What License Plate Does a Motorcycle Belong To?

1 Answers
MacPiper
07/30/25 12:26am
Motorcycles generally use yellow license plates for those with an engine displacement above 50cc, while blue license plates are for lightweight motorcycles with an engine displacement below 50cc. Pre-departure checks: Inspect the motorcycle's condition, ensuring the headlights, turn signals, horn, handlebars, etc., are functioning properly. Attire and protective gear: Helmets are legally required protective equipment, and it's advisable to wear brightly colored clothing. Traffic rules compliance: Avoid racing with cars; drive safely according to traffic laws and yield to pedestrians. Maintain a safe distance when following another vehicle, positioning yourself at the right rear corner of the vehicle ahead. When overtaking, pass from the left side of the vehicle in front; avoid overtaking from the right or between two parallel vehicles.
Was this review help?
6
5
Share
More Forum Discussions

How to turn on the cold air conditioning in a Buick Excelle?

Generally, the blue button in a car represents cold air, while the red one represents warm air, and the middle one represents moderate temperature. To turn on the cold air, adjust the button towards the blue area. The other two buttons are for adjusting the fan speed and the mode respectively.
11
4
Share

How to Use Buick Remote Start?

First press the lock button to ensure the vehicle is locked, then press and hold the Buick logo button on the remote key to start the vehicle. First press the lock button to ensure the vehicle is locked, then press and hold the remote start button to start the vehicle.
11
3
Share

How to turn on the high beam on a Mercedes-Benz?

The button for the high beam is located on the left control lever, which is on the driver's side. Simply push the lever forward. When the high beam is on, the lever will automatically reset after releasing it. Pulling the lever back turns off the high beam and switches back to the low beam.
16
1
Share

What are the assembly process steps for a transmission?

Clutch housing, transmission housing, differential sub-assembly, shift fork, shift shaft sub-assembly, input and output shaft sub-assembly. Assembly line process: differential assembly, differential bearing shim adjustment; shaft assembly; transmission housing assembly; fifth gear assembly, rear cover assembly, shift mechanism assembly. Air tightness testing; bench testing.
14
2
Share

How to Adjust the Car Seat?

First, open the car door and enter the vehicle, then observe the visibility effect before sitting down on the seat. Place your feet and hands naturally, then adjust the seat height to ensure clear visibility. Additionally, adjust the seat back angle to ensure comfort for your lower back. Also, adjust the seat's forward and backward position to ensure your hands can comfortably control the steering wheel.
8
1
Share

How should beginners perform parallel parking?

Align the rear of your car parallel to the parked car with a 0.5-meter gap, then start reversing. When your side mirror aligns with the center pillar between the front and rear doors of the parked car, turn the steering wheel fully to the right. When your car forms a 45-degree angle with the parking space, turn the steering wheel fully to the left. Wait until the front of your car straightens out, then return the steering wheel to the center position.
5
1
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.