What kind of engine oil should a Golf use?

Is it normal for the car to move when the clutch is slightly lifted?

It is normal for the car to move when the clutch is slightly lifted, but this only indicates that the clutch is set too low. A clutch that is too low will shorten the service life of the clutch friction disc. This happens because as the clutch friction disc wears thin over time, poor contact occurs between the pressure plate friction disc and the flywheel, making it unable to properly transmit the torque generated by the engine. The clutch is located in the flywheel housing between the engine and the transmission. The clutch assembly is secured to the rear plane of the flywheel with screws, and the output shaft of the clutch is the input shaft of the transmission. During driving, the driver can press or release the clutch pedal as needed to temporarily separate or gradually engage the engine and transmission, thereby cutting off or transmitting the power from the engine to the transmission. The clutch is a common component in mechanical transmission systems, allowing the drivetrain to be separated or engaged at any time.

9

4

Share

What is the Purpose of Four-Wheel Alignment?

The purpose of four-wheel alignment is: 1. To extend the service life of tires; 2. To improve handling; 3. To achieve fuel-saving effects; 4. To ensure driving safety. Steps for four-wheel alignment operation: 1. Connect the power and turn on the machine; 2. Attach the target to the wheel, with the target facing the camera; 3. Click on the computer screen to enter the measurement program; 4. Open the camera to confirm if the target is correctly positioned front and back; if not, continue adjusting the target; 5. Click to measure and follow the prompts to obtain the measurement data; 6. Adjust the total front speed vehicle data to the green standard range. Situations that require four-wheel alignment include: 1. Damage to the chassis and suspension caused by an accident; 2. Replacement of the steering system and components; 3. Unilateral wear of front or rear tires; 4. Replacement or adjustment of the suspension system; 5. The car pulling to the left or right when driving straight.

10

5

Share

How to Read the Fuel Gauge on a Motorcycle to Check Fuel Level?

The F on a motorcycle's fuel gauge represents a full tank, while the E in the red zone indicates low fuel. However, when the needle points to the red zone near E, there is still approximately one-third to one-quarter of the total fuel capacity remaining in the tank. Motorcycles are powered by gasoline engines and are two- or three-wheeled vehicles steered by handlebars, known for their agility, speed, and widespread use in patrols, passenger and cargo transport, as well as sports equipment. All scooters and underbone motorcycles come equipped with fuel gauges, while some standard (or "cross" type) motorcycles may not have them. To address this, standard motorcycles feature a fuel tank switch with main and reserve positions. When fuel is abundant, the switch is set to the main tank position. When fuel runs low in the main position and stops flowing, the switch can be turned to the reserve position, which provides about 2 liters of fuel—enough to travel over 50 kilometers.

20

4

Share

How to replace the wiper blades on a Skoda Octavia?

Skoda Octavia wiper blade replacement method is as follows: 1. First, use a flat-head screwdriver to open the plastic cover at the connection between the wiper arm and the wiper blade, and hold the wiper blade with your hand. 2. Pull firmly along the direction of the wiper arm (the part where the base of the arm connects to the wiper pivot), and the wiper blade will come off. 3. For installation, reverse the removal process: insert the new wiper blade into the groove of the wiper arm, cover it with the plastic cap, and the replacement is complete. Wiper systems generally include vacuum wipers, electric wipers, and wipers with electronic control units. The drawback of vacuum wipers is that the movement speed of the wiper blade is unstable; when the engine's vacuum decreases (such as when the car is climbing a hill), the wiper blade may stop, obscuring the driver's vision. Vacuum wipers were phased out in 1972 and replaced by electric wipers.

15

1

Share

What is the difference between lfb12 and lfb11?

lfb12 and lfb11 differ in battery capacity. lfb11 and lfb12 are two engines from the same series of Honda, utilizing the working principle of the i-MMD system. In the i-MMD system, both motors are placed inside the transmission housing, and the generator does not participate in driving operations. It is only connected to the engine output shaft via gears. As soon as the gasoline engine starts, it begins generating electricity to charge the battery. Honda's i-MMD motor operates in complete synchronization with the output shaft, with a rigid connection, but the connection between the motor and the engine is controlled solely by a clutch. When the motor and engine need to operate in a hybrid output mode, the clutch engages, and a certain speed ratio must be maintained between the motor and the engine. This torque coupling method combines the torque of both for acceleration.

5

2

Share

Is Differential Oil the Same as Transmission Oil?

Differential oil and transmission oil are both types of gear oil. Differential oil is specifically designed for lubricating the rear differential of rear-wheel-drive vehicles, providing effective protection for the differential. Transmission oil, on the other hand, is used to maintain the cleanliness of the gear system, ensuring the proper functioning of the transmission and extending the lifespan of the drivetrain. The car differential is a mechanism that allows the left and right or front and rear drive wheels to rotate at different speeds. Its function is to enable the left and right wheels to roll at different speeds when the car is turning or driving on uneven roads, ensuring that both drive wheels perform pure rolling motion. The transmission is a device that changes the speed ratio and direction of motion, adjusting the torque, speed, and direction of motion transmitted from the drive shaft to the driven shaft under different working conditions. A gear-driven transmission typically consists of a housing and several gear pairs.

17

3

Share

What kind of engine oil should a Golf use?

Is it normal for the car to move when the clutch is slightly lifted?

What is the Purpose of Four-Wheel Alignment?

How to Read the Fuel Gauge on a Motorcycle to Check Fuel Level?

How to replace the wiper blades on a Skoda Octavia?

What is the difference between lfb12 and lfb11?

Is Differential Oil the Same as Transmission Oil?

What is the method for starting a Levin?

What does max mean on the air conditioner?

Is there a 2019 model for the Tiggo 3?

What Causes a Clicking Sound from the Chassis When Turning?