What is the tutorial for replacing the transmission oil of Excelle?
3 Answers
The tutorial for replacing the transmission oil of Excelle is: 1. Unscrew the drain nut at the bottom of the transmission, drain the transmission oil inside, and then tighten it; 2. Open the driver's door and pull the engine hood switch, lift the engine hood, then open the transmission oil cap, and add transmission oil until it reaches the middle between the upper and lower scale lines. The Excelle is a 4-door, 5-seater compact sedan with body dimensions of 4468mm in length, 1765mm in width, and 1469mm in height, with a wheelbase of 2611mm. It is equipped with a 1.3L naturally aspirated engine, paired with a 5-speed manual transmission.
I recommend starting the Buick Excelle transmission fluid change with preparatory work: ensure the vehicle is on level ground, warm up the engine for a few minutes to thin the oil, then turn it off. Prepare a jack to lift the vehicle and secure it with jack stands for safety. Wear gloves and goggles, locate the transmission drain plug at the bottom, and use a wrench to loosen it, allowing the old fluid to drain into a catch pan. After fully draining, reinstall the plug with a new gasket and check for leaks. Then, locate the fill hole and add the specified type of new fluid, such as the model recommended in the manual, using a small funnel to slowly pour it in until the dipstick reaches the full mark. Once completed, start the engine and let it idle in neutral for a few minutes to check the fluid level and for any leaks. It is recommended to change the fluid every 60,000 kilometers to ensure smooth transmission operation, extend its lifespan, and avoid costly repairs. DIYers should pay attention to tool selection and environmentally friendly disposal of the old fluid.
As a DIY enthusiast, changing the transmission fluid for my Excelle was quite interesting: buy a bottle of compatible transmission fluid and prepare tools like a jack, wrench, and oil drain pan. For safety, park on level ground, turn off the engine, and wait for the oil to cool down a bit for easier operation. Use the jack to lift the vehicle and secure it, then unscrew the drain bolt at the bottom of the transmission to drain the old fluid completely, avoiding splashes. After cleaning, tighten the bolt and slowly pour new fluid through the fill hole, not exceeding the specified amount. Start the engine and let it idle for a few minutes, then check the dipstick to ensure the fluid level is within the normal range—job done. The whole process takes about half an hour, saving on repair costs while learning a new skill. Regular fluid changes keep the car running smoother.
