What Items Are Typically Replaced During Car Maintenance?

1 Answers
StReagan
07/30/25 4:25am
During routine car maintenance, the following items are typically replaced: 1. Engine oil and oil filter: These are usually replaced at every service interval. Engine oils are generally categorized into three types: mineral oil, semi-synthetic oil, and fully synthetic oil, each with different replacement cycles. Mineral oil should be replaced every 5,000 kilometers or six months, semi-synthetic oil every 7,000 kilometers or six months, and fully synthetic oil every 10,000 kilometers or annually. 2. Coolant: Automotive coolant not only prevents freezing but also helps dissipate heat generated by the engine during operation. In cold winter temperatures, coolant protects the engine from low-temperature damage. It is generally recommended to replace coolant every three years or 50,000 kilometers. 3. Cabin air filter: This filters the air to ensure clean airflow from the air conditioning system. Typically, it should be replaced every 1-2 years. 4. Brake fluid: It is advisable to replace brake fluid approximately every two years to prevent braking abnormalities and ensure driving safety. 5. Transmission fluid: Transmission fluid has a longer replacement cycle, usually recommended every five years or after exceeding 60,000 kilometers.
Was this review help?
12
1
Share
More Forum Discussions

What is the difference between 75W80 and 75W90?

75W-80 has a relatively lower viscosity compared to 75W-90. Below are the details about motor oil grades and considerations for oil changes: Introduction to motor oil grades: The oil grade indicates its viscosity specification. For example, in "15W-40" or "5W-40," the "W" stands for Winter. The smaller the number before the "W," the better the oil's low-temperature fluidity, indicating it can be used in lower environmental temperatures and provides better engine protection during cold starts. The number after the "W" represents the oil's kinematic viscosity at 100°C. A higher number indicates higher viscosity. For instance, "40" means the kinematic viscosity standard at 100°C is between 12.5mm²/s and 16.3mm²/s. Considerations for oil changes: For new vehicles under normal driving conditions, if synthetic oil is used, the oil can typically be changed every 10,000 kilometers, and some can even go up to 20,000 kilometers. Under "severe driving" conditions, where engine wear is greater, the requirements for oil are also higher. Therefore, it is recommended to shorten the oil change interval to effectively protect the engine.
6
1
Share

How to Check Water Temperature in BMW?

Different BMW series have different methods for checking water temperature. Below is the method for checking coolant temperature in BMW F series models: 1. This function requires unlocking the instrument cluster. The unlock code varies for each vehicle and is calculated by adding the last five digits of the chassis number, so each vehicle has a unique code! 2. There is a button at the bottom left of the instrument cluster used for service reset and viewing related data. Operation logic: Long press to bring up the menu, short press to select, and long press again to confirm! Below is the method for checking coolant temperature in BMW E series models: 1. Similarly, first calculate the unlock code. Turn the ignition key to the second position without starting the vehicle, and close all doors. 2. The only adjustment button at the bottom left of the instrument cluster, long press the adjustment button and hold for about 4 seconds until a triangle symbol appears. Continue holding at this point. 3. Still holding the button, the oil light will appear next. This interface is used for service data reset. 4. Now, press the button to navigate through options. When you reach item 19, long press the button to enter the code. 5. Long press to display CODE:00, then press to enter the code, which is the sum of the last five digits of the chassis number. 6. When LOCK:OFF appears, the unlock is successful. Item 7 is the water temperature.
2
5
Share

Is a tire pressure of 270 to 280 normal for the Haval F5?

A tire pressure of 2.7-2.8 bar for the Haval F5 is abnormal and can lead to uneven tire wear. Prolonged driving under such conditions may cause a tire blowout. Normal tire pressure reference standards: According to the international GBT2978-2008 standard, the recommended tire pressure for standard tires is approximately 2.4-2.5 bar, while reinforced tires should be around 2.8-2.9 bar. In winter, it is advisable to increase the tire pressure by about 0.2 bar based on the standard tire pressure. In summer, the tire pressure should be adjusted to the lower limit of the standard, typically 0.1 bar lower, to prevent blowouts due to high temperatures. For unloaded or partially loaded vehicles, adjust the tire pressure to the lower limit of the standard. For fully loaded vehicles, adjust to the upper limit. On rough roads, it is recommended to reduce the tire pressure by 0.1-0.2 bar from the standard. Daily tire pressure precautions: Most vehicles are equipped with a tire pressure monitoring system (TPMS) that alerts drivers to tire leaks or abnormal pressure to ensure driving safety. Pay attention to the TPMS warning light on the dashboard. Both underinflation and overinflation can negatively impact driving performance and accelerate tire wear.
20
4
Share

How Often Should the Kuga's Battery Be Replaced?

The lifespan of the Kuga's battery depends on usage conditions, typically ranging between 3 to 6 years. Below is some information about automotive batteries: 1. A car battery, also known as a storage battery, is a type of battery that works by converting chemical energy into electrical energy. 2. The common car battery refers to a lead-acid battery, which is primarily made of lead and its oxides, with a sulfuric acid solution as the electrolyte. Extended content: Automotive batteries can be categorized into the following three types: 1. Conventional Battery: The plates of a conventional battery are made of lead and lead oxides, with an electrolyte of sulfuric acid solution. Its main advantages are stable voltage and low cost; the disadvantages include low specific energy, short lifespan, and frequent maintenance. 2. Dry-Charged Battery: Its full name is dry-charged lead-acid battery. The main feature is that the negative plate has a high capacity for storing electricity. In a completely dry state, it can retain the stored charge for up to two years. When in use, you only need to add the electrolyte and wait for 20-30 minutes before it can be used. 3. Maintenance-Free Battery: Due to its structural advantages, the maintenance-free battery consumes very little electrolyte and basically does not require the addition of distilled water during its lifespan. It also features shock resistance, high-temperature resistance, compact size, and low self-discharge. Its lifespan is generally twice that of a conventional battery.
3
0
Share

How often should the spark plugs of a Toyota Corolla be replaced?

Toyota Corolla spark plugs should be replaced approximately every 100,000 kilometers. The spark plug is an important component in the car engine's ignition system and is a wear part that requires regular replacement. If the spark plugs are not replaced for a long time, the electrode gap will increase, affecting the spark plug's ignition energy, and carbon deposits may appear on the electrodes. Poor working condition of the spark plugs can affect the engine's combustion and power. The Toyota Corolla, once known as the 'Corolla,' is a brand of Toyota Motor. It is equipped with Michelin 215/45R17 tires, TRD Sportivo high-performance shock absorbers, TRD TF4 17-inch sport rims, reinforced clutch, and high-performance brake pads, ensuring relatively ideal sports performance.
9
1
Share

How to adjust the left and right of the Cruze headlights?

The method to adjust the left and right of the Cruze headlights mainly involves the following steps: 1. Open the engine hood. 2. Locate the adjustment screws behind the headlights. 3. You can then adjust the left and right illumination height of the headlights as needed. Extended content: The usage methods of the Cruze headlights are: 1. The daytime running lights, also known as the parking lights, are designed to make the four corners of the vehicle visible to others, with lower brightness than the headlights. These lights should be turned on during rain, in dim light, or in underground parking lots. 2. When meeting another vehicle, if the high beams are used, the other driver may be unable to see the road clearly due to the strong light and may not accurately judge the position of your vehicle, increasing the chance of an accident. Therefore, when meeting another vehicle, if the high beams are on, switch to the low beams. 3. The parking lights can be turned on when it gets slightly dark in the evening; the low beams should be used for night driving; if the weather is good, do not use the high beams or fog lights when driving on urban roads at night. 4. A prerequisite for turning on the high beams in the Cruze is that the low beams must be on. The high beams cannot be activated in other light settings. However, pulling the lever inward to flash the high beams once is not restricted and can be done even when the lights are off.
13
2
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.