What level of SUV is the Mustang Bojun?

What are the disassembly and assembly steps for the Passat automatic transmission?

Passat automatic transmission disassembly and assembly steps are: 1. Clean the exterior of the transmission, remove all components installed on the automatic transmission housing, such as the oil filler tube, neutral start switch, etc.; 2. Remove the torque converter from the front of the automatic transmission, loosen the fastening bolts, remove the torque converter housing at the front of the automatic transmission, remove the output shaft flange and the rear housing of the automatic transmission, and remove the speed sensor induction rotor from the output shaft; 3. Remove the oil pan, after removing the 19 oil pan connecting bolts, insert the blade of the special maintenance tool between the transmission and the oil pan to cut the sealant, being careful not to damage the oil pan flange; 4. Inspect the particles in the oil pan, remove all wiring harness connectors attached to the valve body, and remove the 4 solenoid valves; 5. Remove the connecting bolts between the valve body and the automatic transmission housing, and take out the valve body assembly; 6. Remove the oil pump fixing bolts and use a special tool to pull out the oil pump assembly. The Passat body dimensions are 4870mm in length, 1834mm in width, 1472mm in height, with a wheelbase of 2803mm.

3

1

Share

What Causes the Rustling Sound When the Car is Running?

It could be a bearing failure. In this case, a "rustling" sound will be emitted, which may turn into a "rattling" or "whistling" sound in severe cases. Deformed tire treads, bulges, severe wear, or tire pressure outside the standard range may all cause radial jumping of the tires during driving, resulting in abnormal noise. The tires need to be replaced or the tire pressure adjusted. During normal driving, it is important to regularly check the condition of the tires. Below are some related explanations: 1. Steering wheel noise: Poor lubrication of the steering column, resulting in high friction; insufficient power steering fluid; check if there is an issue with the universal joint; aging and hardening of the rubber bushings on the chassis suspension stabilizer bar links; aging of the steering tie rod ball joints, which need replacement; if a "clicking" noise is heard when turning the steering wheel, it indicates a problem with the steering gear, which needs to be replaced promptly. 2. Causes of body noise: It could be due to poor material stiffness of the body itself, which deforms over time and causes friction with other components, resulting in noise. In this case, simply applying adhesive tape to the friction area can usually alleviate the issue. Another possibility is that prolonged driving has caused some components to loosen, in which case the loose parts need to be identified and secured.

3

0

Share

Will points be deducted if the guide line exceeds 30cm during parallel parking?

Exceeding the 30cm guide line during parallel parking will result in a 10-point deduction. Here is an introduction to the relevant content of parallel parking: 1. Test requirements: The parallel parking test requires the driver to park the vehicle in the right parking space without the wheels touching the lane boundary or the parking space boundary. 2. Subject 2 assessment content and requirements: The five assessment items are reversing into a garage, parallel parking, stopping and starting on a slope, turning at a right angle, and driving on a curve. Subject 2 requires 26 class hours, including 2 hours of theoretical knowledge, so there are actually 24 practical class hours.

11

3

Share

Which model is the Phoenix engine?

Phoenix engine is the Peugeot 1.6L engine with model number TU5JP4. Advantages of Phoenix engine: The advantage of TU5JP4 engine lies in its power output at high RPM. Without applying any advanced auxiliary technology, this engine can achieve a maximum power of 78kw/5750rpm and maximum torque of 142nm/4000rpm. Introduction to engines: Automotive engine is the power-generating device for vehicles, serving as the heart of a car that determines its power performance, fuel economy, stability and environmental friendliness. According to different power sources, automotive engines can be divided into diesel engines, gasoline engines, electric vehicle motors and hybrid power systems, etc. Engine working principle: A four-stroke gasoline engine mixes air and gasoline in a certain proportion to form a good combustible mixture, which is drawn into the cylinder during the intake stroke. The compressed mixture ignites and burns to generate thermal energy, and the high-temperature high-pressure gas acts on the piston top to push the piston for reciprocating linear motion, outputting mechanical energy through the connecting rod and crankshaft flywheel mechanism. A four-stroke gasoline engine completes one working cycle through intake stroke, compression stroke, power stroke and exhaust stroke.

2

Share

What causes a battery to overheat and fail to charge fully?

If a battery consistently fails to charge fully and becomes hot, it may be due to battery aging or reaching the end of its service life. Batteries have a limited lifespan, typically ranging from 2 to 3 years. If charging becomes impossible, the battery's lifespan should be considered. Solutions for a battery that won't charge fully: If the battery has reached the end of its life, it needs to be replaced; if a fuse is blown, visit a 4S shop or repair shop to have a professional replace the fuse; poor contact between the fuse holder and fuse socket requires professional attention. If there's poor contact with the power source, unplug the charger and reconnect it to ensure proper contact. Battery usage precautions: Avoid using vehicle electrical devices, such as listening to the radio or watching videos, when the engine is off; if the vehicle is parked for an extended period, disconnect the battery, as even when the vehicle is locked remotely, the electrical system enters a dormant state but still consumes a small amount of current; frequent short-distance driving can prevent the battery from charging fully, significantly shortening its lifespan. Regularly drive the vehicle on highways or use an external charging device to maintain the battery.

11

3

Share

Which one to choose between Volkswagen T-Roc and Buick Encore GX?

Buy the Buick Encore GX. The following are the differences between the Volkswagen T-Roc and the Buick Encore GX: 1. Exterior: The design of the Encore GX is better than the T-Roc, with higher recognition than Volkswagen. The front face design of the Encore GX is fuller than the T-Roc, and the interior materials are also more substantial than the T-Roc. The configuration is also better than the T-Roc, such as electric sunroof, 6 airbags, remote start, automatic headlights, etc., which are all standard across the lineup. 2. Powertrain: The GX is equipped with a 1.3T+CVT, and the CVT transmission is more powerful than the T-Roc's dry dual-clutch, with better fuel efficiency. The car is equipped with General Motors' eighth-generation Ecotec engine, which is the first to feature the industry-leading ATM active thermal management system, enabling the fastest warm-up time and minimizing cold-engine operation. Facing the national six emission standards, General Motors adopts a forward R&D approach, which will also provide sufficient technical reserves in the coming years to meet more stringent emission and fuel consumption standards. The manufacturer has already produced a good product that meets current environmental requirements, so choosing the Encore GX is still a wise decision.

17

3

Share

What level of SUV is the Mustang Bojun?

What are the disassembly and assembly steps for the Passat automatic transmission?

What Causes the Rustling Sound When the Car is Running?

Will points be deducted if the guide line exceeds 30cm during parallel parking?

Which model is the Phoenix engine?

What causes a battery to overheat and fail to charge fully?

Which one to choose between Volkswagen T-Roc and Buick Encore GX?

How much fuel is generally consumed per kilometer?

What are the speed and feed rate for lathe knurling?

Can Ice Pads Be Left in a Car Under Direct Sunlight?

Will the manufacturer still honor the warranty if the car is not serviced at a 4S shop?