What Issues Should Be Noted to Prevent Car Fires?

1 Answers
EllieDella
07/29/25 11:30pm
Preventing car fires requires attention to relevant inspection tasks, and smoking should be avoided in vehicles carrying flammable or explosive materials. Inspection: Before driving, thoroughly check the fuel and electrical systems to eliminate faults; do not drive with existing issues. If fuel system faults are detected during the journey, stop to inspect and resolve them. Prohibited: When cleaning the cylinder block with gasoline, ensure the power supply is disconnected, and do not use work lights with voltages exceeding 36 volts. Avoid: When transporting combustible or flammable materials, ensure they are properly covered. During transit, drivers and loaders must not smoke in the vehicle. Note 1: Do not stop in areas where parking is prohibited by regulations. If stopping is necessary, ensure someone is present to monitor the vehicle. Note 2: When parking the vehicle in a garage or parking lot, empty the ashtray inside the car. Note 3: Check if the potential meter has reset, then disconnect the power and lock the doors.
Was this review help?
7
1
Share
More Forum Discussions

Which Light to Use When Reversing?

When reversing a car, the reverse lights are activated. The reverse lights do not need to be manually turned on; they automatically illuminate when the car is shifted into reverse gear. Here is some relevant information about car reverse lights: 1. Introduction: Car reverse lights are installed at the rear of the vehicle to illuminate the road behind when reversing and serve as a warning to vehicles and pedestrians behind. 2. Classification: Car reverse lights can be categorized by the materials used into gas reverse lights and LED reverse lights. Gas reverse lights use halogen materials. Halogen-based reverse lights are mature in technology and low in cost, making them widely used in many car models. LED reverse lights use LED materials. LED-based reverse lights are characterized by being pollution-free, radiation-free, and having a long service life, with a theoretical lifespan of over 50,000 hours.
14
4
Share

Can a Car Spare Tire Be Used for a Long Time?

Car spare tires cannot be used for a long time. Here is some relevant information about car spare tires: 1. Purpose of Spare Tires: Compact spare tires, folding spare tires, and run-flat tires also help save storage space inside the vehicle. The maximum speed when using a spare tire is lower than that of a standard tire, and it is advisable to replace it with a standard tire as soon as possible after reaching the destination. This is usually indicated in multiple languages with prominent labels. 2. Types of Spare Tires: A full-size spare tire has the exact same specifications as the other four tires on the vehicle and can replace any temporarily or permanently unusable tire. A non-full-size spare tire has a slightly smaller diameter and width compared to the other four tires, so it can only be used as a temporary substitute. Run-flat tires, also known as safety tires or commonly referred to as "anti-burst tires," are literally translated in the industry as "tires that can run without air."
8
1
Share

What Causes Power Steering Failure in Cars?

Reason: The steering system operates under excessive load, causing excessive wear of the stator and rotor inside the steering pump. This leads to irregular movement of the oil inside the pump, resulting in power steering failure. Below is an introduction to electro-hydraulic power steering: 1. Introduction: Power steering fluid is a special liquid used in the power steering pump of a car's power steering system. Through hydraulic action, it makes the steering wheel very light, facilitating the driver's control of the driving direction. 2. Function: When the driver turns the steering wheel, the power steering system automatically provides power, thereby reducing the driver's steering effort. Power steering fluid is a medium oil added to the power steering system, serving to transmit steering force and provide cushioning. 3. Common power steering fluids: Brake power steering fluid, steering power steering fluid, clutch power steering fluid, etc. 4. Note: Power steering fluid does not need to be changed frequently.
2
2
Share

Should Windshield Washer Fluid Be Diluted with Water?

If it is pre-mixed windshield washer fluid, no additional water is needed. However, if it is windshield washer concentrate, it should be diluted with water. Below is relevant information about automotive windshield washer fluid: 1. Types of washer fluid: In northern regions, choose anti-freeze washer fluid to prevent the pipes from freezing and cracking in winter before the fluid is used up. In southern areas, washer fluid with added insect-cleaning agents is sufficient. 2. How to dilute: Generally, purchased washer fluid needs to be diluted before use. Simply follow the instructions on the product manual. The capacity of a car's washer fluid reservoir is approximately 1.5 liters, so a container of 1.25L to 1.5L is suitable for dilution. 3. How to refill: There is a reservoir on the left side of the engine compartment with a cap marked with a windshield washer symbol—this is the washer fluid container. Open it and pour in the diluted anti-freeze washer fluid, but do not overfill. It is sufficient to just see the water level at its deepest point, and do not exceed the MAX mark.
13
4
Share

What does the last letter on a tire mean?

The last letter on a tire indicates its speed rating. Sometimes it's V, sometimes H, etc. Here are the specific details: 1. V means the maximum speed is 240 km/h. 2. H means the maximum speed is 210 km/h. 3. The speed rating indicates the maximum speed at which the tire can carry a specified load under defined conditions. Common speed ratings include: Q: 160 km/h, R: 170 km/h, S: 180 km/h, T: 190 km/h, H: 210 km/h, V: 240 km/h, W: 270 km/h, Y: 300 km/h, Z: ZR speed is above 240 km/h—if ZR appears, such as in P275/40ZR1793W, then the maximum speed rating (the "W" in "93W") is 270 km/h. Below is additional information about tires: 1. Tire markings: Tires are an important component of a vehicle. There are over 10 types of markings on a car tire. Correctly identifying these markings is crucial for selecting, using, and maintaining tires, as well as ensuring driving safety and extending tire lifespan. 2. Tire specifications: Specifications are the geometric parameters and physical performance data of a tire. There are three methods to represent tire specifications: A. Metric (m); B. Mixed metric and imperial; C. Imperial. Imperial tire specifications are often represented by a set of numbers, where the first number indicates the tire section width, and the second number indicates the rim diameter, both in inches. 3. Tire structure: "R" stands for radial tire, while "D" and "-" indicate bias-ply tires. 4. Others: "XL" denotes a locally reinforced tire, "TG" indicates tires for engineering tractors and graders (off-road use), and "NHS" stands for non-highway service tires.
13
2
Share

What does auto mean on a car?

Auto on a car means automatic. Here is an introduction to the auto button on a car: 1. AUTO button on the air conditioner: It refers to the automatic function of the air conditioner. Car air conditioners can be divided into automatic and manual types. Manual air conditioners can be forced to heat or cool, while automatic air conditioners are different. When the air conditioner is turned on and the AUTO button is pressed, the air conditioner will determine the temperature, whether to cool or heat, and the fan speed based on the detection data from the car's internal sensors. 2. AUTO button on the window control: It refers to whether the window opens or closes automatically. If there is an auto window button in the car, opening or closing the window only requires pressing the button once, and it will complete the action automatically without needing to hold it. 3. AUTO button below the electronic handbrake: Its name is the automatic parking system. When the vehicle is frequently started or stopped, this button helps the owner park the car. When the automatic parking system is turned on, after stepping on the brake, the vehicle will lock, and releasing the brake will not move the car. The car will only move again after stepping on the accelerator, eliminating the hassle of repeatedly using the handbrake.
8
0
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.