What is the vehicle and vessel tax for a 2.4L displacement vehicle?

1 Answers
BeckettAnn
07/28/25 2:09pm
The vehicle and vessel tax for a 2.4L displacement vehicle ranges from 720 to 900 yuan per year. More information about the vehicle and vessel tax is as follows: 1. The vehicle and vessel tax not only varies depending on the size of the vehicle's displacement, but also has different tax standards for vehicles with the same displacement in different regions. 2. Across the country, the vehicle and vessel tax is calculated based on displacement and vehicle type. The larger the displacement, the higher the vehicle and vessel tax. There are mainly five types of vehicles: passenger cars, commercial vehicles, trailers, other vehicles, and motorcycles. Among them, passenger cars are categorized based on the total engine cylinder volume (displacement).
Was this review help?
11
3
Share
More Forum Discussions

How to turn on the headlights of a Polo?

The method to turn on the headlights of a Polo is: rotate the left low beam button to the low beam position to activate the low beams. Press the left lever on the steering wheel downward to switch to high beams, return it upward for low beams, and push it further upward to alternate between low and high beams (flashing). Taking the 2019 Polo as an example, its body dimensions are: length 4053mm, width 1740mm, height 1449mm, with a wheelbase of 2564mm. The 2019 Polo features a MacPherson strut front suspension and a torsion beam rear suspension. It is equipped with a 1.5L naturally aspirated engine, delivering a maximum horsepower of 113PS, maximum power of 83kW, and maximum torque of 145Nm, paired with a 5-speed manual transmission.
14
3
Share

What are the causes of the Q5 sunroof rattling noise?

The causes of the Q5 sunroof rattling noise are: 1. Aging of the sunroof rubber seal or sealing ring; 2. Loose sunroof screws or malfunctioning lifting mechanism; 3. Dust particles in the sunroof sliding track. The maintenance methods for the car sunroof are: 1. Clean the sunroof drainage channel promptly and regularly wipe the sunroof guide rails with a damp sponge; 2. Apply silicone oil to the sunroof seal after washing the car, which can effectively prevent the aging of the rubber seal and extend its service life. The solutions for sunroof rattling noise are: 1. Check the sunroof sliding track and add lubricating oil; 2. Tighten the sunroof screws; 3. Replace the rubber seal or sealing ring, and spray rubber conditioner on the seal.
9
1
Share

What are the precautions for stopping and taking the card in Subject 2?

Here are the precautions for stopping and taking the card in Subject 2: 1. Avoid crossing the line: When entering the stop-and-take-card section, in addition to looking at the front of the car and aligning the body, you should also pay attention to the rearview mirror to prevent the rear wheels from crossing the line. 2. Find the right position: During the test, control the speed, find the correct stopping position, and stop in time. Otherwise, if you miss the correct position, you will not be able to take the card (swipe the card), or if you reverse to adjust, you will fail. 3. Control the distance: Just like parallel parking, the stopping position for stopping and taking the card must also be controlled well. You cannot cross the line, but you cannot be too far away either. If it exceeds 50cm, you will lose 100 points.
4
4
Share

What is the purpose of installing a shark fin on a car?

Installing a shark fin on a car can enhance signal reception. Functional shark fin antennas need to be connected to the car's internal wiring and can integrate various powerful automotive electronic functions such as FM, GPS, and GSM, replacing and surpassing traditional rod antennas. Decorative shark fin antennas can also release static electricity and improve signal reception. Steps for installing a shark fin antenna: 1. Wrap the shark fin antenna with 3M tape, ensuring it is as flat as possible. 2. Remove the light on the rear seat of the car and take off the antenna base. 3. Determine and mark the correct position for the shark fin antenna. 4. Apply glue around the inner edge of the installation position, then peel off the tape on the shark fin antenna and align it to the marked position. 5. After installation, secure the shark fin with tape and remove the tape after 24 hours.
11
4
Share

How to Remotely Start a Car?

To remotely start a car, follow these steps: Aim the key at the vehicle and press the lock button on the key. Within 5 seconds, hold down the remote start button on the key for at least 4 seconds, or until the vehicle's turn signals flash. The parking lights will illuminate and remain on while the engine is running. After entering the vehicle during a single remote start session, press the brake pedal and turn the ignition switch to the ON/RUN position to drive the vehicle. Additional information about remotely starting a car is as follows: 1. The car's smart keyless entry system, abbreviated as PKE, utilizes the world's most advanced RFID radio frequency technology and vehicle identity coding recognition system. It pioneers the development of compact, low-power RF antenna solutions and successfully integrates remote control and keyless systems. 2. This system maintains traditional vehicle circuit protection, truly achieving a dual RF system and dual anti-theft protection, providing maximum convenience and security for car owners.
12
3
Share

Is It Illegal to Install a Rear Spoiler on a Car?

Installing a rear spoiler on a car is not illegal. Here is more information about car spoilers: Introduction to Car Spoilers: A car spoiler refers to the ducktail-like protrusion installed at the rear end of the car's trunk lid. It is part of the car's aerodynamic kit and primarily functions to reduce lift at the rear of the vehicle. Important Notes: When modifying a spoiler, the car owner must file a record with the vehicle management office in advance. After the modification is completed, the owner must also take new photos to update the images on the vehicle registration certificate. Functions: It effectively reduces the air resistance generated when the car is driving at high speeds. It offsets some of the lift, controls the car's upward float, reduces the impact of wind resistance, improves driving stability, and enhances the car's aesthetic appearance.
18
3
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.