What is the tutorial for replacing the air filter element of the Sagitar?

1 Answers
DiRicardo
07/29/25 12:04pm
The air filter element of the Sagitar is located in the air filter box above the engine. Use a cross screwdriver to remove the four screws, take off the air filter element cover, and there is also a clip inside, which can be removed with a screwdriver to replace the new one. The recommended replacement cycle is once a year. If you often drive on roads with haze or construction sites, it should be replaced in advance. Daily inspection can check its dirtiness, and the replacement should be based on the cleaning condition. Related introductions are as follows: 1. Generally speaking, how often the car air conditioning filter element is replaced depends on the usage. For general urban household cars, it can be replaced every six months or once a year. 2. If you usually drive on roads with a lot of dust, more dust will enter the car, which will make the air conditioning very dirty. Some users also like to park under big trees or temporarily park near trees. The fruits of the trees will fall on the air inlet of the air filter element, which will also make the air filter very dirty and need to be replaced in advance.
Was this review help?
14
5
Share
More Forum Discussions

What to Do When a Car Won't Start After Being Parked for a Long Time?

If this happens, you can ask a friend with a car to come over and jump-start the engine. After starting the engine, the generator will operate, and it can then charge the battery. If the battery is severely depleted, it is recommended to use a professional charger to recharge the battery.
4
2
Share

How to Close a Car Sunroof?

Make sure your vehicle's ignition is turned on, or start the vehicle directly. Turn the car key once to activate the ignition, at which point the dashboard will light up, indicating that the electrical circuit is active. Then, manually rotate the sunroof control switch counterclockwise until it reaches the edge where there is a black vehicle emblem. When you see the "0" marking, the electric sunroof will automatically slide back to its original position.
12
0
Share

What is the simplest method for car window tinting?

Preparations before car window tinting, including cleaning and interior protection installation. To prevent tiny impurities during the tinting process, a full-body car wash is typically performed before window tinting. It's essential to protect the car's interior, especially for new vehicles, as the tinting process may inevitably dirty the interior, so proper preparations should be made.
17
4
Share

What to Do When Car Tail Lights Stay On?

Car tail lights staying on may be caused by a short circuit in the brake switch, requiring replacement of the brake switch. If it is not a fault with the car's brake light switch, it could be an issue with the car's electrical circuit. In such cases, the car owner should not attempt to fix it themselves and should instead seek professional assistance at a 4S shop or a specialized repair shop.
15
1
Share

What are the steps for car window tinting?

Preparation before car window tinting: cleaning and installing interior protection. To prevent tiny impurities during the tinting process, the entire car is usually thoroughly cleaned before window tinting. It's essential to protect the car's interior, especially for new cars, as the tinting process may inevitably dirty the interior, so preparatory work is necessary.
13
0
Share

How to Deal with Unqualified HC in Vehicle Exhaust?

Replace with higher-grade gasoline, as higher-grade gasoline is cleaner. The content of harmful gases CO, NO, and HC after combustion is significantly reduced. You can refuel with higher-grade gasoline to purify the exhaust, making it easier to pass the annual inspection.
14
5
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.