What is the wading depth of the 2021 Santana?

1 Answers
OLila
09/04/25 4:29am
The wading depth of the 2021 Santana is generally around 80 centimeters. Here are some precautions for driving through water: 1. Observe the water conditions: Pay attention to the water depth. Watch other vehicles driving through the water to determine if your vehicle can pass smoothly based on their water levels and positions. 2. Check the road surface: Use the path taken by other vehicles to identify shallow areas and avoid potholes. If there are no other vehicles to follow, you should get out and test the water depth yourself before proceeding. 3. Drive slowly through water: Always maintain a low speed. For manual transmission vehicles, it is recommended to use second or third gear depending on the water depth. In cases of deep water and heavy traffic, use first gear. 4. Avoid heavy acceleration: Rapid acceleration is not advisable. Many drivers, fearing stalling, press the accelerator hard to speed through, which often leads to more problems.
Was this review help?
4
2
Share
More Forum Discussions

What is the replacement interval for brake discs?

The replacement interval for brake discs is approximately when the vehicle has traveled 80,000 to 100,000 kilometers. The steps for replacing brake discs are: 1. Lift the vehicle and remove the tires; 2. Remove the bolts of the brake caliper, open the brake caliper, and take out the old brake pads; 3. Push the brake piston back in, install the new brake pads; 4. Reinstall the brake caliper, tighten the caliper bolts to the specified torque, and reinstall the tires; 5. Press the brake pedal several times to eliminate the gap between the brake pads and the disc, allowing the brake piston to reset; 6. Check if the brake fluid pump is functioning properly. Conditions for replacing brake discs include: 1. The thickness of the brake disc is less than the minimum maintenance standard allowed by the vehicle manufacturer; 2. The wear indicators on the brake disc come into contact with the disc; 3. The brake disc exhibits abnormal wear or tapered wear.
13
0
Share

What are the reasons for antifreeze spraying out due to high temperature in the car radiator?

Reasons for antifreeze spraying out due to high temperature in the car radiator: 1. Reason one: There is air in the engine cooling system pipeline. 2. Reason two: The radiator cap or overflow tank cap is damaged. 3. Reason three: Partial blockage in the cooling system pipeline. 4. Reason four: Cylinder head gasket damage causing cylinder blow-by. The following is an introduction to antifreeze: 1. Introduction to antifreeze: Antifreeze is a coolant containing special additives, mainly used in liquid-cooled engine cooling systems. Antifreeze has excellent properties such as preventing freezing in winter, preventing boiling in summer, preventing scale and corrosion all year round. 2. Functions of antifreeze: The engine and its cooling system are made of metals, including copper, iron, aluminum, steel, and solder. These metals, when in contact with water under high temperatures for a long time, will corrode and rust. Antifreeze not only does not cause corrosion to the engine cooling system but also has anti-corrosion and rust-removing functions.
2
5
Share

Is the Vehicle Environmental Protection Label Still Required in 2021?

In 2021, the vehicle environmental protection label has been merged with the annual vehicle inspection label, and it must be displayed on the vehicle. Additional information is as follows: 1. Specific details: The latest regulations state that the environmental protection inspection and annual vehicle inspection labels have been combined into one. This means that a single label now signifies both the vehicle's passing of the annual inspection and its compliance with environmental protection standards. As a result, vehicles only need to pass the annual inspection and no longer need to obtain a separate environmental protection label. 2. Penalties for not displaying the inspection label: According to Article 95 of the 'Road Traffic Safety Law of the People's Republic of China,' driving a vehicle without displaying the inspection qualification label will result in a fine and a deduction of 1 point. In severe cases, the traffic management department of the public security organ may impound the vehicle and require the owner to provide the corresponding license, label, or complete the necessary procedures. For vehicles within the first 6 years, the owner must apply for the annual inspection label every two years at the vehicle management office, or they can apply online. Vehicles older than 6 years must undergo an annual inspection and obtain the label each year. For vehicles older than 15 years, a semi-annual inspection is required to ensure the vehicle meets road standards.
6
1
Share

What Causes Loud Tire Noise While Driving?

Tire noise is primarily related to tread pattern design, tire hardness, and road surface smoothness. The detailed explanations are as follows: 1. Tire tread design includes the arrangement of tread pitch, direction and depth of tread grooves, etc. These factors affect the air flow between tread gaps and the air noise generated by disturbances around the tire; 2. Tire vibration noise caused by vibrations in the tire body and tread sections, especially with harder tire materials which tend to produce louder noise; 3. Road noise caused by uneven road surfaces, particularly when driving on bumpy roads. The friction and impact between the tread and the ground generate noise, which resonates with vibrations from components like fenders and wheel arches, amplifying the noise inside the vehicle.
15
3
Share

Is Manual Transmission Cruise Control Easy to Use?

Car cruise control is a very practical onboard tool. More detailed introduction about cruise control is as follows: 1. Cruise control (CRUISE-CONTROL-SYSTEM), also known as speed control system or autonomous driving system, functions by maintaining the vehicle speed as set by the driver without the need to press the accelerator pedal, allowing the vehicle to travel at a constant speed. 2. With this device installed, drivers no longer need to manually control the speed during long-distance highway driving, reducing fatigue and unnecessary speed changes, which can also save fuel.
4
2
Share

What to Do When the Car Windshield Doesn't Clean Properly?

Solutions for a car windshield that doesn't clean properly are as follows: 1. Check if the windshield wipers are aged or damaged, which may cause the front windshield to not clean properly. If the wipers are aged, they need to be replaced. If the wipers are still effective and show no signs of aging, extending their usage time might be acceptable. However, the most important factor is the condition of the wipers themselves. If they are less than a year old but already show significant cleaning issues during operation, replacement is necessary. 2. Alternatively, you can use toothpaste or a cleaning agent. Apply a small amount of toothpaste or cleaning agent to the stained areas, then gently wipe with a soft towel dampened with water to easily clean the windshield.
2
1
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.