What is the wading depth of the Hongguang Mini?
3 Answers
The wading depth of the Hongguang Mini is 125mm. The wading depth of the Hongguang Mini is determined by the height of the vehicle's chassis, which is the ground clearance listed in the model's parameter configuration table. Generally, the greater the ground clearance, the higher the chassis, and the higher the safety factor when passing through waterlogged roads. Therefore, in terms of safe wading depth, off-road vehicles and SUVs have obvious advantages. However, for most compact and small cars with low chassis, the position of the vehicle's air intake should be used as a benchmark when passing through waterlogged roads. If the air intake of the Hongguang Mini is below the water level while wading, water will be sucked into the engine's cylinders. Since water cannot be compressed like air, it will cause severe damage to the engine's mechanical components (such as connecting rods, pistons, crankshafts, etc.). Therefore, the wading depth must not exceed the height of the engine's air intake. The height of the engine's air intake, and thus the maximum wading depth, can also be increased by installing a snorkel. If wading is unavoidable, the following safe and correct operations should be performed: Before the vehicle enters the water, the auto start-stop function must be turned off to prevent the engine from automatically restarting after stalling in the water, which could cause severe damage due to water intake; Assess the underwater road conditions based on the passage of preceding vehicles and choose an appropriate entry point. Observe the path taken by other vehicles and follow it at low speed, avoiding sudden acceleration or deceleration; For roads prone to water accumulation, observe warning water level markers, trees, or other vehicles' wheels and doors as reference points to judge the water depth before deciding whether to proceed; Know your vehicle's safe wading depth. If the water depth exceeds half the tire height or the engine's air intake, do not enter the water recklessly; choose an alternative route instead.
Seeing someone ask about the wading depth of the Hongguang Mini, I feel that as a car enthusiast, I need to explain it clearly: The wading depth of this electric mini car is generally around 300 millimeters, which is below the center height of the wheel hub. Electric vehicles have better battery sealing and stronger water resistance compared to traditional cars, which are prone to stalling, but you still shouldn’t wade through deep water recklessly. When driving through puddles, keep the speed slow to avoid wave impacts affecting sensors or the braking system. It’s fine for daily city driving, but don’t force your way through deep standing water after rain—if the water level is too high, it could damage suspension components or cause short circuits. It’s recommended to do a quick check of the chassis for any water traces after wading and promptly rinse off any mud or sand at a car wash to prevent corrosion. Overall, the Hongguang Mini is designed with urban commuting in mind, and its wading capability is fairly reliable, but safety always comes first.
From a daily driving perspective, I recommend not exceeding a wading depth of 30cm for the Hongguang Mini, which is approximately half the tire height. Electric vehicles are somewhat safer than fuel-powered cars when wading because the motor is sealed against water ingress. However, based on my experience driving similar models, I've found that water that's too deep can still cause issues, such as affecting the brakes or electrical connectors. It's best to detour around heavy rain and accumulated water rather than pushing through to avoid expensive repairs and wasted time. As a side note, after wading, drive a short distance and check for any unusual noises or power abnormalities in the car—addressing issues early saves a lot of hassle. This car is compact and easy to drive, but paying attention to maintenance details is key to its longevity.
