···
Log in / Register

What is the wheelbase of the Haima CUPID?

4 Answers
DelAshlyn
07/24/25 11:34am
The wheelbase of the Haima CUPID is 2500 millimeters. More details about the Haima CUPID are as follows: 1. The Haima CUPID is a compact car under the Haima brand. 2. The dimensions of this car are 3918*1725*1518 millimeters in length, width, and height respectively. 3. This car is equipped with either a 1.3-liter or a 1.5-liter naturally aspirated engine. The 1.3-liter naturally aspirated engine delivers 97 horsepower and a maximum torque of 121 Nm. This engine can output maximum power at 6000 rpm and maximum torque at 4000 rpm. It features multi-point fuel injection technology and uses an aluminum cylinder head with a cast iron cylinder block. This engine is paired with a 5-speed manual transmission. The 1.5-liter naturally aspirated engine produces 112 horsepower and a maximum torque of 140 Nm. It can output maximum power at 6000 rpm and maximum torque at 4000 rpm. This engine is equipped with VVT technology and multi-point fuel injection, also using an aluminum cylinder head with a cast iron cylinder block. This engine is matched with a 6-speed AMT transmission. 4. The front suspension of the Haima CUPID uses a MacPherson independent suspension, while the rear suspension employs a torsion beam non-independent suspension. The torsion beam suspension has a simple structure and occupies less space, allowing for increased rear passenger and trunk space.
Was this review help?
6
1
Share
DeRafael
08/11/25 2:48am
I remember the Haima Cupid has a wheelbase of exactly 2500mm, which is quite interesting among small cars. I once drove my friend's old Cupid, and the 2500mm wheelbase gave it an exceptionally small turning radius—it could make a U-turn in narrow market roads in one go. However, when tall friends sat in the back, their knees would touch the front seats. The contemporary Fit had a 2530mm wheelbase, while the Polo was 2470mm; the Cupid took a middle ground. The trunk could barely fit two suitcases, but it was indeed agile for city commuting. For frequent family trips, a car with a wheelbase of 2600mm or more might be more comfortable.
Was this review help?
18
5
Share
Expand All
LeJameson
09/25/25 4:32am
I have a lot to say about the 2500mm wheelbase of the Cupid. When I accompanied my cousin to pick up the car, I specifically measured the rear seats. A person who is 175cm tall can sit in the back with about two fingers' space between their knees and the front seat—enough but not spacious. Interestingly, the car's short body makes it very agile in turns, which was especially handy when parking at the hospital with my mother-in-law. Once, I even managed to fit the panels of an assembled wardrobe in the back after folding down the rear seats—a performance that really exceeded expectations for a car with a 2500mm wheelbase. However, the rear seats can get uncomfortable on long trips, a common issue with shorter wheelbase cars.
Was this review help?
14
5
Share
Expand All
OHaven
11/08/25 6:38am
The wheelbase of the Haima Cupid is exactly 2500mm, a number I remember particularly clearly. Last month, while helping a neighbor check out a used car, I measured the actual vehicle with a tape measure. With the front seats adjusted to a comfortable position, a child safety seat could just barely fit in the back. It's sufficient for daily school runs, but becomes cramped for family trips with lots of luggage. It drives quite nimbly though—fitting into a 5-meter-wide parking space in one go, and it's fuel-efficient too. That's where the advantage of a short-wheelbase city commuter car lies. However, body sway during high-speed cornering is more noticeable compared to longer-wheelbase vehicles.
Was this review help?
8
1
Share
Expand All
More Forum Discussions

What does the automatic start-stop failure of Volkswagen Sagitar mean?

Volkswagen Sagitar automatic start-stop failure causes and solutions are as follows: Causes of Volkswagen Sagitar automatic start-stop failure: Most automatic start-stop failures occur when the control unit detects that the vehicle cannot start normally after stalling. There are many reasons, such as insufficient battery power (automatic start-stop vehicles have higher battery requirements), throttle failure, etc. Solutions for Volkswagen Sagitar automatic start-stop failure: Engage the starting gear. If neither the starter nor the engine can rotate, check according to the starting system fault; check the battery storage condition and pole connection. If the battery is normal, then check whether the starting line, fuse, and ignition switch are damaged and need to be replaced.
1
5
Share

Can you make a U-turn on a dashed yellow line?

Yellow dashed-solid lines allow vehicles on the dashed side to cross for U-turns or turns, while the solid side prohibits crossing. Violations captured by traffic cameras typically result in a 200 yuan fine and 3 penalty points. Below is relevant information: 1. Double solid yellow lines: U-turns, crossing, or high-speed turns are strictly prohibited. Violators face a 200 yuan fine and 3 penalty points. 2. Double dashed yellow lines: On main roads, left turns are permitted when safe and without obstructing traffic, but U-turns remain prohibited. 3. Solid-dashed double yellow lines: Vehicles on the dashed side may make U-turns or cross when safe and unobstructive, while vehicles on the solid side must not cross or linger on the lines.
14
3
Share

What does gdit mean?

gdit stands for Turbocharged Direct Injection Engine. Here are the specific details about the Turbocharged Direct Injection Engine: 1. Technology: In a Turbocharged Direct Injection Engine, fuel is directly injected into the cylinder via a high-pressure injector. Due to the concave bowl-shaped design of the piston top, the fuel forms a spiral-like mixture within the cylinder. 2. Advantages: To address the inherent shortcomings of SDI, a turbocharger is installed on the Turbocharged Direct Injection Engine, significantly increasing the intake pressure. The compression ratio generally exceeds 10, allowing the engine to achieve high torque at very low speeds. Moreover, due to more complete combustion, the content of harmful particles in emissions is greatly reduced.
15
2
Share

What Preparations Are Needed Before Learning to Drive?

Here are some preparations needed before learning to drive: 1. Download the "Motor Vehicle Driver Physical Condition Certificate" form from the local vehicle management office website and undergo a physical examination at a county-level medical institution or a military medical institution at or above the regimental level. 2. After passing the physical examination, you can register for the driving test at a driving school. When registering, you also need to prepare four recent one-inch bareheaded photos with a white background and corresponding electronic versions for facial image collection. 3. For non-local residents, a temporary residence certificate must be obtained from the local police station in the temporary residence area before applying for a driver's license. Additional information: The physical conditions for applying for a driver's license include corresponding regulations on age, height, vision, color discrimination ability, hearing, upper limbs, lower limbs, torso, and neck.
19
3
Share

Where is the power steering pump located?

The power steering pump is located near the pulley driven by the engine accessory belt, while the electric power steering is located below the steering wheel. Power steering systems can be roughly divided into three categories: 1. Mechanical hydraulic power steering system. 2. Electro-hydraulic power steering system. 3. Electric power steering system. Introduction to power steering systems: 1. The mechanical hydraulic power steering system generally consists of components such as a hydraulic pump, oil pipes, pressure and flow control valve body, V-type drive belt, and oil reservoir. 2. The main components of the electro-hydraulic power steering system include the oil reservoir, power steering control unit, electric pump, steering gear, and power steering sensor, among which the power steering control unit and electric pump form an integrated structure.
5
4
Share

Where is the turbocharger installed?

Normally, the turbocharger of a car is located near the exhaust manifold. You can check by opening the engine hood. Some cars have the exhaust manifold at the front, while others have it at the rear. Here is more information about turbochargers: 1. A turbocharger consists of two parts: one is the intake turbine, and the other is the exhaust turbine. The exhaust turbine is connected to the exhaust manifold. When the engine reaches a certain speed, the exhaust has enough energy to drive the exhaust turbine to rotate. The exhaust turbine is connected to the intake turbine via the same shaft. Once the exhaust turbine starts rotating, the intake turbine also begins to rotate, compressing air and blowing it into the cylinders. 2. Turbocharging technology can increase the amount of air entering the engine without increasing the engine displacement, thereby enhancing the engine's power.
11
0
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.