What is the Toyota Aqua called in China?

1 Answers
VeraLee
07/29/25 5:32pm
Toyota Aqua is called Prius in China. The following is an introduction to the Prius: 1. Vehicle Overview: The Toyota Prius, launched by Toyota Motor Corporation of Japan in 1997, was the world's first mass-produced hybrid vehicle model. It was subsequently sold to more than 40 countries and regions worldwide in 2001, with its largest markets being Japan and North America. 2. Design Philosophy: Before the energy crisis and environmental issues became prominent, TOYOTA foresightedly incorporated hybrid technology development into its long-term plans. After over 40 years of dedicated effort, the Prius was the first to perfectly execute avant-garde design concepts with future-oriented craftsmanship, and it also led the era by incorporating a series of highly intelligent technologies.
Was this review help?
13
1
Share
More Forum Discussions

Can I change lanes on my own during Subject 3?

Subject 3 allows for independent lane changes, which is also one of the assessment items in the road test. Here are some techniques for changing lanes on your own: Timely use of turn signals: Before changing lanes, you must turn on the turn signal for at least 3 seconds to alert the vehicles behind you and avoid rear-end collisions. Observe traffic conditions: After turning on the turn signal, do not rush to the next step. First, check the surrounding traffic conditions through the rearview mirror, and also look back to observe the lane you are about to enter. Only proceed with the turn after confirming safety. Decisive lane change: Once everything is observed, the next lane change operation should be carried out quickly, and the steering should not be excessive. Avoid hesitation when changing lanes, as this can cause trouble for the vehicles behind. Turn off the turn signal: After completing the lane change, remember to turn off the turn signal.
19
2
Share

What are the conditions for the combined examination of Subject 2 and Subject 3?

As long as the required training hours are completed, current driving test regulations allow simultaneous scheduling of Subject 2 and Subject 3 examinations. Below are detailed introductions to Subject 2 and Subject 3: Subject 2: Also known as the small road test, it is part of the motor vehicle driver's license assessment, specifically referring to the field driving skills examination. For small vehicles (C1/C2), the test items include five mandatory components: reverse parking, parallel parking, hill start, right-angle turns, and curve driving. Subject 3: Also known as the big road test, it is another part of the motor vehicle driver's license assessment, specifically referring to the road driving skills and safety-conscious driving knowledge examination in the driver's test.
13
3
Share

What are the techniques for left and right turns in Subject Three of the driving test?

Subject Three left turn techniques are as follows: When making a left turn at an intersection, you should slow down in advance and enter the left turn lane (if there is a left turn waiting area, enter it when the traffic light turns green) or wait on the left side of the road. When the traffic light turns green or the green left turn arrow lights up, promptly observe the traffic conditions ahead and to the side or check the left and rear traffic conditions through the interior and exterior rearview mirrors. At the same time, pay attention to whether there are right-turning vehicles from the opposite direction encroaching on your path to ensure a safe turn. Subject Three right turn techniques are as follows: Right turns must be made from the right lane, and the speed should not exceed 30 km/h. Observe the traffic conditions on both sides of the intersection.
9
4
Share

What does it mean to drive without following the examiner's instructions in Subject 2?

It means not following the examiner's instructions, resulting in a test failure. Here is the relevant information: Test standards: Each item is scored out of 100, and a score of 80 or above is required to pass. Passing all five items with scores above 80 means passing Subject 2. The full score for Subject 2 is 100. For large buses, tractors, city buses, medium-sized buses, and large trucks as the permitted vehicle types, a score of 90 or above is required to pass. For other permitted vehicle types, a score of 80 or above is required to pass. Test items: The test includes parallel parking, stopping and starting on a slope, right-angle turns, curve driving (S-curve), and reversing into a garage. The full score is 100, and the passing standard is 80. Each Subject 2 test has two attempts. There are evaluation standards for failure, deduction of 20 points, deduction of 10 points, and deduction of 5 points.
18
1
Share

What is the top speed of the Benelli 302s?

The top speed of the Benelli 302s is 160km/h. Below is a related introduction of this motorcycle: Appearance: The design features a streamlined profile, with an overall youthful and dynamic style. The front section is quite sharp, exuding a street bike's temperament, and the well-proportioned side lines extend from the head to the tail. Power System: Equipped with a 300cc twin-cylinder water-cooled engine, delivering a maximum torque of 25.6 Nm and a maximum output horsepower of 36Ps. It uses a mainstream fuel injection system, offering outstanding performance, stability, and reliability. The six-speed chain transmission system ensures smooth and orderly gear shifts without any lag.
7
2
Share

What is the principle of self-sealing liquid?

Tire self-sealing liquid can repair tires because it contains rubber fiber particles and adhesive components. When there is a puncture in the tire, the rubber fiber particles in the self-sealing liquid will fill the hole, and the adhesive will quickly bond the particles. Utilizing the pressure difference between the inside and outside of the tire, the rubber fibers tightly adhere to the inner wall of the tire, achieving the purpose of sealing the puncture. Here is additional information: Tire self-sealing liquid is an automatic tire repair solution used to prevent slow air leakage and seal holes in tires. The self-sealing agent is injected into the tire through the valve stem in a certain amount, and then the tire is fully inflated.
19
2
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.