What is the wading depth of the Maxus V80?

2 Answers
OliviaAnn
07/25/25 6:42am
The maximum wading depth of the Maxus V80 is 600mm. The wading depth of the Maxus V80 is determined by the height of the vehicle's chassis, which is the ground clearance listed in the model's parameter configuration table. Generally, the greater the ground clearance, the higher the chassis, and the higher the safety factor when passing through waterlogged roads. Therefore, in terms of safe wading depth, the advantages of off-road vehicles and SUVs are obvious. However, for most compact and small cars with low chassis, the position of the vehicle's air intake should be used as a reference when passing through waterlogged roads. If the air intake of the Maxus V80 is below the water level during wading, water will be sucked into the engine's cylinders. Since water cannot be compressed like air, it will cause severe damage to the engine's mechanical components (such as connecting rods, pistons, crankshafts, etc.). Therefore, the wading depth should not exceed the height of the engine's air intake. The height of the engine's air intake, and thus the maximum wading depth, can also be increased by installing a snorkel. If wading is unavoidable, the following safe and correct operations should be performed: Before the vehicle enters the water, always turn off the auto start-stop function to prevent the engine from automatically restarting after stalling in the water, which could cause severe damage due to water ingestion. Assess the underwater road conditions based on the passage of preceding vehicles and choose an appropriate entry point. Observe the path taken by other vehicles and follow their tracks at low speed, avoiding sudden acceleration or deceleration. On roads prone to water accumulation, observe warning water level markers, trees, and reference points such as the wheels and doors of other vehicles to estimate the water depth before deciding whether to proceed. Know your vehicle's safe wading depth. If the water depth exceeds half the height of the tires or the engine's air intake, do not proceed and choose an alternative route.
Was this review help?
4
3
Share
MacDaisy
08/10/25 6:15pm
I've just researched this! For light passenger vehicles like the SAIC Maxus V80, the manufacturer's official wading depth is generally around 400mm, which is about half the height of a tire. You need to be extra careful driving this vehicle in the rain—if you encounter standing water, don't force your way through. It's best to observe whether other vehicles can pass first. Ordinary urban stormwater accumulation isn't a big issue, but if water floods into the air intake, trouble can escalate quickly, ranging from stalling to severe engine damage. If you must wade through water, remember two key points: maintain steady throttle for a consistent speed to avoid creating large splashes, and after crossing the water, press the brakes a couple of times to dry the brake discs. Safety first!
Was this review help?
17
4
Share
Expand All
More Forum Discussions

How many liters of transmission oil are needed for a Honda XRV?

Honda CRV typically requires about 6 liters of transmission oil. Transmission oil is a lubricant that maintains the cleanliness of the gear system, ensuring the proper functioning of the transmission and extending the lifespan of the transmission components. It should be replaced when you notice significant difficulty in shifting gears or severe jerking. More details are as follows: 1. Depending on the transmission structure, transmission oil is categorized into manual transmission oil and automatic transmission oil. 2. Manual transmission oil, commonly referred to as gear oil, is primarily composed of petroleum-based lubricating oil or synthetic lubricating oil, enhanced with extreme pressure anti-wear agents and oiliness agents. It is a crucial lubricant used in various gear transmission devices to prevent gear surface wear, scuffing, and seizing, thereby extending their service life, improving power transmission efficiency, and reducing power loss. 3. Automatic Transmission Fluid (ATF) is specifically designed for automatic transmissions. This specialized fluid serves as the hydraulic fluid for the torque converter, the lubricant for the planetary gear structure, and the hydraulic oil for the shifting mechanism.
2
3
Share

What is the minimum ground clearance of the new Kuga?

The minimum ground clearance of the new Kuga is 180 millimeters. The minimum ground clearance of the new Kuga refers to the distance between the lowest point (excluding the wheels) and the supporting plane, which indicates the vehicle's ability to pass over obstacles such as rocks and stumps without collision. A higher ground clearance for the new Kuga improves its off-road capability, but if the ground clearance is too high, the stability at high speeds may decrease. The new Kuga is a compact SUV under Changan Ford. The dimensions of the two-wheel-drive Jingyi version of the new Kuga are 4524 mm in length, 1838 mm in width, and 1685 mm in height, with a wheelbase of 2690 mm. Other versions measure 4524 mm in length, 1838 mm in width, and 1701 mm in height, with the same wheelbase of 2690 mm. Generally, the ground clearance of sedans ranges from 110 mm to 150 mm, while SUVs have a ground clearance between 200 mm and 250 mm. However, the ground clearance of the new Kuga is not static; it also depends on the load condition. Therefore, changes in ground clearance should be considered based on the vehicle's load variations. When selecting a vehicle, ground clearance can be one of the reference factors. The choice should depend on the vehicle's intended use and the road conditions. For urban areas with well-paved roads, a vehicle with lower ground clearance may enhance stability and comfort. For long-distance travel or driving in areas with poor road conditions, a vehicle with higher ground clearance is advisable to improve off-road performance and avoid damage to the undercarriage.
14
1
Share

What causes the system to be too lean in Volkswagen cylinder bank 1 at idle?

The reasons for the system being too lean in Volkswagen cylinder bank 1 at idle are: 1. Clogged fuel injector; 2. Excessive air intake; 3. Exhaust pipe leakage; 4. Aging and softening of the crankcase ventilation valve diaphragm in the oil-gas separator. The methods to address the system being too lean in cylinder bank 1 at idle are: 1. Check the fuel injector atomization; 2. Inspect the electronic control system; 3. Verify if the engine intake pressure sensor is faulty. Taking the 2020 Volkswagen Magotan as an example, its body dimensions are: length 4865mm, width 1832mm, height 1471mm, wheelbase 2871mm, fuel tank capacity 66 liters, and trunk capacity 533 liters.
11
4
Share

What engine does the Peugeot 308 use?

Peugeot 308 uses three engines, which are the low-power and high-power versions of the 1.2-liter turbocharged engine and the 1.6-liter naturally aspirated engine. The low-power version of the 1.2-liter turbocharged engine has 116 horsepower and a maximum torque of 190 Nm. The high-power version of the 1.2-liter turbocharged engine has 136 horsepower and a maximum torque of 230 Nm. The 1.6-liter naturally aspirated engine has 117 horsepower and a maximum torque of 150 Nm. The body dimensions of the Peugeot 308 are 4590mm in length, 1820mm in width, and 1488mm in height, with a wheelbase of 2675mm. The Peugeot 308 is front-wheel drive, with a front suspension type of MacPherson independent suspension and a rear suspension type of torsion beam non-independent suspension.
3
0
Share

How to Replace the Battery in a Mercedes C55 Key?

Method for replacing the battery in a Mercedes C55 key: 1. Pull up the key while pushing open the latch; 2. Remove the mechanical key and locate the gap for the electronic key to insert; 3. After inserting the key into the gap, gently pry it open; 4. Once the back cover is open, tap it on your palm to remove the battery; 5. Reinstall the battery in the same manner. The Mercedes C55 has body dimensions of 4526mm in length, 1728mm in width, and 1427mm in height, with a wheelbase of 2715mm. The Mercedes C55 features a front-engine, rear-wheel-drive layout, with a front suspension type of double-wishbone, coil springs, and stabilizer bar, and a rear suspension type of multi-link, coil springs, and stabilizer bar.
2
0
Share

What Causes the Bad Smell Inside the Car?

Causes of bad smell inside the car: 1. Odors from items in the car: such as smoking, eating, or placing unclean items in the car; 2. New car smell: When the car leaves the factory, the plastic panels or rubber rings inside the car may contain substances like formaldehyde that have not yet dissipated, which can produce a certain odor; 3. Air conditioning odor: If the air conditioning filter is not cleaned for a long time, it can accumulate bacteria and dirt. When air passes through these substances and circulates into the car, it can produce an unpleasant smell. Tips to avoid bad smells: 1. Try not to eat strongly flavored food in the car; 2. Avoid placing fragrances or similar items in the car; 3. When using the air conditioning, try to use the external circulation mode; 4. After purchasing a new car, promptly remove the plastic protective films inside the car.
13
0
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.