What is the wading depth of the BYD Han?

1 Answers
LeFinley
07/28/25 3:10pm
The maximum wading depth of the BYD Han is approximately 250mm. The wading depth of the BYD Han is determined by the height of the vehicle's chassis, which is the ground clearance listed in the model's parameter configuration table. Generally speaking, the greater the ground clearance, the higher the chassis, and the higher the safety factor when driving through waterlogged roads. Therefore, in terms of safe wading depth, off-road vehicles and SUVs have obvious advantages. However, for most compact and small cars with low chassis, the position of the vehicle's air intake should be used as a benchmark when passing through waterlogged roads. If the air intake of the BYD Han is below the water level during wading, water will be sucked into the engine's cylinders. Since water cannot be compressed like air, it will cause serious damage to the engine's mechanical components (such as connecting rods, pistons, crankshafts, etc.). Therefore, the wading depth should not exceed the height of the engine's air intake. The height of the engine's air intake, and thus the maximum wading depth, can also be increased by installing a snorkel. If wading is unavoidable, the following safe and correct operations should be performed: Before the vehicle enters the water, be sure to turn off the auto start-stop function to prevent the engine from automatically restarting after stalling in the water, which could cause serious damage due to water ingestion; Assess the underwater road conditions based on the passage of vehicles ahead and choose an appropriate entry point. Observe the path taken by other vehicles and follow their tracks at low speed, avoiding sudden acceleration or deceleration; On roads prone to waterlogging, observe warning water level markers, trees, and reference points like the wheels and doors of other vehicles to estimate the water depth before deciding whether to proceed; Know your vehicle's safe wading depth. If the water depth exceeds half the height of the tires or the engine's air intake, do not proceed and choose an alternative route instead.
Was this review help?
3
3
Share
More Forum Discussions

What to Do When the Temporary License Plate Expires and the Official License Plate Has Not Been Issued Yet?

Temporary license plate has expired, and the official license plate has not been issued yet. You can reapply for a temporary license plate. Here is some knowledge about applying for a temporary license plate: 1. Application method: The owner only needs to bring their ID card, car purchase invoice, compulsory insurance policy (copy), original vehicle factory certificate, and copies, then go to the DMV window to apply for a temporary license plate, receive and fill out the application form, submit the relevant materials, and after review, you can pay a 5 yuan fee to receive the temporary driving license plate. 2. Definition of temporary license plate: A paper motor vehicle license plate that allows temporary road use of the motor vehicle, also known as a temporary driving license plate. It refers to a temporary vehicle driving certificate issued by the public security vehicle management department before the new vehicle is officially registered.
3
3
Share

What is the refund standard for failing the Subject 2 test?

There is no clear refund standard for the driving test, and it needs to be negotiated with the driving school based on the contract signed at the time of registration. The following is an introduction to the Subject 2 test: 1. Definition: Subject 2, also known as the small road test, is part of the motor vehicle driver's license assessment and is the abbreviation for the field driving skills test. The C1/C2 test items include five mandatory tests: reversing into a garage, parallel parking, stopping and starting on a slope, turning at a right angle, and driving on a curve (commonly known as the S-bend). Some areas also include a sixth item: high-speed card collection. 2. Reversing skills: Control the speed steadily: Keep the speed at a steady and very slow state. (Release the clutch slowly and steadily, avoid sudden lifting and continuous pressing and lifting). Correct steering technique: The method of turning the steering wheel must be correct, otherwise, it will be impossible to control the direction of the car's movement, not knowing how much to turn the wheel back or whether it has already been straightened.
2
2
Share

What needs to work together with airbags to be effective?

Airbags must be used in conjunction with seat belts to provide effective protection. Here is an introduction to airbag knowledge: 1. Definition: The electronic control safety airbag system is a passive safety protection system. When used together with seat belts, it can provide effective collision protection for occupants. In car collisions, airbags can reduce head injuries by 25% and facial injuries by about 80%. 2. Composition: Mainly consists of airbag sensors, collision safety airbags, and electronic control devices. The driver-side collision airbag is installed in the steering wheel; the passenger-side collision airbag is generally installed on the dashboard. Airbag sensors are installed on the left, right, and center of the cabin partition; the central airbag sensor and airbag system are installed together with the electronic control device.
4
5
Share

Will the car battery die if I leave the air conditioning on while parked?

Leaving the air conditioning on for an extended period while the car is parked can drain the battery. Here is some knowledge about car air conditioning: 1. Reasons for car battery drain: Because the air conditioning compressor is powered by the engine, when the car is turned off, the blower's natural air is powered by the battery. Excessive use of the blower can lead to long-term battery depletion. 2. Best practices for using car air conditioning: On hot summer days, you should first open the windows to ventilate the car, then turn on the air conditioning's external circulation to expel the hot air inside. After driving for a while and the interior temperature drops, you can close the windows and switch to internal circulation to achieve the coolest temperature most efficiently.
2
2
Share

Why is the car air conditioner cooling but with low air volume?

Reduced air volume in a car air conditioner is often caused by a clogged air filter. Below is an introduction to car air conditioning systems: 1. Air Conditioning Layout: Different types of air conditioning systems have varying layout methods. Currently, integrated heating and cooling air conditioning systems are widely used in passenger cars. Their layout involves assembling components such as the evaporator, heater core, centrifugal blower, and control mechanisms together, collectively referred to as the air conditioning unit assembly. 2. Air Conditioning Components: Modern air conditioning systems consist of a refrigeration system, heating system, ventilation and air purification devices, and a control system. A car air conditioner generally includes components such as the compressor, electronically controlled clutch, condenser, evaporator, expansion valve, receiver-drier, piping, condenser fan, vacuum solenoid valve, idle speed controller, and control system. Car air conditioning systems are divided into high-pressure and low-pressure lines. The high-pressure side includes the compressor output side, high-pressure lines, condenser, receiver-drier, and liquid lines; the low-pressure side includes the evaporator, accumulator, return lines, compressor input side, and compressor oil sump.
5
0
Share

What does the yellow parking space line mean?

Yellow lines indicate that vehicles can park temporarily or for an extended period in this area. Below is relevant information about parking space lines: 1. Definition: China's architectural standards for garages and parking lots are quite complex, divided into four levels. Although there is no specified "standard parking space size," minimum required dimensions are outlined. For example, vehicles with a length not exceeding 6 meters and a width not exceeding 1.8 meters should have a spacing of no less than 0.5 meters between vehicles and between vehicles and walls or the ends of parking spaces. For vehicles longer than 6 meters but not exceeding 8 meters, and wider than 1.8 meters but not exceeding 2.2 meters, the spacing between vehicles should be no less than 0.7 meters. 2. Advantages: Standardized parking lot markings help maintain order, reduce traffic accidents, and ensure safety. Additionally, during the marking process, it is essential to adhere to standard procedures and employ professional teams to guarantee quality.
12
0
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.