What is the weight capacity of a car trunk?

2 Answers
McMax
09/04/25 6:29am
For ordinary sedans, the trunk weight capacity is approximately 125 kg, while hatchbacks typically have a capacity below 80 kg. SUVs generally offer a trunk capacity of around 500 kg. The exact weight capacity varies depending on the specific vehicle model, and you can refer to the values provided in the vehicle's manual. It's advisable to avoid placing excessively heavy items in the trunk, as this can easily cause serious damage to the car. The car trunk serves as a storage compartment for miscellaneous items, and using a trunk liner can effectively protect it by preventing dirt or liquids from damaging the trunk surface and keeping items from sliding around.
Was this review help?
12
3
Share
OOmar
09/16/25 7:25am
I've been driving for over 20 years, and I know that trunk load capacity depends on your vehicle type. Sedans generally shouldn't exceed 150 kg, SUVs can handle 200 to 300 kg, while pickup trucks are more robust with about 500 kg capacity. Excessive weight can damage the suspension system, making the vehicle unstable, especially during turns or emergency braking, potentially causing loss of control. I once saw a friend overload their trunk during a move - it couldn't close properly and items flew out on the highway, nearly causing an accident. I recommend balancing the load evenly, avoiding excessive weight on one side, and regularly checking rear wheels for deformation or unusual noises. For precise limits, check your owner's manual or factory label for specifications. If unsure, visit a repair shop for professional testing.
Was this review help?
4
2
Share
Expand All
More Forum Discussions

How many seconds does it take for the Audi TT to accelerate from 0 to 100 km/h?

Audi TT accelerates from 0 to 100 km/h in 6.4 seconds. The following is an introduction to the related content of maximum speed: Maximum speed test: The maximum speed refers to the highest driving speed a car can achieve under windless conditions on a level, good asphalt or cement road surface. According to Chinese regulations, the last 500 meters of a 1.6-kilometer test section are used as the test area for maximum speed, with four round trips conducted, and the average value is taken. Limited maximum speed: The maximum speed is different from the theoretical maximum speed (which refers to the best performance achieved by the engine under optimal conditions, limited to theory). For some high-performance cars, manufacturers often limit the vehicle's maximum speed through technical means (such as electronic speed limit function) to protect the engine or comply with traffic regulations when the car leaves the factory.
6
5
Share

What Causes the BMW Trunk Switch to Fail?

Here are the reasons why the trunk of a BMW car cannot be opened: Linkage rod or lock cylinder issue: If you frequently use the key to open the trunk, the inability to open it may be due to a broken linkage rod, which requires a visit to a repair shop to resolve. If you always use the remote control to open the trunk, the lock cylinder might be dirty or rusty. Spraying a rust remover into the lock cylinder a few times can help open it. Not unlocked: Before attempting to open the trunk, it's best to press the unlock button on the key and check if the key's battery has power. Mechanical component failure: The trunk itself might have issues, such as a broken wire or other trunk-related problems that prevent it from opening.
8
5
Share

What grade of gasoline should an Audi RS7 use?

Audi RS7 should use 98-octane gasoline, as this is the recommended fuel grade in the vehicle's official user manual. In addition to checking the appropriate gasoline grade in the user manual, you can also find it on the fuel tank cap, which will also indicate the recommended grade. Typically, the fuel grade can also be determined based on the engine's compression ratio. Vehicles with an engine compression ratio between 8.6-9.9 should use 92-octane gasoline, those between 10.0-11.5 should use 95-octane gasoline, and if the compression ratio is higher, 98-octane gasoline is recommended. However, with the application of new technologies, the compression ratio alone cannot determine the appropriate gasoline grade, as high-compression engines can also be tuned to use lower-octane fuel. This is because, besides the compression ratio, other factors such as ignition timing, turbocharging technology, and Atkinson cycle technology also play a role. Generally, the higher the gasoline grade, the higher the octane number and the better the anti-knock performance. 92-octane gasoline contains 92% isooctane and 8% n-heptane, while 95-octane gasoline contains 95% isooctane and 5% n-heptane. If the wrong gasoline grade is occasionally used in an Audi RS7, simply switching back to the correct grade after consumption is sufficient. However, prolonged use of the wrong gasoline grade can have the following effects: For vehicles recommended to use lower-octane gasoline, using a higher-octane grade will not cause damage, but the increased octane number can alter the fuel's ignition point, leading to delayed combustion in the engine. This results in reduced engine power and thermal efficiency, with the practical effect being poorer performance. For vehicles recommended to use higher-octane gasoline, using a lower-octane grade can cause engine knocking. Because the octane number is significantly lower, the lowered ignition point may cause the fuel to ignite prematurely during the compression stroke. If detonation occurs before the spark plug fires, resistance will develop during the upward stroke. This resistance makes the engine run very unstably. If the knocking is mild, it may only increase noise without obvious engine damage. However, noticeable knocking indicates severe engine conditions, affecting not only driving stability but also causing abnormal wear on pistons and cylinders, and in severe cases, cylinder scoring.
7
1
Share

What is the tire model of the BMW 740?

The tire model of the BMW 740 is 245/50R18. The first number 245 represents the tire width of 245MM, 50 indicates the aspect ratio of the tire section is 50%, meaning the section height is 50% of the width, the letter R stands for radial tire, and 18 represents the rim diameter of 18 inches. The BMW 740 has a top speed of 235km/h, accelerates from 0 to 100km/h in 7.8 seconds, and has a fuel consumption of 7.5L per 100km. In addition to the model, the tire also displays the following common data: Tire cord material: Indicated by Chinese pinyin, such as M-cotton cord, R-rayon cord, N-nylon cord, G-steel cord, ZG-steel radial cord tire. Speed rating: Indicates the maximum speed at which the tire can carry a specified load under defined conditions. Letters A to Z represent certified speed ratings ranging from 4.8km/h to 300km/h. Common speed ratings include: Q: 160km/h; H: 210km/h; V: 240km/h; W: 270km/h; Y: 300km/h; Rim specification: Indicates the rim size compatible with the tire for practical use, such as "Standard rim 5.00F".
6
2
Share

What is the wheelbase of the XPeng P7?

The wheelbase of the XPeng P7 is 3000mm. Below is an introduction to relevant information about XPeng Motors: Forms and Relationships: XPeng Motors adopts a contract manufacturing model for production. The company and its component suppliers strengthen ties through mutual investments, while leveraging existing social resources for testing and inspection to avoid excessive early-stage costs. R&D Work: XPeng Motors has completed the first phase of its R&D efforts, which focuses on developing a pure electric drive system centered around the motor, battery, and electronic control (collectively known as the "three electric components"), as well as an intelligent system centered around a large central control screen (referred to as the "one screen"). Currently, prototype vehicles equipped with XPeng's "three electric components and one screen" have accumulated test mileage exceeding 5,000 kilometers. Core: XPeng Motors' pure electric drive system is built around the motor, battery, and electronic control. The motor controller, DCDC, and charger are located in the front compartment, while the battery system is positioned beneath the floor of the passenger compartment.
1
0
Share

What is the difference between Passat 300tsi and 330tsi?

The following are the differences between Passat 300tsi and 330tsi: Engine: The Passat 300TSI is equipped with the second-generation EA888 engine and is a government procurement version. The 330TSI uses the third-generation EA888 engine and comes in Premium, Luxury, and Flagship versions. Power: The 300TSI features a 1.8T inline 4-cylinder turbocharged low-power version, paired with a 6-speed automatic transmission, delivering a maximum power of 118KW, maximum horsepower of 160PS, and maximum torque of 250N·m. The maximum power rpm is 5100~6000rpm, and the maximum torque rpm is 1700~5000rpm. The Passat 330TSI is equipped with a 1.8T inline 4-cylinder turbocharged high-power version, matched with a 7-speed dual-clutch transmission, producing a maximum power of 132KW, maximum horsepower of 180PS, and maximum torque of 300N·m. The maximum power rpm is 4300~6250rpm, and the maximum torque rpm is 1450~4100rpm.
10
4
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.