What kind of engine oil should be chosen for Citroen C5?

Can a new battery still be used after three years of non-use?

It cannot continue to be used. An unopened new battery can generally last one to two years, but it needs to be recharged every three months or half a year, as the battery will naturally discharge even when not in use. Battery storage: The battery should be stored in a well-ventilated and dry place. Batteries are also sensitive to cold and should be kept in a warm environment with temperatures between 5-40 degrees Celsius. Avoid placing them near damp or heat-emitting equipment. Battery charging time: Typically, battery charging takes a long time, with an average charging duration of around 8 hours. It is important to monitor the charging time carefully. If the charging current is high, the battery may charge quickly, but continuing to charge beyond this point can lead to overcharging, causing the battery to lose water and overheat, which will reduce its lifespan.

18

4

Share

What are the pros and cons of changing from 14-inch to 16-inch wheels?

14-inch to 16-inch wheels is that the size is larger, the disadvantages are that the increased tire span leads to reduced safety, relatively higher chassis, increased wind resistance, and affects stability performance, etc. The following is a detailed introduction about car wheels: 1. Overview: The wheel hub (Car-Rim) is the part of the wheel center where the axle is installed, namely the "rim" or "steel ring". Wheel hubs are easily stained with dirt. If not cleaned for a long time, they may be corroded and deformed, creating safety hazards. 2. Classification: Wheel hubs can be divided into steel wheels and alloy wheels according to the material, each with its own advantages and disadvantages. The main advantage of steel wheels is that the manufacturing process is simple (generally using casting technology, for example, aluminum alloy wheels are generally produced by low-pressure casting technology), the cost is relatively low, and the ability to resist metal fatigue is strong.

15

1

Share

How much temperature difference can a windshield withstand?

Ordinary glass is doped with corresponding impurities according to different needs, with relatively low silicon dioxide content, generally withstanding temperatures up to 600 degrees. Characteristics of automotive windshields: Car windshields are typically made as a single-piece, large-curved surface with certain curvatures on all sides. This curved glass represents a product with extremely high technical requirements in terms of both manufacturing process and assembly fitment, as it involves multiple factors including vehicle model, strength, heat insulation, and installation. The reason why looking outward through car glass creates a speed reduction effect: Visual illusion. The variable people use to judge motion perception is not linear velocity but angular velocity (degrees of visual angle per second). Therefore, the more premium the car, the longer the front end tends to be, the greater the inclination of the windshield, and the farther the driver sits from the front end - making this "speed reduction" effect more pronounced.

4

1

Share

How to Pry Open a Locked Car Door?

Here are two solutions for prying open a locked car door: 1. The first method is to seek professional help from a locksmith to unlock the door; 2. The second method involves slightly lifting the door edge and using a wire hook to open the door via the interior door handle. Below are detailed steps for using a wire hook to pry open a car door: 1. Find a wire coat hanger and straighten the wire; 2. Use pliers to cut the straightest part of the hanger at the bottom; 3. Straighten the cut wire and bend one end into a hook shape; 4. Create a small gap in the door or window and use a wedge to widen the gap; 5. If you need to manipulate the interior door handle, insert the hooked end of the wire first; if pulling the handle, extend the hook to the handle position and hook it; if pressing a button or pulling a latch to unlock, insert the loop to the button or latch position; 6. Open the car door.

7

4

Share

What is the tire pressure for motorcycle inner tubes?

Motorcycles do not have inner tube tire pressure. The tire pressure for motorcycle tires is 170 kPa for the front wheel and 200-220 kPa for the rear wheel. Impact of motorcycle tire pressure: The correctness of tire pressure directly affects the lifespan of the tire. Excessive tire pressure can easily lead to irregular wear in the central part of the outer tire and increases the risk of tire blowouts during high-speed driving in hot summer conditions. Over-inflation not only worsens vehicle bumpiness, affecting comfort, but can also damage other components due to severe vibrations. Motorcycle tire pressure standards and composition: The normal tire pressure for motorcycles ranges between 2.2 to 2.5 bar. Tires generally consist of three parts: the outer tire, inner tube, and flap. The inner layer of the tire has a rubber layer with excellent airtightness, gradually promoting the trend toward lighter tires. The outer tire mainly consists of the carcass, tread and sidewall, and the bead, with the carcass and bead forming the force-bearing structure of the inflatable tire for vehicles.

8

1

Share

Does a Faulty Engine Exhaust Valve Affect the Engine?

Engine exhaust valve failure affects the engine. The impacts of a faulty exhaust valve include: Inability to control the exhaust gas recirculation volume, excessive exhaust gas participating in recirculation, affecting the mixture concentration, which may lead to difficult starting, engine shaking, unstable idling, weak acceleration, and overall impact on engine performance; causing the car to burn oil and emit blue smoke from the exhaust pipe. The exhaust valve serves the function of oil-gas separation. Under normal operation, it only draws exhaust gas without sucking oil. When the exhaust valve is damaged, it loses its oil-gas separation function, potentially drawing oil along with air into the combustion chamber, resulting in oil burning and blue smoke emission. Causes of exhaust valve damage: Poor quality of the exhaust valve itself; improper maintenance; fuel quality issues; aging of the exhaust valve.

11

0

Share

What kind of engine oil should be chosen for Citroen C5?

Can a new battery still be used after three years of non-use?

What are the pros and cons of changing from 14-inch to 16-inch wheels?

How much temperature difference can a windshield withstand?

How to Pry Open a Locked Car Door?

What is the tire pressure for motorcycle inner tubes?

Does a Faulty Engine Exhaust Valve Affect the Engine?

What region does the license plate code Lu F represent?

What are the solutions for soft brakes in the Great Wall H6?

Can You Make a U-turn into the Auxiliary Lane?

What are the components of the engine block assembly?