What is the wading depth of the new Santana?

1 Answers
ElainaFitz
07/25/25 8:52am
The wading depth of the new Santana is 300mm. The wading depth of the new Santana is determined by the height of the vehicle's chassis, which is the ground clearance listed in the model's parameter configuration table. Generally, the greater the ground clearance, the higher the chassis, and the higher the safety factor when passing through waterlogged roads. Therefore, in terms of safe wading depth, the advantages of off-road vehicles and SUVs are obvious. However, for most compact and small cars with low chassis, the position of the vehicle's air intake should be used as a benchmark when passing through waterlogged roads. If the air intake of the new Santana is below the water level during wading, water will be sucked into the engine's cylinders. Since water cannot be compressed like air, it will cause severe damage to the engine's mechanical components (such as connecting rods, pistons, crankshafts, etc.). Therefore, the wading depth should not exceed the height of the engine's air intake. The height of the engine's air intake, and thus the maximum wading depth, can also be increased by installing a snorkel. If wading is unavoidable, the following safe and correct operations should be performed: Before the vehicle enters the water, the auto start-stop function must be turned off to prevent the engine from automatically restarting after stalling in the water, which could cause severe damage due to water intake; Based on the passage of the vehicle ahead, assess the underwater road conditions and choose an entry point. Observe the path taken by other vehicles and follow it at a low speed, avoiding sudden acceleration or deceleration; For roads prone to water accumulation, observe warning water level markers, trees, or the wheels and doors of other vehicles as reference points to judge the water depth before deciding whether to proceed; Know your vehicle's safe wading depth. If the water depth exceeds half of the tire height or the engine's air intake, do not enter the water recklessly; choose an alternative route instead.
Was this review help?
9
1
Share
More Forum Discussions

What transmission is used in the new Mercedes-Benz GLE AMG?

The new Mercedes-Benz GLE AMG uses a 9AT transmission, which offers relatively smooth gear shifting and good reliability and durability. The AT transmission can also be referred to as a torque converter transmission, as it connects to the engine via a torque converter. Inside the AT transmission are planetary gears, which are responsible for gear shifting and torque conversion. As the top performance version of the GLE, the new Mercedes-Benz GLE AMG is equipped with a 430kW 5.5L twin-turbocharged V8 engine. Its body dimensions are 4961mm in length, 2014mm in width, and 1716mm in height.
8
1
Share

Does the new Corolla not have a reverse radar?

The new Corolla does not come with a reverse radar installed, and owners need to install it later. A reverse radar is a safety assist device used when the vehicle is reversing or parking. Car radars are divided into front radars and rear radars. For cars equipped with a reverse radar, the driver can determine the distance between the car and obstacles through sound or virtual images while reversing, avoiding scratches during the process. This is the main function of a reverse radar. The body dimensions of the all-new Corolla are 4620mm in length, 1775mm in width, and 1480mm in height, with a wheelbase of 2700mm.
17
2
Share

How to Reset the Maintenance Light on a Civic?

Steps to reset the maintenance light on a Civic: Turn on the Civic's power, repeatedly press the (Display/Info) button until "Maintenance" appears on the screen, then press the Enter button for about ten seconds to reset. Below is an introduction to car maintenance: 1. Maintenance content: Mainly includes the maintenance of the engine system, transmission system, air conditioning system, cooling system, fuel system, power steering system, etc. 2. Maintenance purpose: To keep the car clean and in normal technical condition, eliminate potential hazards, prevent faults, slow down the deterioration process, and extend the service life.
18
2
Share

How to start an Audi Q5?

Enter the car, insert the smart key into the slot, step on the brake, then press the one-touch ignition button located next to the gear shift. If the car is equipped with a one-touch start system, carry the key with you, step on the brake, ensure the gear is in P or N position, and press the one-touch start button. If the car does not have a one-touch start system, there is a card slot on the dashboard behind the right side of the steering wheel. Insert the key with the button side facing up, step on the brake, and press the key inward.
17
1
Share

What is the chassis code of the new BMW 3 Series?

The chassis code of the new BMW 3 Series is G20, with three versions available: 320i, 330i, and M340i xDrive. The new BMW 3 Series adopts a front-engine, rear-wheel-drive layout. It features a double-joint spring strut front suspension and a multi-link independent rear suspension. The body structure is of a unibody design, with electric power steering. The entire new BMW 3 Series lineup is equipped with the B48B20B engine, which has a displacement of 2.0L and utilizes turbocharging. It is paired with an 8-speed automatic transmission, delivering a maximum output of 184 horsepower and a peak torque of 300 Nm, complying with the China VI emission standards.
19
1
Share

How to Start an Automatic Transmission Car Without Hill Start Assist?

Before starting the car, ensure the gear lever is in P (Park) or N (Neutral). When starting, pay attention to coordinating the brake, handbrake, and accelerator properly. After shifting to D (Drive), slowly release the handbrake while gently lifting the brake pedal (similar to slowly releasing the clutch in a manual transmission car), then lightly press the accelerator to allow the vehicle to start moving gradually. Avoid stomping on the accelerator, as it not only wastes fuel but also harms the vehicle. Also, remember not to release the brake pedal when shifting gears.
20
1
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.