What kind of oil does the RAV4 use?

What are the hazards of excessive engine oil to the engine?

The hazards of excessive engine oil to the engine are: 1. It may cause the crankcase to explode; 2. The engine exhaust pipe emits blue smoke; 3. Piston ring sticking and fuel injector clogging; 4. Reduced engine output power; 5. Oil leakage. The methods to deal with overfilled engine oil are: 1. Remove the oil seal screw to drain the oil; 2. Use an oil pump to extract the excess oil. The functions of engine oil are: assisting in engine lubrication and wear reduction, cooling and temperature reduction, sealing and leak prevention, rust and corrosion prevention, and shock absorption. The steps to change engine oil are: 1. Run the engine to reach operating temperature; 2. Engage the handbrake and lift the vehicle; 3. Unscrew the oil filter and drain the oil; 4. Apply new oil to the gasket of the new filter; 5. Pour new oil into the oil pan; 6. Check for leaks under the engine; 7. Lower the vehicle, check the oil dipstick, and start the engine; 8. Turn off the engine and recheck the oil level.

6

5

Share

What is TC Slash?

When a car displays TC slash, it means the traction control is turned off. The TC light is part of the traction control system. When the anti-lock braking system detects that some wheels are slipping, it applies braking to the slipping wheels to prevent loss of traction on those wheels. Here is some relevant information: The traction control system can improve the vehicle's passability. When the system is active, the yellow TC indicator light on the dashboard flashes to alert the driver. The working principle of the traction control system is to replace the mechanical connection between the accelerator pedal and the throttle with an electronic throttle control device. Sensors transmit the accelerator pedal's information to the ECU, which generates a control voltage signal based on the input. The servo motor then adjusts the throttle according to the signal, thereby reducing the throttle opening and controlling wheel slip.

14

1

Share

How much faster is a 4.33 ratio compared to 4.875?

About 10 mph. Below is relevant information about gear ratios: 1. Different gears in the transmission have different ratios, and the main reduction gear ratios in differentials also vary across vehicles. A larger ratio results in slower speed but greater torque, while a smaller ratio provides higher speed but reduced torque. 2. The automotive transmission ratio, also known as gear ratio, refers to the speed ratio between the input and output shafts in a vehicle's drivetrain. There are two types: the final drive ratio and the transmission gear ratios. For a given vehicle model, the final drive ratio is fixed. Data for various vehicle types can be found in automotive performance manuals.

1

5

Share

Where Can I Check the Tire Production Date?

The production date of a tire can be identified through the markings on the tire sidewall. The last four digits following the letters DOT indicate the tire's production date. The first two digits of the sidewall marking represent the week of the year, while the last two digits indicate the year. The production date of a tire should not exceed three years, as the primary material of tires is rubber, and tires aged beyond three years may have deteriorated, posing safety hazards when used. Tire Replacement Cycle: The service life of car tires is four years or eighty thousand kilometers, whichever comes first. If there are more than five damages, early replacement is required. If there is even one damage on the sidewall, replacement is necessary. If you frequently drive on rough roads and the tires show severe wear, they should be replaced earlier. Tire Maintenance: Regularly check tire pressure, avoid hitting obstacles, stop using tires when the tread wears down to the wear indicator, ensure proper wheel alignment and balancing, protect tires from damage by sunlight, oil, acid, and carbon compounds, and rotate tires periodically.

16

5

Share

What is the fuel consumption of a used Roewe 750s-1.8t?

The fuel consumption of a used Roewe 750s-1.8t is 10.23L/100KM. Here are some methods to reduce fuel consumption: 1. Correct use of cruise control: When driving on good roads and less complex sections, use cruise control to maintain a steady speed at the economical speed for optimal fuel-saving effects. 2. Rational use of the air conditioning system: When the speed is below 85 km/h, consider turning off the air conditioning system as needed. 3. Utilize the car dashboard: Maintain the engine in an economical driving state, constantly monitor the readings of various gauges, and keep the engine running at the economical speed as required to achieve fuel-saving goals.

12

1

Share

What is the reason for the BMW interior rearview mirror not being adjustable?

The reason why the BMW interior rearview mirror cannot be adjusted may be due to a switch circuit malfunction. Here are detailed explanations about car rearview mirrors: 1. Overview: Car rearview mirrors are located on the left and right sides of the front of the car, as well as in the front interior of the car. They reflect the situation behind, beside, and below the car, allowing the driver to indirectly see these areas, serving as a 'second pair of eyes' and expanding the driver's field of vision. 2. Notes: Car rearview mirrors are important safety components, and their mirror surface, shape, and operation are carefully designed. The quality and installation of rearview mirrors are subject to corresponding industry standards and cannot be altered arbitrarily.

9

1

Share

What kind of oil does the RAV4 use?

What are the hazards of excessive engine oil to the engine?

What is TC Slash?

How much faster is a 4.33 ratio compared to 4.875?

Where Can I Check the Tire Production Date?

What is the fuel consumption of a used Roewe 750s-1.8t?

What is the reason for the BMW interior rearview mirror not being adjustable?

What Vehicles Can an A1 Driver's License Drive?

What is Gear Shift Jerking?

Why Does Engine Oil Increase?

How to Use the Car Air Conditioning Correctly?