What is the vehicle painting process?

What causes the ABS light to illuminate on the dashboard?

ABS light illumination can occur in various states, with different causes and solutions for each state. The details are as follows: State 1: ABS warning light stays on constantly (most common). Cause 1: The ABS speed sensor's sensing part is covered by dirt, mud, or other contaminants, affecting the sensor's ability to detect the corresponding speed signal. This prevents the ABS computer from determining the vehicle's speed or the wheel's slip rate, thus failing to issue appropriate commands to regulate braking. Solution: Clean the dirt from the speed sensor and adjust the gap between the sensor and the signal ring to restore normal function. Cause 2: Poor signal transmission due to loose connections in the system wiring or poor contact in the ABS relay, leading to system failure. Solution: Check the wiring connections and reconnect any loose parts. State 2: ABS warning light intermittently illuminates but turns off when accelerating. Cause: When multiple electrical devices are in use, the battery voltage drops below 10.5V. The ABS light turns off as the engine speed increases and voltage rises. This may also occur if the ABS system's power supply voltage is too low due to poor terminal contact or grounding issues. Solution: Check the battery's specific gravity, inspect the charging system, and examine the power supply (e.g., voltage relay or poor power contact). State 3: ABS warning light stays on after engine start and only turns off when the engine is turned off (IGFF). Cause: Poor grounding contact in the ABS hydraulic valve body; poor contact in the ABS hydraulic valve body's wiring connector; ABS computer malfunction. Solution: Loosen and retighten the grounding screw of the hydraulic valve body, cleaning the contact surface if necessary. Check if the connector gap has widened. Replace the ABS or ABS/ASR computer if needed. State 4: ABS warning light illuminates during high-speed driving. Cause: During high-speed driving, the ABS computer detects a significant discrepancy between the rear and front wheel speed signals. This may also occur due to incorrect tire or wheel rim specifications. Solution: Refer to the vehicle's tire and wheel rim specifications, as indicated on the label near the fuel tank cap. State 5: ABS warning light intermittently illuminates. Cause: Improper adjustment of the brake light switch; poor internal contact in the brake light. Solution: With the engine running, press the brake pedal and use a finger to push the brake switch linkage all the way down. Release the brake pedal to complete the self-setting position. Replace the brake light switch if necessary. If the ABS warning light is on, it is advisable not to continue driving. An illuminated ABS light indicates a malfunction in the vehicle's anti-lock braking system. During emergency braking, if the wheels lock up, the vehicle may skid uncontrollably, making it difficult for the driver to slow down or adjust the vehicle's trajectory, posing significant safety risks.

8

5

Share

Does the Volkswagen Jetta have a sunroof?

Volkswagen Jetta does not have a sunroof. It is a compact car with a body length of 4501 mm, width of 1704 mm, height of 1469 mm, a wheelbase of 2604 mm, minimum ground clearance of 109 mm, maximum speed of 181 km/h, and a curb weight of 1120 kg. The Volkswagen Jetta is equipped with a 1.4L naturally aspirated engine, delivering a maximum horsepower of 90 hp, maximum power of 66 kW at 5500 rpm, maximum torque of 132 Nm at 3800 rpm, and features multi-point fuel injection.

17

2

Share

What is the engine displacement of the Jetour X70M?

Jetour X70M's engine displacement is 1.5 liters, with a turbocharged intake form, delivering a maximum horsepower of 156 hp, a maximum power of 115 kW at 5500 rpm, and a maximum torque of 230 Nm between 1750 rpm and 4000 rpm. It is paired with a 6-speed manual transmission. The dimensions of the Jetour X70M are 4755 mm in length, 1885 mm in width, and 1695 mm in height, with a wheelbase of 2745 mm and a fuel tank capacity of 55 liters. It features a MacPherson independent front suspension and a multi-link independent rear suspension.

7

4

Share

What is the solution for vehicle CO failure?

Vehicle CO failure solutions are as follows: 1. Replace spark plugs. Both new and old ones are acceptable, as long as the electrode points are cleaned with sandpaper and the gap is properly adjusted. 2. Adjust ignition timing. Delaying the ignition timing will significantly reduce CO content in the exhaust. Since the ignition time is delayed, the combustion time in the combustion chamber will be shortened, the maximum combustion temperature will decrease, and the emissions of hydrocarbons and nitrogen oxides will be reduced. 3. Clean the distributor contacts and distributor rotor contacts. 4. Clean the three-way catalytic converter and oxygen sensor. 5. Add half a tank of E10 ethanol gasoline. Ethanol has a high oxygen content, which aids combustion.

2

4

Share

Is Jetta a Joint Venture or Domestic Brand?

Jetta is a joint venture brand, established by the German Volkswagen Group in China. It belongs to FAW-Volkswagen Automotive Co., Ltd. The dimensions of the vehicle are 4416mm in length, 1668mm in width, and 1438mm in height, with a wheelbase of 2471mm. It features front-wheel drive, a trunk capacity of 442 liters, and a fuel tank capacity of 55 liters. The braking system consists of front discs and rear drums. In terms of interior design, the dashboard is inclined towards the driver's side, and the display adopts a tilted design for easier viewing of vehicle information. Most surfaces are covered with soft materials, complemented by silver trims and stitching, enhancing the overall premium feel of the car.

12

3

Share

What to Do If the One-Key Start Key of Emgrand Is Lost?

Nowadays, most car keys use chips, which are part of a magnetic chip system. The solutions for a lost one-key start key of Emgrand are as follows: 1. Contact a repair station to get a new key. Depending on the vehicle model, the repair station may require the owner to provide a 17-digit anti-theft code for key configuration. This code is not the key's tooth shape number but the one provided to the owner when purchasing the new car. 2. Ask the repair station to replace the entire car lock. Choosing to replace the key alone still carries the risk of losing items inside the car, so replacing the lock completely eliminates this risk. However, the cost is much higher than that of getting a new key.

5

3

Share

What is the vehicle painting process?

What causes the ABS light to illuminate on the dashboard?

Does the Volkswagen Jetta have a sunroof?

What is the engine displacement of the Jetour X70M?

What is the solution for vehicle CO failure?

Is Jetta a Joint Venture or Domestic Brand?

What to Do If the One-Key Start Key of Emgrand Is Lost?

How to Replace the Battery in a Car Remote?

What are the differences between Nissan Sunny and Sylphy?

What is the best engine oil for Geely Boyue?

What are the effects of not changing engine oil for a long time?