What issues should be paid attention to when overtaking?

How many cylinders does the Ford Territory engine have?

Ford Territory is equipped with a 1.5-liter four-cylinder turbocharged engine. The Ford Territory is a compact SUV under the Ford brand, with dimensions of 4580mm (length), 1936mm (width), 1674mm (height), and a wheelbase of 2716mm. The Ford Territory is a five-door, five-seat SUV model. Here is an introduction to the Ford Territory: 1. The 1.5-liter turbocharged engine of the Ford Territory has a maximum power of 103kW and a maximum torque of 225 Nm. The engine's maximum power is achieved at 4500 to 5200 rpm, and the maximum torque is available from 1500 to 4000 rpm. This engine features direct fuel injection technology and uses an aluminum alloy cylinder head and block. 2. The front suspension of the Ford Territory uses a MacPherson independent suspension, while the rear suspension employs a multi-link independent suspension. The multi-link independent suspension is an improved version based on the double-wishbone suspension, where the two wishbones are replaced with separate links. The multi-link independent suspension enhances the tire's contact with the road.

18

2

Share

What causes the ABS yellow light to illuminate on the dashboard?

There are multiple states in which the ABS light may illuminate, with different causes and solutions for each state. The details are as follows: State 1: ABS warning light stays on (most common). Cause 1: The ABS speed sensor's sensing part is covered by dirt, mud, or other contaminants, affecting the sensor's ability to detect the corresponding speed signal. This prevents the ABS computer from determining the vehicle's speed and the wheel's slip rate, thus failing to issue appropriate commands to adjust braking. Solution: Clean the dirt from the speed sensor and adjust the gap between the sensor and the signal ring to restore normal function. Cause 2: Poor signal quality due to loose system wiring connections or poor contact in the ABS relay, leading to system failure. Solution: Check wiring connections and reconnect any loose parts. State 2: ABS warning light intermittently illuminates but turns off during acceleration. Cause: When multiple vehicle electrical devices are in use, the battery voltage drops below 10.5V. The ABS warning light turns off when the engine speed increases and voltage rises. The ABS system's power supply voltage is too low, possibly due to poor terminal contact or grounding issues. Solution: Check the battery's specific gravity, inspect the charging system, and examine the power supply (e.g., voltage relay or poor power contact). State 3: The ABS warning light stays on after engine startup and only turns off when the engine is turned off (IGFF). Cause: Poor grounding contact in the ABS hydraulic valve body; loose wiring connections in the ABS hydraulic valve body; ABS computer malfunction. Solution: Loosen and retighten the grounding screw on the hydraulic valve body, cleaning the contact surface if necessary. Check for enlarged gaps in the connectors. Replace the ABS or ABS/ASR computer if needed. State 4: ABS warning light illuminates during high-speed driving. Cause: During high-speed driving, the ABS computer detects a significant discrepancy between the rear and front wheel speed signals. Incorrect tire or wheel rim specifications may also be a factor. Solution: Refer to the vehicle's tire and wheel rim specifications, as indicated on the label near the fuel tank cap. State 5: ABS warning light intermittently illuminates. Cause: Improper adjustment of the brake light switch; poor internal contact in the brake light. Solution: With the engine running, press the brake pedal and manually push the brake switch linkage down to its limit, then release the pedal to complete self-positioning. Replace the brake light switch if necessary. If the ABS warning light is on, it is advisable to avoid continued driving. An illuminated ABS light indicates a malfunction in the vehicle's anti-lock braking system. During emergency braking, if the wheels lock up, the vehicle may skid uncontrollably, making it difficult for the driver to slow down or adjust the vehicle's trajectory, posing significant safety risks.

19

1

Share

How to Check Tire Pressure Monitoring Data?

The methods to check tire pressure monitoring data are: 1. Use a tire pressure monitor to check; 2. Use navigation to detect changes in tire pressure; 3. Press the tire pressure monitoring button in the central control panel area to check. Tire pressure monitoring automatically monitors tire pressure in real-time during vehicle operation and alerts for tire leaks or low pressure to ensure driving safety. The working principle of tire pressure monitoring involves using pressure sensors installed in the tires to measure tire pressure, with wireless transmitters sending pressure information from inside the tire to a central receiver module. Its functions include: 1. Preventing accidents; 2. Extending tire lifespan; 3. Reducing wear on the suspension system.

9

0

Share

Where is the fuel tank cap button on the Chevrolet Cruze?

The fuel tank cap of the Cruze is located on the right side, which is the passenger side. To open the fuel tank cap, first turn off the engine, then approach the fuel tank cap. Press the rear side of the fuel tank cap, facing the direction of the rear of the car, and press lightly. If it doesn't open, press a few more times. If the fuel tank cap is damaged, you can use the emergency manual switch located on the right side of the trunk to open it. Additional information: 1. Generally, the trunk and fuel tank cap of a sedan can be controlled remotely from inside the cabin, which provides great convenience to the owner. However, when they malfunction, it can often leave the owner at a loss, causing significant inconvenience. 2. If the fuel tank cap cannot be opened, you can start with the trunk. First, remove the trunk liner covering the fuel tank, which is usually secured by plastic clips and can be easily pried open with a screwdriver. After removing the liner, you can see the locking mechanism of the fuel tank cap and the remote control cable for the fuel tank cap. Simply pull the cable to open the fuel tank cap.

8

5

Share

Should the Sagitar 1.4T use 92 or 95 octane fuel?

The Sagitar 1.4T can use 92 octane fuel. This is the standard data provided by Volkswagen. Generally, vehicles with a "T" designation are recommended to use 95 octane gasoline to enhance the operational stability of the engine during operation. Since turbocharged engines require a high compression ratio, the proportion of fuel injected into the combustion chamber decreases. If lower-octane fuel with poor stability is used, it may cause abnormal engine operation. However, the Volkswagen Sagitar 1.4T engine, which uses the EA211 model, can efficiently utilize 92 octane gasoline, ensuring completely stable engine performance. Additional information: 1. Effects of using gasoline with too low an octane rating: If a high-compression engine uses low-octane fuel, it can lead to a sharp increase in cylinder temperature, incomplete fuel combustion, severe engine vibration, reduced power output, and damage to engine components. 2. Therefore, engines designed for 95 octane fuel should avoid using 92 octane gasoline. Conversely, using higher-octane fuel in a low-compression engine may result in "delayed ignition," where the fuel does not reach its auto-ignition point even at maximum compression, leading to incomplete combustion and carbon buildup, which is also detrimental to the engine. Hence, car owners must choose the appropriate gasoline according to their vehicle's engine specifications.

15

4

Share

How many seats does the BMW i3 have?

The BMW i3 is a four-seater, which is a pure electric vehicle under the BMW brand. The BMW i3 is a single-motor model, with the motor positioned at the rear, making it a rear-wheel-drive vehicle. Its motor has a maximum power of 125 kW and a maximum torque of 250 Nm. Here is a brief introduction to the BMW i3: 1. The BMW i3 uses a MacPherson independent suspension at the front and a multi-link independent suspension at the rear. The multi-link independent suspension is a very common type of independent suspension that can improve the wheel's ground contact performance, thereby enhancing traction. With improved traction, the vehicle's handling also improves. 2. If you are interested in the BMW i3, you can visit a local BMW 4S store for a test drive. The driving experience of this car is also quite good. The interior space of the BMW i3 is also quite sufficient. The car's dimensions are 4020 mm in length, 1775 mm in width, 1600 mm in height, with a wheelbase of 2570 mm.

4

3

Share

What issues should be paid attention to when overtaking?

How many cylinders does the Ford Territory engine have?

What causes the ABS yellow light to illuminate on the dashboard?

How to Check Tire Pressure Monitoring Data?

Where is the fuel tank cap button on the Chevrolet Cruze?

Should the Sagitar 1.4T use 92 or 95 octane fuel?

How many seats does the BMW i3 have?

What Are the Reasons Why a Sagitar Car Won't Start?

What does the wrench symbol on the Sagitar dashboard mean?

Where to Find the Civic's Engine Number?

Where is the engine of the Territory from?