What is the weight of the Corolla?

1 Answers
LeNatalie
07/29/25 10:37am
The weight of the Corolla is approximately 1.2 tons, and the fully loaded weight is about 1.77 tons. Below is relevant information about the Corolla: 1. The Corolla (formerly known as 'Corolla') is a brand of Toyota. The Corolla uses Michelin 215/45R17 tires, TRD Sportivo high-performance shock absorbers, TRD TF4 17-inch sport rims, reinforced clutch, and high-performance brake pads to ensure excellent sports performance. 2. The Corolla is the tenth-generation straight-line upgrade of the Toyota COROLLA. The body size of the Corolla has significantly increased compared to the previous generation, presenting an unprecedented 'wide and low' stance, while also creating a spacious interior. The newly developed 1.6-liter and 1.8-liter engines with dual VVT-i technology deliver a more powerful driving experience.
Was this review help?
5
5
Share
More Forum Discussions

What is the actual fuel consumption of the Buick Park Avenue 3.0?

The official fuel consumption of the Buick Park Avenue 3.0 is: 10.9 liters/100 km. According to the crowd-sourced data from car owners on the website, the actual average fuel consumption is 13.0L/100KM. The Buick Park Avenue is produced by General Motors. The vehicle features innovative design and classic luxury, with smooth acceleration from 0-100 km/h in 7.8 seconds and a spacious and comfortable interior. Here is an introduction to the Buick Park Avenue 3.0: 1. The new Buick Park Avenue is equipped with an advanced 3.0L-V6-SIDI intelligent direct injection engine built with cutting-edge technology. This engine delivers a maximum power of 187kW/6700rpm and a maximum torque of 296Nm/2900rpm. Paired with a six-speed intelligent manual/automatic transmission and a high-performance rear-wheel-drive system, the vehicle accelerates from 0 to 100 km/h in just 8.3 seconds, with a combined fuel consumption of only 10.9L/100 km. The engine's power-to-displacement ratio of 62.3kW/L ranks at the top among its peers, offering significant advantages in efficiency and energy savings, along with superior smoothness and quietness. 2. This 3.0L-V6-SIDI intelligent direct injection engine shares its lineage with the 3.6L-V6-SIDI engine found in the Buick Enclave luxury SUV. Utilizing the most advanced cylinder direct fuel injection technology, the 3.0L-V6-SIDI engine shows a 5% reduction in fuel consumption and a 25% decrease in cold-start pollutant emissions compared to traditional engines of the same displacement, while significantly improving power and torque. It fully complies with the Euro 4 emission standards.
3
0
Share

Does signing for Subject 2 mean passing?

Signing for Subject 2 means passing. Here is the relevant introduction to Subject 2: 1. Small vehicle test content: The test items include reversing into a garage, parallel parking, stopping and starting on a slope, turning at a right angle, and driving through curves (commonly known as S-curves) as five mandatory items (some areas also have a sixth item of high-speed card collection). 2. Large vehicle test content: The test items include stake driving, stopping and starting on a slope, parallel parking, passing through a single-plank bridge, driving through curves, turning at a right angle, passing through a width-restricted gate, passing through continuous obstacles, driving on bumpy roads, making a U-turn on a narrow road, as well as simulating highway driving, continuous sharp turns on mountain roads, tunnels, rainy (foggy) conditions, slippery roads, and emergency situations.
15
5
Share

Can Electric Vehicles Drive on Highways?

Electric vehicles can drive on highways, but they must meet the following three conditions: 1. Possess necessary certifications such as motor vehicle registration certificate and compliance certificate: The pure electric vehicle driven by the owner should be produced by a legitimate manufacturer and have the motor vehicle registration certificate, compliance certificate, and other qualifications issued by relevant national quality supervision departments. The vehicle must have a dedicated new energy vehicle license plate and a motor vehicle driving license issued by the traffic management department. 2. Speed requirements: The vehicle's maximum speed must meet the speed requirements for highway driving. 3. C2 or higher driver's license: On highways within Chinese provinces, the driver must also hold a C2 or higher driver's license.
6
2
Share

What is the solution to the knocking sound during cold start that disappears after the engine warms up?

The solutions to the knocking sound during cold start are as follows: 1. The knocking sound disappears as temperature rises: When the car starts and knocking sounds occur in low-temperature environments, but disappear as the temperature rises, this type of knocking can be temporarily ignored, and the vehicle can continue to be driven. 2. The knocking sound becomes more obvious at normal temperature: If the knocking sound does not disappear but becomes more pronounced when the engine reaches normal temperature, the owner should avoid high-speed driving, stop and inspect the vehicle in time to prevent traffic accidents. 3. Replace the cylinder liner, piston, and piston rings: If after removing the cylinder head and pulling out the piston, it is found that the cylinder is severely out of round, scratched, or the gap between the piston and cylinder is too large, replacement is necessary. Replace the cylinder liner, piston, and piston rings.
11
5
Share

Why was the Cross-Polo discontinued?

Cross-Polo was discontinued due to low sales volume. Here are the specific details about the Cross-Polo: 1. Powertrain: The Cross-Polo only offered one engine option - a 1.6L gasoline engine with 77kW/5000rpm power and 155Nm/3800rpm torque, meeting Euro IV emission standards, paired with either a 6-speed Tiptronic or 5-speed manual transmission. 2. Chassis: The ground clearance was increased by 15mm, equipped with 17-inch alloy eight-spoke BBS wheels, raising the overall vehicle height by 32mm. The total body length was 3.916 meters and width was 1.650 meters.
3
0
Share

How often should a sedan undergo annual inspection?

The first annual inspection for a sedan is required when it reaches six years of age. For non-operational small and micro passenger vehicles, including family sedans, those over 6 years but under 10 years old need to undergo inspection every two years. For a vehicle that has just reached six years, the owner must drive the vehicle to the inspection station, bringing along their ID card, vehicle license, vehicle and vessel tax or tax exemption certificate, and compulsory traffic insurance policy. After passing the inspection, a certification form will be issued, and the owner can then take this form along with the other documents to the relevant window to receive the annual inspection sticker. Annual inspection procedure: First, after submitting the inspection application, the vehicle undergoes an online inspection. The vehicle is driven into the automatic inspection area to sequentially check the exhaust emissions, speed, lights, side slip, and chassis to ensure they meet the standards. Only when all items pass can the vehicle proceed. Next is the appearance inspection, verifying the correctness of the vehicle's license plate, type, body color, engine number, VIN code, and frame number. Then, the body appearance is inspected, including details such as the bumper, engine compartment, rearview mirrors, lower mirrors, window glass, paint, engine operation status, and the interior and wheels of the vehicle. Finally, the owner can obtain the inspection report and application form from the inspector. If all inspection items pass, the owner can proceed to pay the inspection fee and receive the vehicle license and inspection label. If any items fail, the owner must repair the vehicle and undergo re-inspection until all items pass before proceeding with the visa procedures. Annual inspection precautions: During the annual inspection, the vehicle management office will check the vehicle's lights. If the lights are found to be too dim or too bright, the vehicle will be deemed unqualified and will not pass the inspection. If the lights are too dim, check the light circuit and bulbs for aging, and replace the relevant parts if necessary. If the vehicle has been modified with xenon headlights, it is recommended to restore the original headlights before the inspection to pass the test.
10
1
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.