What is the wading depth of the 10th-generation Accord?

1 Answers
MacTravis
07/30/25 12:54am
The maximum wading depth of the 10th-generation Accord is 350-400mm. The wading depth of the 10th-generation Accord is determined by the vehicle's ground clearance, which is listed in the model's parameter configuration table. Generally speaking, the greater the ground clearance, the higher the chassis, and the higher the safety factor when passing through waterlogged roads. Therefore, in terms of safe wading depth, the advantages of off-road vehicles and SUVs are obvious. However, for most compact and small cars with low chassis, the position of the vehicle's air intake should be used as a reference when passing through waterlogged roads. If the air intake of the 10th-generation Accord is below the water level during wading, water will be sucked into the engine's cylinders. Since water cannot be compressed like air, it will cause serious damage to the engine's mechanical structure (connecting rods, pistons, crankshaft, etc.). Therefore, the wading depth should not exceed the height of the engine's air intake. The height of the engine's air intake, and thus the maximum wading depth, can also be increased by installing a snorkel. If wading is unavoidable, the following safe and correct operations should be performed: Before wading, always turn off the automatic start-stop function to prevent the vehicle from automatically restarting after stalling in water, which could cause serious damage to the engine due to water intake; Judge the underwater road conditions based on the passage of the vehicle ahead and choose a suitable entry point. Observe the path taken by other vehicles and follow their tracks at low speed, avoiding sudden acceleration or deceleration; On roads prone to water accumulation, observe warning water level markers, trees, and reference points such as the wheels and doors of other vehicles to judge the water depth before deciding whether to proceed; Understand your vehicle's safe wading depth. If the water depth exceeds half of the tire height or the engine's air intake, do not enter the water rashly; choose an alternative route instead.
Was this review help?
2
5
Share
More Forum Discussions

Is the headlight turned on in Subject Three the low beam?

Headlights refer to the vehicle's high beam, low beam, and turn signals, with the low beam being a part of the headlights. When using a car, the requirements for headlights are: They must provide good illumination while avoiding dazzling oncoming drivers. Keep the headlight lens clean: Especially when driving in rain or snow, dirt and grime can reduce the headlight's illumination performance by up to 50%. Some vehicle models are equipped with headlight wipers and washers. When two vehicles meet at night: Both vehicles should switch from high beam to low beam when they are 150 meters apart to ensure driving safety. To maintain the performance of the headlights: After replacing the headlights or every 10,000 kilometers driven, the headlight beam should be checked and adjusted. Regularly inspect the bulbs, wiring sockets, and grounding for oxidation or looseness: Ensure that the connectors have good contact and the grounding is reliable. If the connections are loose, turning on the headlights may cause current surges due to circuit interruptions, which can burn out the filaments. If the connections are oxidized, the brightness of the bulbs may decrease due to increased voltage drop at the connections.
19
5
Share

Where is the trunk switch located on the old Audi A6?

Audi A6's trunk switch is located in the middle of the rear license plate. The specific position is inside the groove right below the four rings. Three methods to open the trunk of Audi A6: Directly open with the remote key: The remote key can also open the trunk (after the engine is turned off and the key is pulled out). Press and hold the "car logo" button in the center of the remote key for 3 seconds (the one between the unlock and lock buttons), and the trunk will automatically unlock, but it won't open directly. You still need to lift it manually. Open with the mechanical key: There is a keyhole above the license plate. Insert the key, turn it to unlock, and then lift the trunk lid. Press the unlock button directly: Press the unlock button directly (in the middle of the rear license plate), and the trunk will also unlock and open. Precautions for using the trunk: Be cautious when closing the trunk lid to ensure no one is between the lid and the trunk to avoid injury. After closing the trunk lid, check whether it is properly closed and locked to prevent the lid from suddenly opening while driving. The closed trunk lid should be flush with the surrounding body.
20
0
Share

Do pure electric vehicles require annual inspection?

Pure electric vehicles require annual inspection. Electric vehicles are also licensed motor vehicles, which are inspected every two years within the first six years, and once a year after exceeding six years. Documents required for pure electric vehicle annual inspection: "Motor Vehicle Inspection Mark Application Form" (no need to bring, provided on-site for direct filling). Motor vehicle driving license. Compulsory traffic insurance certificate. Vehicle and vessel tax payment or tax exemption certificate (usually purchased together with compulsory insurance and can be found in the compulsory insurance policy; if not found, inquire with the insurance company, as some regions may handle this separately). Owner's ID card. If handled by someone else, the agent must bring their own ID card. Regulations for vehicle annual inspection: Operational passenger vehicles are inspected once a year within five years, and once every six months after exceeding five years. Trucks and large and medium-sized non-operational passenger vehicles are inspected once a year within ten years, and once every six months after exceeding ten years. Motorcycles are inspected once every two years within four years, and once a year after exceeding four years. After exceeding six years, private vehicles with nine seats or less within ten years are relaxed from annual inspection to biennial inspection. That is to say, private vehicles within ten years only need to undergo online inspections in the sixth and eighth years.
19
1
Share

What are the key reference points for automatic transmission right-angle turns?

There are four techniques for automatic transmission right-angle turns. Technique 1: Keep the right side of the vehicle close to the outer right-angle edge line while moving forward. When the midpoint between the triangular windows of the left and right front doors aligns with the inner and outer right-angle lines, turn the steering wheel fully left or right, then straighten when the vehicle is aligned. Technique 2: Proceed in first gear without accelerating; stay as close as possible to the right boundary line during the turn. When the seatbelt anchor point inside the cabin passes the corner, turn the steering wheel sharply left until fully locked. When the front of the car aligns with the exit, quickly straighten the wheel to prepare for the next right-angle turn. Technique 3: Proceed in first gear without accelerating. When entering the test area, stay close to the right curb. Once the front curb is obscured by the hood, turn the steering wheel sharply left until fully locked. When the front of the car aligns with the exit, quickly straighten the wheel. Technique 4: Before entering the right-angle turn, drive slowly while keeping the vehicle as far as possible from the turning point marker between the boundary lines. When the center of the small triangular window on the side closest to the turning point aligns with the turning point, turn the steering wheel fully toward that side. After passing through, straighten the wheel when the front of the car is aligned.
15
3
Share

What is the sequence of turning on lights for the wet road surface in Subject 2?

Subject 2 wet road surface light sequence includes turning on high beams, fog lights, width indicator lights, hazard lights, and wipers. Below are the techniques for turning on lights on wet road surfaces in Subject 2: Slow down the vehicle: Shift to 1st gear and steadily enter the test area. When entering muddy roads, drive at low speed, adjust direction to keep the decorative strips inside the yellow line. Remember to slow down and avoid crossing the line. Maintain steady speed: Try to maintain a stable and uniform speed throughout the route to avoid speed changes or body vibration issues, and do not stop, otherwise it is easy to be judged as unqualified. Listen to the voice prompts and stay calm: When the front of the car crosses the finish line, you will hear the voice assistant say "This project is over". At this time, you must drive steadily within 5 seconds and turn off all lights and wipers. Also, do not remove your hands from the steering wheel. Do not be nervous about additional test items, the most important thing is to adjust your mindset. Before getting in the car, you can wipe the rearview mirror and windows clean, and do not close the windows too tightly to prevent fogging. Controlling the speed slower will reduce tension and give yourself enough time to think and prepare.
18
4
Share

What are the questions about drunk driving in Subject One?

There are many questions about drunk driving in Subject One. Below is a detailed introduction to the standards for drunk driving and the penalties for drinking and driving. Standards for drunk driving: Criteria for determining drunk driving: A driver's blood alcohol content is greater than or equal to 80mg/100mL. According to the national "Threshold and Test for Blood and Breath Alcohol Content of Vehicle Drivers," a driver with a blood alcohol content of 20-80mg per 100 milliliters is considered driving under the influence, while a content above 80mg is classified as drunk driving. Breathalyzer tests are not included in drunk driving identification. Following the standards for criminal evidence collection, drivers suspected of drunk driving must undergo blood tests for evidence. The alcohol monitoring instrument data during drunk driving checks is only a preliminary method for traffic police to determine drunk driving. A conclusive identification is made by comparing the suspect's blood alcohol content. Penalties for drinking and driving: According to the new traffic law: Driving under the influence of alcohol results in the temporary suspension of the motor vehicle driver's license for one to three months, a fine, and 6 demerit points. The legal penalties for driving commercial motor vehicles under the influence of alcohol are more severe: Driving under the influence results in the temporary suspension of the motor vehicle driver's license for three months, a fine, and 12 demerit points.
9
1
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.