What is the torque of the Changan CS55?

1 Answers
KiaraFitz
07/29/25 9:38pm
Changan CS55 has a maximum torque of 225 Nm. Here is an introduction to the Changan CS55: 1. The 1.5-liter turbocharged engine used in the Changan CS55 has a maximum power of 115 kW and a maximum torque of 225 Nm. The maximum power speed is 5500 rpm, and the maximum torque speed ranges from 2000 to 4000 rpm. This engine is equipped with VVT technology and multi-point electronic fuel injection technology, and uses an aluminum alloy cylinder head and block. 2. The engine is paired with either a 6-speed manual transmission or a 6-speed automatic transmission. 3. The front suspension of this car uses a MacPherson independent suspension, and the rear suspension uses a multi-link independent suspension. 4. The Changan CS55 is only available in front-wheel drive models, with no four-wheel drive options available.
Was this review help?
11
1
Share
More Forum Discussions

How to Drive an Automatic Transmission Car on a Slope?

When driving uphill, automatic transmission vehicles can select gears such as L, M, S, 1/2/3 (or 1/2), and +/-. Additionally, maintain the engine speed at a higher RPM (above 3000) to ensure sufficient torque output for easier uphill driving.
5
1
Share

What to Do When You Scratch Someone Else's Car?

When taking photos, be mindful of passing vehicles nearby. After taking photos, immediately notify the car owner and have them come to the scene to assess the accident damage. If the responsibility is clear, send the photos to the insurance company. If the responsibility is unclear, call the traffic police to determine liability and report the incident to the insurance company to assess the vehicle damage.
14
4
Share

How to Remove the Steering Wheel of a Haima M6?

Use two flathead screwdrivers to insert into the holes at the back of the steering wheel in the opposite direction, and simultaneously apply force to release the airbag clamp, then unplug the airbag connector. Then remove the internal fixing screws to disconnect the steering wheel combination plug, and pull out the steering wheel horizontally.
6
5
Share

How to Use the Highlander Rear Wiper?

Highlander rear wiper switch is located on the right-hand stalk of the steering wheel. By rotating the rear wiper control knob to the corresponding position, the rear wiper can be activated; push the stalk towards the front of the vehicle to spray and wash the rear windshield. The middle position with a wiper icon is the intermittent mode, which wipes the windshield at a certain frequency. The further down the wiper switch is pressed, the faster the frequency.
8
0
Share

How to Match RPM and Gear?

Correct gear shifting should be performed after the car starts, with the engine RPM increasing, matching different speeds, and shifting into the corresponding gear. The optimal time to shift gears is generally when the engine RPM is between 2500 and 3000r/min.
2
5
Share

How to properly park and shift gears?

After the car comes to a complete stop, shift the gear to P, then engage the handbrake and turn off the engine. After the car comes to a complete stop, shift the gear to N, engage the handbrake and turn off the engine, then press the clutch and shift the gear to P.
11
0
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.