
3 Answers
Activating the headlights refers to turning on the low beam, which provides illumination for the driver. Below is additional relevant information: 1. Headlights: Also known as front headlamps, they are installed on both sides of the front of the car and are used for road illumination during nighttime driving. They can be configured in either two-light or four-light systems. The lighting effectiveness of headlights directly affects nighttime driving operations and traffic safety. 2. Subject 3: This includes the road driving skills test and the safety and civilized driving knowledge test, which are part of the motor vehicle driver's license assessment. It is the abbreviated term for the road driving skills and safety and civilized driving knowledge test subjects in the motor vehicle driver's examination. The content of the road driving skills test varies for different types of vehicles eligible for driving.
When you hear the instruction to turn on the headlights during the driving test (Subject 3), it actually means turning on the low beams. Don’t be intimidated by the technical term—it’s a very basic operation. Just reach out and twist the light control stalk on the left side of the steering wheel to the low beam symbol. While practicing with my friend, I noticed many beginners freeze up, but it’s simple: the dashboard will display a blue low beam indicator—just confirm it’s lit. Remember, the high beams are activated by pushing the stalk forward, which is only used for nighttime oncoming traffic—don’t mix them up. During the test, always double-check the dashboard immediately after the operation to be safe.
As a frequent visitor to the training ground, I'm well aware of the lighting operation requirements for Subject 3. Turning on the headlights specifically refers to the low beams—never switch them to high beams! The operation is quite simple: with your left hand, locate the knob on the left rear side of the steering wheel and rotate it to the position marked with a small bulb symbol. The key detail is to observe the dashboard after starting—only when the blue light icon with a diagonal line illuminates does it count as qualified. Note that the position lights will also turn on automatically at this time, which is normal and can be ignored. If the examinee is also required to perform a nighttime simulation test after this operation, they will need to use the high-low beam switch later on.
