What is the wading depth of the Baojun e100?

2 Answers
OTaylor
07/29/25 5:34am
The maximum wading depth of the Baojun e100 is 130mm. The wading depth of the Baojun e100 is determined by the height of the vehicle's chassis, which corresponds to the ground clearance listed in the model's parameter configuration table. Generally, the greater the ground clearance, the higher the chassis, and the higher the safety factor when driving through waterlogged roads. Therefore, in terms of safe wading depth, off-road vehicles and SUVs have obvious advantages. However, for most compact and small vehicles with low chassis, the position of the vehicle's air intake should be used as a benchmark when passing through waterlogged roads. If the air intake of the Baojun e100 is below the water level during wading, water will be sucked into the engine's cylinders. Since water cannot be compressed like air, it will cause severe damage to the engine's mechanical components (such as connecting rods, pistons, crankshafts, etc.). Therefore, the wading depth must not exceed the height of the engine's air intake. The height of the engine's air intake, and thus the maximum wading depth, can be increased by installing a snorkel. If wading is unavoidable, the following safe and correct procedures should be followed: Before driving through water, always turn off the auto start-stop function to prevent the engine from automatically restarting if the vehicle stalls in the water, which could cause severe damage due to water ingestion. Assess the underwater road conditions based on the passage of preceding vehicles and choose an appropriate entry point. Observe the path taken by other vehicles and follow their tracks at a low speed, avoiding sudden acceleration or deceleration. For roads prone to flooding, use warning water level markers, trees, or the wheels and doors of other vehicles as reference points to estimate water depth before deciding whether to proceed. Know your vehicle's safe wading depth. If the water depth exceeds half the height of the tires or the engine's air intake, do not proceed and choose an alternative route instead.
Was this review help?
2
5
Share
LeAnna
08/12/25 9:08am
I've reviewed a lot of car data. The official manual of the Baojun E100 states that its wading depth is about 30 cm, which refers to the safe height of water accumulation the vehicle can pass through. This is mainly determined by the battery design, as its high-voltage battery is located under the chassis with limited waterproof rating. Exceeding this depth can easily cause short circuits or corrosion, leading to safety issues. In practice, it's recommended to use a ruler or simple tool to measure water depth to avoid estimation errors. Electric vehicles have better sealing than traditional fuel vehicles, but caution is still needed. Driving through water at high speed may damage wiring due to water pressure changes. In short, knowing this number is practical, and checking road conditions before traveling in the rain is necessary—don't take risks to save time.
Was this review help?
7
0
Share
Expand All
More Forum Discussions

Why Do Black Cars Show White Scratches?

Scratches damage the car's primer, resulting in white marks. Here are specific methods to avoid car scratches: 1. Drive cautiously: Follow traffic rules and maintain order while driving. Avoid forcing lane changes or squeezing through crowded areas during traffic jams. Patience helps protect your car from damage. 2. Choose parking spots wisely: Avoid parking in open areas where children might scratch the car. Also, try not to park in tight spaces to prevent other vehicles from scratching yours when maneuvering. If possible, consider purchasing a car cover to protect your vehicle from scratches.
12
4
Share

Is the Venucia Star a Joint Venture Car?

Venucia Star is not a joint venture car; it is a domestic vehicle. Below is relevant information about this model: 1. Introduction: The Venucia Star is an 'A+ class SUV first-class cabin' created by Dongfeng Venucia after ten years of accumulation and three years of refinement. It efficiently integrates the global technical resources of the Renault-Nissan-Mitsubishi Alliance and is based on the new 'Primordial Aesthetics' design concept and the VSA intelligent modular architecture. With 'global technology and joint venture quality as the brand connotation,' it is primarily targeted at the new first-tier light-middle-class population. 2. Intelligent Assisted Driving: In terms of intelligent assisted driving, the Venucia Star has also achieved breakthroughs. The intelligent assisted driving system, 3D-AVM panoramic monitoring imaging system, DVR intelligent driving recorder, and other configurations provide intelligent driving assistance. The standard BOSCH ESP 9.3 system includes 13 comprehensive active safety assistance configurations to ensure safe travel for consumers.
13
3
Share

What is the voltage of a car cigarette lighter?

The standard voltage for a car cigarette lighter is 12 volts. Below the car's center console, there is a push-button cigarette lighter. Press this button, wait 10 to 60 seconds, and the lighter will pop up with a slight sound as a reminder. At this point, pull out the lighter, press the inner side lightly against the cigarette to draw on the filter tip, and the cigarette will be lit. Insert the lighter back into the socket and release it upon hearing a click. Functions of the cigarette lighter: 1. It serves as a substitute for a lighter to light cigarettes in the car; 2. It can also be used as a charger, with one end being the cigarette lighter and the other end a USB port; 3. The car cigarette lighter can be used to power in-car DVD players.
16
4
Share

What Causes the Chery Tiggo 3 to Occasionally Fail to Accelerate?

Tiggo 3's unresponsive throttle may indicate an abnormality in the vehicle's power system. The engine's power is generated through the coordinated operation of the intake system, ignition system, and fuel system. If any of these components malfunction, it can lead to a decrease in engine power, resulting in symptoms such as unresponsive throttle, body shaking, or smoke from the exhaust. Below are relevant details: 1. Throttle: The throttle of a car engine, typically controlled by a pedal (also known as the accelerator pedal), is a device that regulates fuel supply to the engine. When operating the throttle pedal, place your right heel on the floor of the driver's compartment as a pivot, gently press the accelerator with the ball of your foot, and use ankle movements to press or release. Apply force softly, ensuring smooth and gradual pressing and releasing. 2. Precautions: When starting the engine, avoid pressing the throttle pedal all the way down; it's better to keep it slightly above the idle throttle. During startup, it's advisable to apply a bit of throttle just before the clutch engagement point, with the throttle opening kept at a moderate level. Coordinate the release of the clutch with pressing the throttle promptly and smoothly.
11
4
Share

What is the reason for the Geely Boyue failing to start and displaying communication loss?

Geely Boyue failing to start and displaying communication loss may be caused by engine oil circuit, electrical circuit, and mechanical faults. The specific explanations are as follows: 1. Oil circuit fault: The main fault is low gasoline pressure and poor atomization. 2. Electrical circuit fault: This is due to excessive spark plug electrode gap, reduced ignition energy from the ignition coil, or short circuit/open circuit in the cylinder wires. 3. Mechanical fault: For example, whether the valve is not tightly closed, or whether there is excessive carbon buildup inside the engine. The cold start injector will be absorbed by carbon deposits, resulting in a too-lean cold start mixture, making it difficult to start. When there is excessive carbon buildup inside the engine, gasoline will spray out of the cylinder. During cold start, the injector will be absorbed by carbon deposits, causing the cold start mixture to be too lean, making it difficult to start. It is not easy to start the car until the gasoline absorbed by carbon deposits is saturated. After the gasoline is sucked into the cylinder by the engine's vacuum suction and burned, the gasoline adsorbed on the carbon deposits burns, making the mixture rich. The engine's combustible mixture is sometimes lean and sometimes rich, causing idle shaking after cold start. Since lower temperatures require more oil for cold start, more carbon deposits will affect the smoothness of cold start.
16
5
Share

Can an old license plate be transferred to a new car?

Old license plates can be transferred to your own new car, but they cannot be transferred to another owner along with the vehicle. Below are the details for retaining a license plate: 1. The vehicle must have been used for at least one year to retain the original license plate, and the retention period can be up to 1 year; 2. The original license plate can be retained if the vehicle is transferred, deregistered, or relocated; 3. Both used and new car purchases are eligible to apply for plate retention. Below are the procedures for transferring a license plate to a new car: 1. First, go to the vehicle management office to complete the transfer, deregistration, or relocation of the original vehicle; 2. Request to retain the license plate during the transfer process and surrender your old plate; 3. After obtaining the new car, schedule an appointment with the vehicle management office to apply for continued use of the original license plate during the registration process.
18
4
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.